Summary of the content on the page No. 1
Vacuum
Cleaner
SU-2950 Series
FOR HOUSEHOLD USE ONLY
Operating
Instructions
IMPORTANT SAFETY INSTRUCTIONS ......................... 1
ASSEMBLING PARTS ..................................................... 2
OPERATION .................................................................... 3
MAINTENANCE ............................................................... 5
TROUBLESHOOTING ..................................................... 8
Read these instructions before operating the vacuum cleaner
•T
Summary of the content on the page No. 2
IMPORTANT SAFETY INSTRUCTIONS Thank you for purchasing a Samsung vacuum cleaner. When using an electrical appliance, basic precautions should always be followed, including the following: PLEASE READ ALL INSTRUCTIONS BEFORE USING THIS VACUUM CLEANER. WARNING: To reduce the risk of fire, electric shock, or injury: • Do not leave vacuum cleaner unattended when it is plugged in. • Unplug from outlet when not in use and before servicing. • Do not use outdoors or on wet surfaces. • The appliance is no
Summary of the content on the page No. 3
Assembling Parts Identifications of parts The assembled cleaner will look like the illustration to the left. 1-1 1. Handle 2. Power switch 3. Quick release cord hook 4. Post-Motor Filter 5. Crevice tool 6. Handle release 7. Carrying handle 8. Hose 9. Extension wand 10. Combination tool 11. Cyclone-Lever 12. Dirt Cup 13. Filter Cup 14. Upper Tank 15. Cap Cyclone 16. Hose Wand Base 17. Height Adjustment Dial 18. Hose Clip Front Back 19. Mini Turbo Brush WARNING! OPERATE THE VACUUM CLEANER ONLY AT
Summary of the content on the page No. 4
Operation 2-2 2-3 2-1 Handle positions Transporting cleaner ON-OFF Switch The handle of your cleaner has To move your cleaner from room to 1.To turn cleaner on, press the three positions; upright for storage room, put the handle in upright Power switch. and when using cleaning tools; position, tilt the cleaner back on its operating for general operation on rear wheels and push forward. 2.To the cleaner off, press the carpet and floors; low for reaching Power switch again. under low furniture. S
Summary of the content on the page No. 5
Operation 2-7 2-8 2-6 For maximum cleaning Cleaning lightweight Carpet height performance, The following flexible rugs adjustment carpet height settings are Stand on one end of rug and move Carpet and rug cleaning takes recommended: cleaner toward other end or edge. place at the nozzle (A). Lowest setting: for bare Before reaching edge, push down on When it is necessary to raise floors handle. This will lift up the nozzle(front of and lower the nozzle for Medium setting : for short cleaner)and
Summary of the content on the page No. 6
Maintenance Familiarize yourself with these home maintenance tasks as proper use and care of your cleaner will ensure continued cleaning effectiveness. When to empty the Dirt Cup The dirt cup needs to be emptied when the dirt reaches the "Full" line on the side of the Cup. If more dirt than this accumulates, your cleaner will not operate effectively. Note: All new carpet has loose fibers which can fill the Dirt Cup quickly while vacuuming. Emptying the Dirt Cup Disconnect cleaner from electrical
Summary of the content on the page No. 7
Maintenance The belt 3-7 3-8 The belt on your cleaner causes the agitator to rotate and is important for the effective operation of the cleaner. The belt is located under the bottom plate of the cleaner and should be checked from time to time to be sure it is in good condition. When to replace Disconnect cleaner from Remove agitator and used belt. How to replace electrical outlet. Discard used belt. Disconnect cleaner from electrical outlet. To check belt, remove bottom plate Place handle in low
Summary of the content on the page No. 8
Maintenance Clearing Blockages Disconnect cleaner from electrical outlet. The hose on the back of the vacuum cleaner that carries the dirt from the nozzle to the Dirt Cup can sometimes become clogged. If you notice a change in the sound of the vacuum motor, check for blockages. 3-14 3-16 3-15 Check Upper Tank and Grille Remove the Hose and If the blockage persists, turn Cyclone. To open the Cap, disconnect the Wand. the vacuum cleaner off and grasp the holder and turn Check for clogs in the vac
Summary of the content on the page No. 9
Troubleshooting Check this list of possible problems and solutions before bringing your vacuum to a service center. Problem : Poor job of dirt pickup Problem: Cleaner won’t run Possible Cause Possible Cause Possible Solution Possible Solution ·· Full or clogged Dirt Cup ·· Not firmly plugged in ·· Empty the Dirt Cup and check for blockages. ·· Plug unit in firmly ·· Broken or worn belt ·· No voltage in wall plug ·· Replace belt. ·· Check fuse or breaker ·· Clogged hose or nozzle ·· Blown fuse or
Summary of the content on the page No. 10
M M E E M M O O
Summary of the content on the page No. 11
M M E E M M O O
Summary of the content on the page No. 12
DJ68-00294M REV(0.0) * *
