Summary of the content on the page No. 1
The Easy to Use
I’
Deep Cleaner
i
I
with automatic tool conversion
i
i
! Congratulations on your purchase!
SteamVac” LS cleaners have 5 brushes that deep
clean carpets and scrub bare floors!
SteamVacTM Deep Cleaner cleans carpet fibers by applying hot
tap water and cleaning solution.
,
fl)
1 ’
aii@
0 Go
www. hooverxom
Summary of the content on the page No. 2
Fill in and Retain Owner’s _ Manual Review this manual before operat- ing deep cleaner Important Safeguards! s WARNING: l may l l a l l l Index l 2 ....... l by may ..... .4-6 l is ....... a a .6-9 a tank. . . l all ....... 7 l l electrical to
Summary of the content on the page No. 3
/ Grounding Instructihs (x 1 D * F G ’ A temporary adapter (D) may be used to connect this plug to a 2-pole receptacle DANGER- (E) if a properly grounded outlet is not improper connection of the available. The temporary adapter grounding conductor can result in the be used only until a properly grounded This appliance must be grounded. If it risk of electric shock. Check with a qual- should malfunction or breakdown, outlet (B) can be installed by a qualified ified electrician or service person
Summary of the content on the page No. 4
Assemble handle Attach upper handle Remove clean solution tank (upper tank) from deep cleaner. With cord hook (A) to back of deep cleaner, push upper handle down onto lower han- of dle. bolts will easi- - x Place nuts in recessed areas on When handle sections are completely Replace clean solution tank (upper Hold each nut in place while together, squeeze trigger (B) on upper tank) by positioning bottom first. Press tightening each bolt securely with a handle to snap tripqer
Summary of the content on the page No. 5
Slide rack down into place. Insert screw Attach hose rack Storing hose & tools at (D) and tighten with a Phillips screw- Remove tool and taped screw from rack. Store hose on rack by first positioning driver hose in front section of clip. Insert projections on rack into slots on Slide bare floor attachment into holder Position tool in holder at base of cleaner Then continue wrapping hose as shown as shown. and snap it into place as shown at snapping end of hose connector into arrow. To remove pow
Summary of the content on the page No. 6
The assembled deep cleaner will look like the drawing. Deep cleaner description holds dirty press to solution. release clean solution. place cord in clip to keep it out of the way slide selector to set brush when using cleaner wrap hose when brushes are rotating. around holders for storage. 6. wrap cord around hooks for storage. choose either floor or tools The top hook can be rotated right or left for quick and easy cord release. on pedal to lower handle to o
Summary of the content on the page No. 7
The deep cleaner may also be lifted by Automatic “shut OW Brush speed selector placing a hand under the upper clean Your deep cleaner has three solution tank handle as shown. the automatic shutoff mechanism will shut agitator brush settings. off the deep cleaner suction - for normal cleaning of carpet and At that time the red float disk will rise to LO - for gentle cleaning of carpets and the top of the recovery tank lid (E). The bare floors deep cleaner will no longer pick up dirty - for
Summary of the content on the page No. 8
Using cap, measure detergent the chart below. line (5 ounces) line Floor Do not use Bare Floor Cleaner on carpet or of Rotate tank cap counterclockwise and lift Turn cap (A) upside down to serve as a They are specially formulated for use measuring cup. with your deep cleaner *Available at additional cost if not Included with your model. 2 1 of a C D If rubber ring (C) on cap has become di
Summary of the content on the page No. 9
it is Raise tank handle to carrying position to place it into base of cleaner Move han- dle completely forward to place (see Fig. 35). Raise handle of deep cleaner to upright position and reposition upper clean To remove tank lid, lower handle Raise handle to carrying position pletely toward back of tank and lift off (straight up) to from base of deep cleaner. Lift tank from deep er and carry it to a sink or drain. Empty the tank and reposition the lid. Wet a white absor
Summary of the content on the page No. 10
To clean the outside of the machine, 8. For heavily soiled areas, repeat, To wipe off dirt with a cloth dampened in 4 warm water and mild detergent. to It is best to alternate wet and dry strokes as described above. For best cleaning results and to aid in faster drying of carpet, end with more dry strokes. (Continue using dry strokes until little water is visible passing through the recovery tank lid.) Fill clean solution tank (upper tank) Empty recovery t
Summary of the content on the page No. 11
4. Return deep cleaner to upright posi- persed. Use both forward and reverse has rotating strokes. brushes for extra scrubbing action on tion Lower handle and replace recovery tank. small carpet areas, carpeted stairs and 7. Empty recovery tank when the motor upholstery. Brushes can be removed for sound becomes higher pitched and 5. Raise handle to upright position and converting to the scrub module. reposition clean solution tank. there is a loss in suction (see “Automatic has a shut-off
Summary of the content on the page No. 12
I After using scrub tool 3. Drain hose by turning deep cleaner After using tool ON and holding end of hose up for sev- pull it off module. Follow steps a and b for “After clean- eral seconds. Do not press trigger, Wash it in water with mild detergent. ing” on page 9. 4. Disconnect deep cleaner from elec- 2. Rinse tool and hose by filling sink with trical outlet. Pad must be completely dry before reat- taching to module and storing on deep 5. Drain solution tube (located inside deep cleaner
Summary of the content on the page No. 13
Be sure to check the cleaning code on your upholstery. Place handle in upright position. 2. Fill clean solution tank with HOOVER 6. Gently press the tool (A) or (B) onto 10. For heavily soiled areas, it may be Carpet/Upholstery Detergent according the fabric. Press the trigger and slowly necessary to repeat the cleaning to instructions for Figs. 2-10 to 2-16. pull the nozzle over the fabric. process. Make crisscrossing strokes to 3. Attach tool to end of hose. t
Summary of the content on the page No. 14
Full Two Year Warranty If a minor problem occurs, it usually can be solved quite easily when the cause is Your HOOVER@ appliance is warranted found by using the check list below. in normal household use, in accordance with the Owner’s Manual against original defects in material and workmanship for a period of two full years from date of purchase. This warranty provides, at no Possible solution cost to you, all labor and parts to place this appliance in correct operating con- Plug unit in
Summary of the content on the page No. 15
