JL Audio Stealthbox SB-GM-BURB/10W3v3/RD user manual

Summary of the content on the page No. 1

™
SB-GM-BURB/10W3 STEALTHBOX
Fits 92-97 GM Suburbans, 88-97 GM Full-
Size Trucks, 92-97 GMC Yukons and Chevy
Tahoes (2 and 4 Door Models)
Installation Guide:
This Stealthbox is designed to mount between the front bucket seats, replacing the center console.
It is not designed for installation in vehicles with bench seats.
Please read this installation guide thoroughly before beginning the project. It will guide you step by
step through the process. This product requires professional installatio

Summary of the content on the page No. 2

STEP 4: Slide the console forward to dislodge it from the rear support bracket. Remove the console. STEP 5: Using a 10mm socket, remove the two bolts that hold the rear bracket to the floor. Remove the bracket from the ve- hicle. STEP 6: Place the two supplied 4" X 4" wax squares, sticky side down, in the approximate locations of the Stealthbox mounting holes. STEP 7: Thread both of the supplied 3/8" X 1 1/2" bolts fully into the threaded inserts in the bottom of the Stealthbox. STEP 8: P

Summary of the content on the page No. 3

STEP 10: Remove the Stealthbox from the vehicle. There should be clear impressions in the wax squares. STEP 11: Remove the bolts from the Stealthbox. Before drilling check under the vehicle for any loose wires, fuel lines or other hazards in the areas where holes are to be drilled. STEP 12: Using the impressions in the wax squares as guides, drill a 1/2" diameter hole through the floor pan of the vehicle, using the impression in each wax square as a guide. Stop the drill immediately after pen

Summary of the content on the page No. 4

The top of the factory center console is used as the top of the Stealthbox. STEP 16: Remove the lid of the console by removing the 4 torx screws holding the lid to the console. The hinges should not be removed from the lid. STEP 17: Remove the 8 torx screws that hold the two sections of the console together. Separate the console. The lower section of the console will not be used. Save this piece in the event the original console is ever reinstalled. STEP 18: Using four of the supplied pan head

Summary of the content on the page No. 5

STEP 20: Place the assembled top section of the console onto the Stealthbox. Align it so that it is flush on all sides. STEP 21: While pressing down firmly and evenly on the top of the console, mark the location of the mounting holes for all four of the "L" brackets with a marker or felt tip pen. The lower hole in each bracket should be used for mounting. The upper hole in each bracket is unused. IT IS EXTREMELY IMPORTANT THAT YOU PRE-DRILL THESE HOLES! If the holes are not pre-drilled the fib

Summary of the content on the page No. 6

STEP 26: Using the supplied small screws, screw the front edge of the console to the Stealthbox. STEP 27: Place the supplied shallow storage tray insert into the main storage area of the finished Stealthbox. Use Velcro® (provided) to attach coin box to storage tray. STEP 28: Snap the factory storage bin previously removed in STEP 1 into the front portion of the Stealthbox. TECH TIP: We have found that stuffing polyfill under these bins before installation may reduce the chances of rattles at