MTX Audio F-150 SUPERCREW user manual

Summary of the content on the page No. 1

Warranty Statement
ThunderForm Loaded Enclosures purchased in the United States from an authorized MTX dealer
are guaranteed against defects in material and workmanship for a period of two years from the date
purchased by the end user, and limited to the original retail purchaser of the product.
Amplified ThunderForm Enclosures purchased in the United States from an authorized MTX dealer
are guaranteed against defects in material and workmanship for a period of one year from the date
purchas

Summary of the content on the page No. 2

READ ALL DIRECTIONS CAREFULLY BEFORE BEGINNING Conventional Wiring of Aftermarket Radio MOUNTING LOCATION: The enclosure mounts on the driver’s side under rear seat on Ford F-150 SuperCrew. 20 Amp Fuse TOOLS REQUIRED FOR INSTALLATION: Wire Cutters 5/16” Wrench Terminal Crimpers 1/2" Socket INSTALLATION: Follow the steps below 1. Remove the 2 plastic bolt covers. Press down and slide forward. Remove the 3 seat bracket bolts, flip bottom of seat up and place enclo- Low Level Signal sure under

Summary of the content on the page No. 3

18. Reinstall threshold trim. Locate and align holes in vehicle with pins 4. Route 10ga red power wire from furnished wiring harness starting at on trim. pre-amp location. Route wire under carpet on passenger's side, over to threshold along with factory wiring to the front of vehicle. 5. Open hood. 6. Drill a hole through the firewall. Locate a spot low on the firewall on the passenger's side. You should always look to find a clear path. Drill a hole from inside of the vehicle into engine c

Summary of the content on the page No. 4

11. Ground amplifier to chassis of vehicle; connect the terminal provided 14. Plug power harness into amplifier pre-amp. to the 10ga black wire from furnished wiring harness. A good ground is as important as the power connection. The ground should be as short as possible and the contact point should be free of paint and debris. I N P U T SPEAKER WIRES 12. In the channel on driver's and passenger's side threshold locate the rear speaker wires. Colors are driver's side, yellow/blue (positive)