JL Audio Stealthbox 011180 user manual

Summary of the content on the page No. 1

®
Stealthbox
INSTALLATION GUIDE START
HERE
for the
SB-T-TUNCNSL2/10W3v2
(‘03-Up Toyota Tundra Access & Double Cab
with front bucket seats and center console)
STEP 1: Using a 14mm socket, remove the STEP 2: Tilt the seat to the rear, unplug the STEP 3: Remove the front storage access
four bolts that secure the passenger side front exposed wire assembly, remove the seat from door. Using a 10mm socket, remove the
seat. the truck. exposed bolts.
This Stealthbox is a product which
requires professi

Summary of the content on the page No. 2

Cont. From 3/4” Previous Driver’s side Page ➔➔➔ middle Passenger’s side STEP 7: Slide the center console to the rear of STEP 8: *Tundra Access Cab Only* STEP 9: Remove the 8 screws that is securing STEP 10: *Tundra Access Cab Only* truck.This will allow exposer of the 12v plug wires. the black plastic support to the outer console. Not With the center console out of the truck, flip up Now it is time to remove those air ducts from Unplug and then remove the center console from all circles represen

Summary of the content on the page No. 3

Cont. From Previous Page ➔➔ STEP 15: Place the Stealthbox into position, Press STEP 14: Thread in the three supplied socket cup set screws into the Stealthbox. Make sure that the down firmly. socket ends are on the outside of the Stealthbox. The rear(left side of pic) threaded rods need to protrude about 1 1/4” out of the Stealthbox.The front socket cup set screw needs to protrude about 3/4”. Place the Stealthbox into location. Slide the rear socket cup set screw through the drilled out holes fr

Summary of the content on the page No. 4

Cont. From Previous Page ➔➔➔ STEP 17: Remove the wax square and run speak- STEP 18: *Access Cabs Only* STEP 19: With the Stealthbox and the modified STEP 20: Place the Stealthbox into the center er wire. A/C ducts in position. Place the front section of the console, outside of vehicle . Replace the modified A/C ducts from STEP 10, center console back into the proper location. Do back into the vehicle. *Double Cabs Only* not secure at this time. (Stealthbox is only shown in the picture for positi

Summary of the content on the page No. 5

Cont. From Previous Page CONGRATULATIONS! INSTALL COMPLETE. Included Hardware: STEP 24: With the Stealthbox securely mounted STEP 25: Secure the front section of console with 3) Wax Squares to the vehicle. Secure the plastic console to the the factory screws, from STEP 3. 3) 3/8”- 1-1/4” Fender Washer floor, using the factory screws from STEP 5. Once both portions of the center console have 3) 3/8” Flat Washer been secured. Snap in the cup holders from 3) 3/8” Split Lock Washer STEP 4, front con