Summary of the content on the page No. 1
OWNER'S MANUAL
DLP™ Projection Television
62CM9UA
Owner's Record
You will find the model number and serial number on
62CM9UE
the back of the TV. Record these numbers in the spaces
provided below. Refer to them whenever you call upon
your TOSHIBA dealer regarding this product.
72CM9UA
Model number:
Serial number:
72CM9UE
23566843
#01E01_6272CM9UAE 1 05.10.18, 3:23 PM
http://www.pureglare.com.au
Toshiba 62/72CM9UA/E (E)
Black
Equipment Using the
Reference section Viewing teletext Getting star
Summary of the content on the page No. 2
Welcome to Toshiba • Thank you for purchasing this Toshiba DLP™ Projection Television. This manual will help you use the exciting features of your new TV. • Instructions in this manual are based on using the remote control. •You can also use the controls on the TV if they have the same name as those on the remote control. • Please read all the safety and operating instructions carefully, and keep the manual for future reference. Contents Introduction Sound adjustment ............................
Summary of the content on the page No. 3
Introduction Important Safety Instructions • See “Important notes about your DLP™ projection TV” on page 8. • Be sure to observe the following instructions and precautions to ensure safe use of this TV. Installation Check! Always connect the power plug to an electrical outlet equipped with 220 – 240V AC 50 Hz. 220-240V AC Never use the TV outside the specified voltage range. It may cause a fire or an electric shock. WARNING ABOUT THREE-WIRE GROUNDING-TYPE PLUG: Never remove the earthing pin on t
Summary of the content on the page No. 4
Introduction Important Safety Instructions (continued) Installation (continued) Never place the TV in an area exposed to high humidity levels, such as in a bathroom or close to a humidifier. This may cause a fire or an electric shock. Never place the TV next to a stove where it will be exposed to oil, smoke, or steam, or in a location where there is a large quantity of dust. This may cause a fire or electric shock. Install the TV in a horizontal, stable location. Install a steady tie to ensure t
Summary of the content on the page No. 5
Use Never place hot objects or open flame sources, such as lighted candles or nightlights on, or close to the TV. High temperatures can melt plastic and lead to fires. Never place anything heavy on top of the TV. This may cause the balance to become uneven, resulting in the TV falling over, dropping or causing an injury. The apparatus shall not be exposed to dripping or splashing and that no objects filled with liquids, such as vases, shall be placed on the apparatus. When liquids are spilled or
Summary of the content on the page No. 6
Introduction Important Safety Instructions (continued) Use (continued) Never pull on the power cord when removing the plug from the wall outlet. Always hold the plug firmly when removing it. If the power cord is yanked, the cord may become damaged and fire or electric shock may occur. Never cut, break, modify, twist, bunch up or bent the cord or apply excessive force or tension to it. Never place heavy objects on the cord or allow it to overheat as this may cause damage, fire or electric shock.
Summary of the content on the page No. 7
Service (continued) If the TV is dropped or the cabinet is broken, turn off the TV and remove the power plug from the outlet immediately. If the TV is still power used in this condition, it may cause a fire or an electric shock or an injury. Contact a service technician for inspection. When the TV reaches the end of its useful life, ask a qualified service technician to properly dispose of the TV. Note: The lamp unit contains a small amount of mercury. Disposal of mercury may be regulated due to
Summary of the content on the page No. 8
Introduction Important information Important information Important notes about your DLP™ projection TV WARNING: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE TV COVERS. NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. 1)The light source for this TV is a projection lamp unit with a limited service life. When the lamp wears out, the picture may become dark or black, or the lamp may fail, at which time you must replace the lamp unit. The length of service life
Summary of the content on the page No. 9
Getting started Installation Connecting an antenna Optimum reception of color requires a good signal and will generally mean that an outdoor antenna must be used. The exact type and positioning of the antenna will depend upon your particular area. Your Toshiba dealer or service personnel can best advise you on which antenna to use in your area. Do not plug the power cord until you have finished connecting the antenna. VHF and/or UHF antenna 300 Ω twin-lead feeder 75 Ω antenna Antenna adaptor ter
Summary of the content on the page No. 10
Getting started Exploring your new TV •You can operate your TV using the buttons on the right side panel or the remote control. The back and side of the panel provide the terminal connections to connect other equipment to your TV. See “Equipment connections” on pages 38-40. • Model 62CM9UE is used in this manual for illustration purpose. TV right side For the use of each control, see the pages in brackets. TV right side view TV control panel Headphones (Not supplied) Power [13] Headphone jack (
