Summary of the content on the page No. 1
Register your product and get support at
www.philips.com/welcome
SQM5822/27
EN Fixed wall mount
1
SQM5822-27_Manual.indb 1 2009-7-22 11:18:15
Summary of the content on the page No. 2
Table of contents 1 Important 3 2 Your fixed wall mount 3 2.1 What’s in the box 4 2.2 What you’ll also need 4 3 Installing your wall mount 5 3.1 Mounting the wall plate (drywall) 5 3.2 Mounting the wall plate (concrete) 5 3.3 Attaching the arms to the display 6 4 Mounting and adjusting 7 5 Guarantee and service 8 2 SQM5822-27_Manual.indb 2 2009-7-22 11:18:16
Summary of the content on the page No. 3
• Safety gear and proper tools must 1 Important be used. Failure to do so can result in property damage and/or serious injury. Take time to read this manual before you • A minimum of two people are required use your wall mount. It contains important for this installation. Do not attempt information and notes regarding operating your to install this mount alone under any wall mount. circumstance. • Follow all instructions and © 2009 Koninklijke Philips Electronics N.V. recommendations
Summary of the content on the page No. 4
2.1 What’s in the box. Wall mount Cotter pin Bag #1 (A) M4x12 Bolt (x4) (B) M4x30 Bolt (x4) (C) M4 Lock Washer (x4) Bag #2 (D) M5x12 Bolt (x4) (E) M5x30 Bolt (x4) (F) M5 Lock Washer (x4) Bag #3 (G) M6x12 Bolt (x4) (H) M6x35 Bolt (x4) (I) M6 Lock Washer (x4) Bag #4 (J) M8x16 Bolt (x4) (K) M8x40 Bolt (x4) (I) M8 Lock Washer (x4) Bag #5 (M) Small Spacer (x4) (N) Large Spacer (x4) (O) M6 Washer (x4) Bag #6 (P) Concrete Anchor (x6) (Q) M8x63 Lag Bolt (x6) (R) Lag Bolt Washer (x6) 2.2 What
Summary of the content on the page No. 5
4 With the help of another person, place the 3 Installing your wall mount mount against the wall and level it using the bubble guide. In this chapter, the basic steps to get you started 5 While another person holds the mount in are described. place, mark four locations (two per stud) on the wall where the mount is to be installed. Be sure to use the center of each B Warning stud. (these marks should line up with Carefully read the safety precautions the ones made in step 3 above usi
Summary of the content on the page No. 6
3 With the help of another person, place the 3.3 Attaching the arms to the display mount against the wall and level it using the bubble guide. 4 While another person holds the mount in B Warning place, mark six locations on the wall where Use extra care during this part of the the mount is to be installed. installation. Avoid laying your display 5 Set the mount aside and drill a 3/8” (10 face down if possible as it may damage mm) pilot hole at each marked location. the viewing surface. Re
Summary of the content on the page No. 7
3 Attach the arms to the back of your display using the bolts identified in Steps 1 and 4 Mounting and adjusting 2 and the corresponding lock washer (C, F, I, or L). You will need to use the M6 1 With the help of another person, carefully washers (O) if you are using the M4, M5, lift your display and place it on the wall or M6 bolts. If your display has a curved or plate. Do not release the display until the recessed back, you may also need to use a mounting arms have securely hooked ont
Summary of the content on the page No. 8
4 Once the tv is fitted properly on to the wall bracket, the security bar must be put into 5 Guarantee and service place. 8 Please contact Philips directly if you have any 8 questions in the installation process of the wall mount. Call 1-919-573-7854. Limited One-Year Warranty: Philips warrants that this product shall be free from defects in material, workmanship and assembly, under normal use, in accordance with the specifications and warnings, for one year from the date of your purc
Summary of the content on the page No. 9
SQM5822-27_Manual.indb 23 2009-7-22 11:18:27
Summary of the content on the page No. 10
© 2009 Koninklijke Philips Electronics All rights reserved. SQM5822_27_UM_V2.0 SQM5822-27_Manual.indb 24 2009-7-22 11:18:28
