Summary of the content on the page No. 1
HDMI Extender over Fiber Optic Cable
Model #: FO-HDM-XX-MM
© 2010 Avenview Inc. All rights reserved.
The contents of this document are provided in connection with Avenview Inc. (“Avenview”) products. Avenview makes no representations or warranties with
respect to the accuracy or completeness of the contents of this publication and reserves the right to make changes to specifications and product descriptions at any
time without notice. No licens
Summary of the content on the page No. 2
Table of Contents Section 1: Getting Started ...................................................................................................................... 3 1.1 Important Safeguards ............................................................................................................ 3 1.2 Safety Instructions ................................................................................................................. 3 1.3 Regulatory Notices Federal Communications Commi
Summary of the content on the page No. 3
Section 1: Getting Started 1.1 Important Safeguards Please read all of these instructions carefully before you use the device. Save this manual for future reference. What the warranty does not cover Any product, on which the serial number has been defaced, modified or removed. Damage, deterioration or malfunction resulting from: Accident, misuse, neglect, fire, water, lightning, or other acts of nature, unauthorized product modification, or failure to follow instructions suppl
Summary of the content on the page No. 4
1.3 Regulatory Notices Federal Communications Commission (FCC) This equipment has been tested and found to comply with Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. Any changes or modifications made to this equipment may void the user’s authority to operate this equipment. 1.4 Introduction Avenview FO-HDM-XX-MM Series with fiber optic cable system lets you extend digital flat panel sig
Summary of the content on the page No. 5
1.5 Model Description FO-HDM-XX-MM Model Name Length in Meters (5 = 5 meters, 10 = 10 meters) 1.6 Package Contents Before you start the installation of the converter, please check the package contents. - HDMI Optical Cable with Transmitter and Receiver x 1 - User’s Manual x 1 1.7 Before Installation Put the product in an even and stable location. If the product falls down or drops, it may cause an injury or malfunction. Don’t place the product in too h
Summary of the content on the page No. 6
1.8 Installation Avenview FO-HDM-XX-MM is composed of a Transmitter converting the graphic signal of a computer to optical and Optical Fiber propagating the optical signal and Receiver supplying electrical signal to monitor converted from the optical signal to electrical signal. The Transmitter should be connected to computer and the Receiver should be connected to a monitor. Avenview FO-HDM-XX-MM is designed to self-detect the resolution of the monitor and change the resolution acc
Summary of the content on the page No. 7
Section 2: Specifications Item Description Units FO-HDM-XX-MM (Transmitter) FO-HDM-XX-MM (Receiver Unit Description HDMI Fiber Optic Transmitter HDMI Fiber Optic Receiver HDMI Compliance HDMI 1.3 DVI Compliance DVI 1.0 HDCP Rev 1.1 Input Signal TMDS Signal (HDMI 1.3 Standard) Output Signal TMDS Signal (HDMI 1.3 Standard) 12bit Deep Color / 60Hz Video Bandwidth Supported Resolution & Up to WUXGA (1920x1200), 1080p @ 100 meters ( 330 feet) Distance 4 ch 850 nm Multi-Mode VCSEL 4 ch G
Summary of the content on the page No. 8
2.1 Part List Item Description Q’t y Material Glass filled thermoplastic UL94V-0 DVI-D Single Link 18 Plug A 2 Glass filled PC UL94V-0 DVI Case-Top, Bottom B 2 DVI Thumb Screw SUM 24L+ABS C 4 Stopper PVC 55% D 2 FR-4, 1.5t UL94V-0 Epoxy Printed Circuit Board for Tx E 1 PA46 UL94V-0 + C5210 Optical Connector for VCSEL,PD F 2 Optical Connector for fiber PA46 UL94V-0 G 2 Epoxy Printed Circuit Board for Rx FR-4, 1.5t UL94V-0 H 1 GaAs Vertical Surface Emitting Laser Diode I
Summary of the content on the page No. 9
2.2 Power Consumption and DDC Power Requirements Power consumption of FO-HDM-XX-MM Transmitter and Receiver Module Item maximum unit 0.8 Ws a tt Transmitter 1.05 Watt Receiver Transmitter module of FO-HDM-XX-MM without external power supply is operated by drawing out power for DDC from the computer and receiver module of FO-HDM-XX-MM cable also utilize the DDC power delivered via copper wire. If graphic board of the computer does not supply over 0.6A, 5V, FO-HDM-XX-MM cable may n
Summary of the content on the page No. 10
2.4 FO-HDM-XX-MM Cable Construction The construction of 4 Optical Fibers and 4 Copper wires cable shall be in accordance with Figure and Table below: The Dimension of FO-HDM-XX-MM Cable Items Unit Specification DVI Cable Make-up - Layer Stranding Drain Wires (Size/Stranded) mm(AWG) -0.203/7 (24) AL-Mylar Screen Shield - A helically Cable Outer Diameter mm 7.40±0.20 Jacket Color - FR-PVC(Orange, Blue, Black) Cable Marking - If need Fiber Cable Construction Item Description Number
Summary of the content on the page No. 11
2.4.1 Wiring Diagram www.avenview.com 11
Summary of the content on the page No. 12
Disclaimer While every precaution has been taken in the preparation of this document, Avenview Inc. assumes no liability with respect to the operation or use of Avenview hardware, software or other products and documentation described herein, for any act or omission of Avenview concerning such products or this documentation, for any interruption of service, loss or interruption of business, loss of anticipatory profits, or for punitive, incidental or consequential damages