Summary of the content on the page No. 11
TV back TV back view WOOFER output terminal [30, 39] Antenna input [9] HDMI 1 terminal [43] HDMI 2 terminal [43] (C2) COMPONENT VIDEO INPUT terminals [39] RGB/PC input [40] (C1) COMPONENT HDMI (AUDIO) 1 terminals [43] VIDEO INPUT terminals [39] HDMI (AUDIO) 2 terminals [43] (1) Video 1 input terminals [39] AUDIO OUT terminals [28, 39] MONITOR output terminals [39] 11 #01E09-13_6272CM9UAE 11 05.10.18, 3:23 PM http://www.pureglare.com.au Toshiba 62/72CM9UA/E (E) Black Equipment Using th
Summary of the content on the page No. 12
Getting started Learning about the remote control Location of controls For the use of each control, see the pages in brackets. Teletext on/off [35 – 37] CALL [17, 19] CALL Power on/Standby [13] Initial/index function for Teletext [37] (For Toshiba TV/VCR/DVD) 1 2 3 Number buttons (0-9) [19, 32] 4 5 6 • Input source selection [31] ( 1, 2, C1, C2, 7 8 9 HDMI 1, HDMI 2, PC) • To access sub-pages when in teletext [35] To return to the previous program [19] 0 Picture mode selection [22] Picture s
Summary of the content on the page No. 13
Getting started Turning the TV on • Plug the power cord into a wall outlet. Switching on the TV After you plug in the TV power cord, make sure the blue LED on Side panel the TV front is lit. Press the Power button on 1 Mono the TV control panel or press the button on the remote control. The orange LED will blink for several seconds until the picture appears. Blue LED Note: Orange LED The Quick restart setting will affect the amount of time it takes for the picture to appear when you turn on th
Summary of the content on the page No. 14
Getting started Learning about the menu system •We suggest you familiarize yourself with the display chart before using the menu system: •Press the MENU button to display menu, then press the or button to select main menu headings. •Press the or button to select an item. •Press the or button to select or adjust setting. •Press the OK button to display the next menu. Menu display chart PICTURE menu Picture settings 2/2 MPEG NR Low DNR Auto PICTURE PICTURE Color Temperature Cool Picture sett
Summary of the content on the page No. 15
Selecting a language Choose from seven different languages (English, Chinese (CS), Malay, Thai, Vietnamese, Russian, Arabic, Persian and French) for the on-screen display. Press the MENU button, then press the or button to SET UP Language English display the SET UP menu. CALL Auto tuning OK Manual tuning OK Program sorting OK OK AV connection OK OK 1 2 3 Picture position OK MENU EXIT Back Watch TV 4 5 6 Press the or button to 7 8 9 select Language. SET UP Language English Auto tuning OK Pres
Summary of the content on the page No. 16
Getting started Programming channel memory • First, use the Auto tuning function to preset all the active channels in your area automatically. Then, arrange the preset channels with the Manual tuning function so that you can tune into only desired channels. • Use the Channel search operation if desired channels cannot be preset with the Auto tuning or if you would like to preset channels to specific position numbers one by one. System selection, Auto tuning Press the MENU button, then press the
Summary of the content on the page No. 17
Manual tuning (continued) A. Program position selection B. Sound system (see page 48) C. Color system (see page 48) A : Automatic (factory set), P : PAL, S : SECAM N4 : NTSC 4.43 (MHz), N3 : NTSC 3.58 (MHz) CALL If the color of a certain channel is abnormal, the automatic color system selection (A) may have malfunctioned, or 1 2 3 sound system selection is wrong. In such a case, select another color and/or sound system (see page 48). D. Program position skip selection 4 5 6 Press the or
Summary of the content on the page No. 18
Getting started Programming channel memory (continued) • This TV is capable of receiving a number of different channels depending upon where you live. •Program sorting is an easy way of storing each channel on the program position of your choice. Program sorting Ex.: To swap channel ABCD (Prog.1) for channel MNOP (Prog.4): Press the MENU button, then press the or button to SET UP English display the SET UP menu. Language Auto tuning OK CALL Press the or button to Manual tuning OK Program sor
Summary of the content on the page No. 19
Getting started Watching TV programs Volume, Sound mute, Changing program positions, Program return, On-screen information To alter the volume: TV control panel Press the + or – button to raise or lower the volume. Volume 30 To mute the sound: Press the button. The word Sound mute appears on the Sound mute screen. Press the button again to restore the sound. To change program position: Enter the desired program 1 Mono MNOP position number using the Number buttons on the remote CALL control. Fo
Summary of the content on the page No. 20
Using the TV’s features Viewing the wide-screen picture format • This TV is capable of showing broadcasts in a number of formats. Depending on the type of broadcast being transmitted, you may select between Super live, Cinema, Subtitle, 14:9, Wide and 4:3. Picture size selection Press the button repeatedly to view the options available. Super live This setting will enlarge the 4:3 image to fit the screen by stretching the image vertically and CALL horizontally, holding the correct proportions a
