Summary of the content on the page No. 1
TO RECEIVE DIGITAL SIGNAL
YOU MUST CONNECT ANTENNA
If you need additional operating assistance after reading this owner's manual or to order
replacement accessories, please call TOLL FREE : 1-800-605-8453 or visit our
WEB SITE at http://www.SylvaniaConsumerElectronics.com
Summary of the content on the page No. 2
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLI- ANCE TO RAIN OR MOISTURE. THIS SYMBOL INDICATES THAT DANGER- CAUTION OUS VOLTAGE CONSTITUTING A RISK OF RISK OF ELECTRIC SHOCK ELECTRIC SHOCK IS PRESENT WITHIN DO NOT OPEN THIS UNIT. CAUTION: TO REDUCE THE RISK OF ELEC- THIS SYMBOL INDICATES THAT THERE TRIC SHOCK, DO NOT REMOVE COVER (OR BACK). ARE IMPORTANT OPERATING AND MAIN- NO USER SERVICEABLE PARTS INSIDE. REFER TENANCE INSTRUCTIONS IN THE LITERA- SERVICING TO
Summary of the content on the page No. 3
FIGURE A EXAMPLE OF ANTENNA GROUNDING AS PER NATIONAL ELECTRICAL CODE ANTENNA LEAD IN WIRE GROUND CLAMP ANTENNA DISCHARGE UNIT (NEC SECTION 810-20) ELECTRIC SERVICE EQUIPMENT GROUNDING CONDUCTORS (NEC SECTION 810-21) GROUND CLAMPS NEC - NATIONAL ELECTRICAL CODE POWER SERVICE GROUNDING ELECTRODE SYSTEM (NEC ART 250, PART H) S2898A 13.OUTDOOR ANTENNA GROUNDING - If an outside 19.DAMAGE REQUIRING SERVICE - Unplug this TV from antenna or cable system is connected to the TV, be sure the wall outlet a
Summary of the content on the page No. 4
PRECAUTIONS • Place your TV in a room with adequate ventilation. • Keep your TV set away from sources of direct heat, such as heat registers or direct sunlight. • Do not place your TV on soft surfaces, such as rugs or blankets. • Leave enough room for air to circulate around the bottom, top and back of the set. FCC WARNING: This equipment may generate or use radio frequency energy. Changes or modifications to this equipment may cause harmful interference unless the modifications are expressly ap
Summary of the content on the page No. 5
SUPPLIED ACCESSORIES • Owner’s Manual • Remote control unit • Batteries (1EMN21905) (NF105UD) ("AA" x 2) • If you need to replace these accessories, please refer to the PART NO. above the illustrations and call our help line mentioned on the front page. • Depending on your antenna system, you may need different types of Combiners (Mixer) or Separator (Splitter). Contact your local electronics store for these items. FEATURES • DTV/TV/CATV • MTS/SAP Tuner This TV lets you easily switch TV(NTSC) an
Summary of the content on the page No. 6
ONTENTS C IMPORTANT SAFEGUARDS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 PRECAUTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 SUPPLIED ACCESSORIES . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 FEATURES . . . . . . . . . . . . . . . . . . . .
Summary of the content on the page No. 7
OTR (One Touch Recording) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 27 AUTOMATIC TIMER RECORDING . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 28 AUTO RETURN . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 30 AUTO REWIND-EJECT . . . . . . . . . . . . . . . . . . . . .
Summary of the content on the page No. 8
REPARATION FOR USE P CONNECTION This section describes how to connect this TV to reception and other sources. MAKE SURE YOU HAVE AN ANTENNA As DTV is only available over the air, you need an antenna to receive digital signal. [ANTENNA / BASIC CABLE CONNECTION] 1) When connecting TV to antenna Connect the RF cable or antenna cable on your home outlet to the ANT. jack of this TV. 2) When connecting TV to basic cable (without box) Connect the RF cable or incoming cable on your home outlet to the
Summary of the content on the page No. 9
[CONNECTION TO CABLE / SATELLITE BOX] 1) Connect the antenna cable on your home outlet to the input jack of the CABLE/SATELLITE box. 2) Use the corresponding cable to connect the ANT. jack of this TV and the output jack of the CABLE/SATEL- LITE box. *Required cables in 2) and connecting methods differ depending on the CABLE/SATELLITE box. For more information, please contact the store where you purchased the CABLE/SATELLITE box or nearby electric appliance stores. Satellite Cable TV antenna or s
Summary of the content on the page No. 10
PREPARATION FOR USE [USING FRONT A/V CONNECTION] 1) This is how to use the A/V jack in front of this TV and connect to external devices. This is useful when you use game playing devices etc. When the audio jack of external devices is monaural, connect this TV to the AUDIO L jack. To VIDEO OUTPUT Front of this TV jack HEADPHONE VIDEO AUDIO LR To VIDEO INPUT To AUDIO INPUT To AUDIO OUTPUT jack jacks jacks CABLES NOT INCLUDED [DIGITAL AUDIO CONNECTION] 1) If you connect this TV to an external audi
Summary of the content on the page No. 11
PERATING CONTROLS AND FUNCTIONS O - CONTROL PANEL - D DVD b VD buttons uttons TV/VCR b TV/VCR buttons uttons POWER SELECT REC/OTR REW PLAY F.FWD STOP/EJECT HEADPHONE VIDEO AUDIO VOLUME SKIP PLAY SKIP STOP OPEN/CLOSE CHANNEL LR DVD TV/VCR SEARCH 21 12 3 4 3 5 671 8 9 10 11 1213 14 45 16 17 1819 20 17 Remote sensor window - REMOTE CONTROL - 18 HEADPHONE Jack 19 VIDEO input Jack [P.9] POWER 20 AUDIO L/R input Jacks [P.9] PICTURE/ REC SLEEP SELECT 21 Cassette compartment 22 34 35 23 [REMOTE CONTROL]
