Orion Car Audio RGC-1 user manual

Summary of the content on the page No. 1

Summary of the content on the page No. 2

INTRODUCTION The RGC-1 remote gain control is specifically designed for use with ORION amplifiers. The RGC-1 allows dashboard control to your current Orion amplifier or earlier XTR, XTR Pro or HCCA amplifier. Used on subwoofer amplifiers, it provides subwoofer level control. Used on the first amplifier in a daisy-chain, it works as a remote pre-amp volume control. Warning: The RGC-1 can be used only on ORION amplifiers that have a 1/8-inch mini-jack remote gain port on the connection panel. Usin

Summary of the content on the page No. 3

AC502 Nut Bracket Under Dash Mounting Label Nut Knob Screws In-Dash Mounting Note: There must be enough clearance behind the dash-panel before selecting the location to mount the RGC-1. A 1/2-inch hole must be drilled to mount the RGC-1 in the dash panel. Side in the control from the rear of the dash panel and place the trim label on the threaded shaft. Secure the control with the nut and mount the knob If there is no access to the back of the dash panel, drill a 3/4-inch hole in order to pass t

Summary of the content on the page No. 4

ADJUSTMENT PROCEDURE 1. Set the gain controls of the amplifier according to the “Adjusting the Sound of Your System” in your owner’s manual. The amplifier primary gain controls determine the maximum allowed output level that the amplifier. 2. Set the control knob of the RGC-1 to its mid-rotation position. 3. Check the output level of the subwoofer. The amount of bass can be adjusted for the type of music and individual preference. Warning: DO NOT increase the amplifier gain without repeating St

Summary of the content on the page No. 5

Warranty LIMITED TWO YEAR CONSUMER WARRANTY: Directed Electronics, Inc. promises to the original purchaser, to replace this product should it prove to be defective in workmanship or material under normal use, for a period of two years from the date of purchase by the dealer as indicated by the date code marking of the product PROVIDED the product was installed by an authorized Directed dealer. During this two year period, there will be no charge for this replacement PROVIDED the unit is returned