Oreck UPRO14T user manual

Summary of the content on the page No. 1

40337-02 REV A

®
SIMPL Y AMAZING
USER’S GUIDE
PROFESSIONAL
GRADE
COMMERCIAL
UPRO14T
•IMPORTANT•
SAVE THIS BOOKLET!
Includes:
• Safety Warnings
• Warranty
• Operating Instructions
• Trouble Diagnosis
USA & Canada: 1-800-989-4244
www.oreck.com

Summary of the content on the page No. 2

Table of Contents IMPORTANT SAFETY Maintenance and Customer Service, Grounding Instructions, Important Safety Instructions . page 2 INSTRUCTIONS Warranty, Troubleshooting Guide . . . . . . . . . . . . . . . . . page 3 Parts List, Assembly . . . . . . . . . . . . . . . . . . . . . . . . . . . page 4 When using an electrical appliance, basic Installing Power Cord, Operating Instructions . . . . . . . page 5 precautions should always be followed, including the following: Gene

Summary of the content on the page No. 3

Warranty Troubleshooting Guide ORECK MANUFACTURING COMPANY: (Oreck Manufacturing WARNING: Unplug cord from electrical outlet Company gives you the following limited warranty for this product before servicing. only if it was originally purchased for commercial use, not resale from Oreck or an Oreck Authorized Retail Dealer.) Oreck will repair or replace, free of charge, to the original purchaser, PROBLEM POSSIBLE SOURCE AREAS TO CHECK any part that is found to be defective in material o

Summary of the content on the page No. 4

Parts List 3 To assist you in identifying components of your 1 vacuum, the parts have been numbered as follows: 1. Handle 14. Power Cord 2. Option Mount 15. Wand 12 3. Full Bag Light 16. Transport Handle 4. Main Power Switch 17. Thumb Nut 4 5. Door Latch 18. Base Inlet 13 Connector 6. Bag Housing 2 19. Cord Pigtail 7. Release Handle 20. Rear Wheel 8. Electronic Display 21. M5 Thumbscrew 9. Handle Pivot 22. Cord Strain Relief 14 10. Brush Housing 23. Cord Restraint 11. Power Brush

Summary of the content on the page No. 5

4. Attach desired cleaning tool 2 3 7 (dusting brush, upholstery brush or crevice tool). 5. When finished cleaning, replace the tool and wand to Cord Strain Relief their storage positions. Make sure the wand fits tightly Clamp into the base inlet so it will not leak. Dust Bag Full Indicator 1. Your machine has a red bag Cord Strain full indicator light located on M5 Thumbscrew Relief top of the unit next to the power switch which will Installing Power Cord come

Summary of the content on the page No. 6

General Information To Clean or Replace Inlet Filter WARNING: Unplug cord from electrical outlet The performance of your new vacuum cleaner greatly depends upon before servicing. care and maintenance. The instructions in this manual will guide you in performing basic care and maintenance. To obtain the most satisfying 1. Remove the dust bag. years of service read the instructions and keep them handy for future 10 reference. 2. Snap the filter retainer

Summary of the content on the page No. 7

7

Summary of the content on the page No. 8

©2006 Oreck Holdings, LLC. All rights reserved. All word marks, logos, product configurations, and registered trademarks are owned and used under the authority of Oreck Holdings, LLC. 40337-02 REV A 05/06 ECN# R-8370