JL Audio Stealthbox SB-SC-XB/10W3v3-4 user manual

Summary of the content on the page No. 1

SB-SC-XB/10W3v3-4 INSTR_SKU# 011277
Installat Ion

d I F F I C u l t Y :

If you choose to perform the installation yourself, it is absolutely vital that
®
out
the Stealthbox be properly mounted to the vehicle according to these
o F
instructions. Failure to mount the enclosure properly presents two problems:
I n s t a l l a t I o n G u I d e
for the 1) The sub-bass performance will suffer due to the movement of the enclosure
15
caused by the force exerted by the woofer(s).
SB-SC-XB/

Summary of the content on the page No. 2

SB-SC-XB/10W3v3-4 INSTR_SKU# 011277 s t e P 3 ( d e t a I l ) S T E P 7 Close-up of bolt protruding from enclosure. If bolt does not Connect the wires going to the amplifier, the red terminal is leave an impression in the wax square in ste P 4, back it out positve. Test the enclosure.....Ok! long enough! you’ll get to so that more is sticking out of the Stealthbox® untill it leaves hear it alot more in just a little bit, you’re almost done! a deep enough impression to use as a guide. Put the

Summary of the content on the page No. 3

SB-SC-XB/10W3v3-4 INSTR_SKU# 011277 I n C l u d e d H a R d W a R e (2) 1/4-20 X 1" Chrome Hex Head Bolt (2) 6mm Flat Washer (1) 3/8”-16 X 1 1/4" Hex Head Bolt (1) 3/8” X 1 1/4" Flat Washer (1) 3/8" Split Lock Washer (1) 1" Aluminium Spacer (1) 3”x 3” Wax Square s P e C I F I C a t I o n s Enclosure Type: Acoustic Suspension (sealed) Driver Type: 10W3v3-4 Nominal Impedance: 4 ohms Continuous Power Handling: 500 watts RMS P o W e R R e C o m m e n d a t I o n JL Audio recommends using a high qu