Summary of the content on the page No. 1
75319-10 REV A
®
S I M P L Y AMAZING
USER’S GUIDE
2005HH
2005RH
COMMERCIAL
HIGH SPEED UPRIGHT VACUUM
CLEANER WITH
®
CLEANING SYSTEM
¥ T N A T
SAVE THIS BOOKLET!
Includes:
• Safety Warnings
• Warranty
• Operating Instructions
• Trouble Diagnosis
• Accessories
¥IMPOR
Summary of the content on the page No. 2
T N A T BEFORE OPERATING CLEANER, READ ALL When using an electrical appliance, basic INSTRUCTIONS IN THIS precautions should always be followed, including the following: MANUAL CAREFULLY. READ ALL INSTRUCTIONS BEFORE USING THIS VACUUM CLEANER WARNING Table of Contents To reduce the risk of fire, electric shock, or injury: • Do not leave appliance unattended when plugged in. Unplug Plug Fitting Instructions, from outlet when not in use and before servicing. Important Sa
Summary of the content on the page No. 3
Accessories Maintenance and (Sold Separately) Customer Service ITEM PART NUMBER Your ORECK vacuum cleaner is a product of precise engineering. The motor bearings are 1. Dust Bag, 9 Pack permanently lubricated and should not be oiled. Hypo-Allergenic PK80009DW If you require additional information or have problems with your ORECK appliance, or to order Regular PK80009 new bags or spare parts, you may call ORECK 2. Belts, 3 Pack 0300604 customer service at: (0) 01279 406995. ® 3. Oreck F
Summary of the content on the page No. 4
To Replace Filter Assembly Dust Bag To assist you in assembling your 10 WARNING: Unplug cord from cleaner, the parts have been 11 electrical outlet before servicing. numbered as follows: 9 1 Handle section, upper 1 12 BAG INSTALLATION: 2 Tube, lower 17 1. Hook bottom of bag collar 3 Power head opening under lip “B” of 4 Outer bag 16 A connector assembly. Pull up 5 Paper filter dust bag 5 13 4 on bag collar and snap over 6 Power cord lip “A” of connector. 7 Retaining spring
Summary of the content on the page No. 5
Operating Instructions To Operate All paper dust bags are not the same. Your ORECK Make sure the disposable paper filter dust bag is in place. disposable dust bags have been designed to be DO NOT operate the cleaner without a paper filter dust bag. used with the ORECK cleaner. Using bags other Plug the power cord into an electrical outlet. than genuine ORECK disposable bags will affect Press the ON(l) - OFF(O) switch on handle assembly when the cleaning ability of your
Summary of the content on the page No. 6
How to Replace a Worn Belt Operating Instructions WARNING: Unplug cord from CAUTION—WOOD FLOORS, SOFT (VINYL, ASPHALT TILE, electrical outlet before servicing. ETC.) FLOOR SURFACES AND POLISHED FLOOR FINISHES Use floor and floor finish manufacturer’s recommended Remove the replacement methods of cleaning. The metal strip on the base of the belt from the storage cleaner could be damaged if used on concrete or abrasive channel. surfaces, and, therefore, cause damage to wood floors, s
Summary of the content on the page No. 7
To Adjust or Replace Brush Stuffing or Blockage Under certain conditions it is possible to stuff or block the intake WARNING: Unplug cord from tube and the lower tube assembly. If your vacuum cleaner does electrical outlet before servicing. not pick up properly, or makes unusual noise and the outer bag does not fluff up or balloon open, follow the following steps: To determine if the brush is worn, place a firm straight WARNING: Unplug cord from electrical edge across the nozzle
Summary of the content on the page No. 8
Stuffing or Blockage Troubleshooting Guide 5. Many times blockage occurs WARNING: Unplug cord from F due to a full dust bag electrical outlet before servicing. causing dirt to back down Connector SAVE SERVICE CALLS...CHECK THESE FIRST: the air flow system. When Deflector that happens, the blockage • Is the disposable filter dust bag full? Opening • Are pores of filter dust bag clogged with powder or fine dust? will be at the top of the system, starting in the area • Is anythin