Summary of the content on the page No. 12
TV/DTV SECTION V OPERATION AND SETTINGS T WATCHING TV DTV TV DTV • When selecting the channels with [CH. K K / L L], the major channel selection will be followed by the The unit selects available TV channels automatically minor channel selection. when you connect an Antenna or Cable TV signal to it. To reset TV channels, see page 21. • When selecting the channels with the Number buttons, enter the major channel number followed If you are using a Cable Box or Satellite Receiver, by the minor chan
Summary of the content on the page No. 13
N-SCREEN DISPLAY O WHEN THE CLOSED CAPTION IS ON STATUS DISPLAY The CLOCK/COUNTER display appears by pressing [DISPLAY]. TV VCR Display OFF CLOCK/COUNTER display On screen display examples are shown below. STOP 5:40PM CH2 14 PLAY B 12:00AM CH 123 *The display will HIFI 2 5 STEREO/SAP disappear 6 SP COUNT 0:12:34 after 5 seconds DTV SP COUNT 0:00:00 7 3 In the digital mode, the detailed information for the currently 1. VCR status selected channel such as the program guide is displayed. Disp
Summary of the content on the page No. 14
TV/DTV SECTION ON-SCREEN DISPLAY WHEN PLAYING CASSETTES MTS (Multi-channel Television Sound) VCR SYSTEM Press [TV/VCR Audio] repeatedly to select "HIFI" TV DTV VCR or "MONO". MTS allows for reception of sound other than the • This setting is saved until the cassette is ejected. main audio program. You can listen or record NOTE: monaural audio sound, stereo sound or Secondary • The initial setting is "HIFI". When you play non-HIFI tapes, Audio Program (SAP). the unit will play only in the monau
Summary of the content on the page No. 15
PTIONAL SETTINGS O SLEEP TIMER / PICTURE CONTROL MENU SCREEN TV DTV TV DTV You can set Sleep Timer and picture adjustment This section describes the overview of the menu with [PICTURE / SLEEP]. screen displayed when you press [SET-UP].For more details, see the reference page for each item. SLEEP TIMER SETTING The menu screen consists of the function setting The Sleep Timer function is used to turn off the items below. unit without pressing [POWER] after a desired In TV/DTV/AUX Mode In DVD Mode t
Summary of the content on the page No. 16
TV/DTV SECTION OPTIONAL SETTINGS AUTOMATIC CLOCK SETTING CLOCK SET UP TV DTV VCR NOTES: • If a cable converter box is being used, make sure it is turned on. Set the unit clock correctly for VCR timer recording. We suggest that • You must use the remote control for the clock setting. you should set the clock manually when you first set up the unit, then • If the unit is connected directly to a cable converter box or set the auto clock setting to "ON" to correct the time periodically. satellite bo
Summary of the content on the page No. 17
CLOSED CAPTION SYSTEM 4 Use [K / L] to select "CAPTION SERVICE". You can view specially labeled (cc) TV programs, Press [ENTER] repeatedly to select your movies, news and pre-recorded tapes with either a desired CAPTION SERVICE. dialogue caption or text display. • OFF: Select if you do not want DTV CC. This is the default. TV • Service 1 to Service 6: Select one of these before changing any other item in the Closed Caption 1 Select analog mode by pressing [SELECT]. menu. Choose Service 1 under
Summary of the content on the page No. 18
TV/DTV SECTION OPTIONAL SETTINGS V-CHIP SET UP A TV RATING SET UP TV DTV 5 Use [K K / L L] to select a rating B TV-Y [VIEW] that you wish to block. TV-Y7 ( ) [VIEW] This feature enables parents to prevent their chil- TV-G [VIEW] TV-PG ( ) [VIEW] dren from watching inappropriate material on TV. Press [ENTER] repeatedly to TV-14 ( ) [VIEW] TV-MA ( ) [VIEW] When you try to access a blocked program, set it to "BLOCK" or "VIEW". "PROTECTED PROGRAM by ..." message appears o
Summary of the content on the page No. 19
B MPAA RATING SET UP 1 Select digital mode by pressing [SELECT]. 5 Use [K K / L L] to point to your G [VIEW] desired item, then press 2 Press [SET-UP]. PG [VIEW] PG-13 [VIEW] [ENTER] to select "BLOCK" B R [BLOCK] K L Use [ / ] to select "DTV SET UP", then press NC-17 [BLOCK] X [BLOCK] or "VIEW". [ENTER]. – MAIN MENU – TIMER PROGRAMMING SETTING CLOCK Selection Rating Category Explanations CHANNEL SET UP USER'S SET UP G General Audience V-CHIP SET UP LANGUAGE [ENGLISH] CAPTION [OFF] PG Paren
Summary of the content on the page No. 20
TV/DTV SECTION THER SETTINGS O AUTO PRESET CH 3 For CATV channels – CHANNEL SET UP – If you switch wires (e.g. between antenna and ADD / DELETE CH K L • Use [ / ] to select "AUTO CATV) or if you move the TV to a different area after AUTO PRESET CH ( TV ) B AUTO PRESET CH (CATV) PRESET CH(CATV)", then AUTO PRESET CH (TV/DTV) the initial setting, or if you need to add the DTV AUTO PRESET CH (CATV) ! CATV takes approx. 50min. press [ENTER]. channel you deleted, you will need to perform AUTO PRESE
