Summary of the content on the page No. 1
Automatic Multi-Satellite
TV Antenna
Model SK-3005
®
DIRECTV Slimline
www.winegard.com
For Technical Services, call 1-800-788-4417.
For Receivers and Programming, call 1-866-609-9374.
DO NOT RETURN ANTENNA TO PLACE OF PURCHASE.
For up-to-date information on receiver compatibility
and programming, visit www.winegard.com/receivers
Product Registration
Please register your Winegard product by filling out and returning the Product
Registration Card provided or by completing the online registrat
Summary of the content on the page No. 2
® Congratulations! You have selected the Winegard TRAV’LER® Automatic Multi-Satellite TV Antenna. The TRAV’LER Specifications antenna will deliver the ability to view up to five satellites at the same time with unmatched signal strength, the lowest travel height on the market, maximum HD capabilities and easy to use functionality—just like you get at home.This Height (stowed): 9.62 in Width (stowed): 33 in Length (stowed): 44 in manual provides important information on the installation and ope
Summary of the content on the page No. 3
37.5” from roof to highest point of antenna 18” ) d e R h c e a f l t e t c A t o t r e ( Y N Clearance Requirements Choosing a Location for the TRAV’LER Antenna The arm of the TRAV’LER antenna extends 33” from the center of the base and may operate only 10” above the For best performance and to reduce signal acquisition time, park the vehicle on a level surface
Summary of the content on the page No. 4
a e S l a e S l a e S l a e Coax Cable Coax Cable Front of RV FRONT s a e B t n S u l Seal o a M R e TRAV’LER Power Supply E L TV TV ’ Installing the TRAV’LER Antenna Installing the Cable Entry Plate Place the TRAV’LER antenna on the roof where you plan to install it. On the TRAV’LER mount base, the transition plate After installing the TRAV’LER antenna mount base, install a cable entry plate at the location Figure 8 is marked “FRONT” and “BACK.” Rotate
Summary of the content on the page No. 5
Installing the Reflector Once the sealant around the cable entry plate has begun to cure, check that there is nothing above the unit that might prevent the antenna from raising. Follow the steps below to raise the antenna for reflector installation. In some cases you may be able to install the reflector with the unit in the stowed position; if so, skip to step 3. Pay attention to the pinch points as the antenna raises. Refer to Figure 1 on page 1 of Installation. 1 Press [POWER], and hold for
Summary of the content on the page No. 6
Automatic Multi-Satellite TV Antenna Model SK-3005 ® DIRECTV Slimline www.winegard.com For Technical Services, call 1-800-788-4417. For Receivers and Programming, call 1-866-609-9374. DO NOT RETURN ANTENNA TO PLACE OF PURCHASE. For up-to-date information on receiver compatibility and programming, visit www.winegard.com/receivers Product Registration Please register your Winegard product by filling out and returning the Product Registratio
Summary of the content on the page No. 7
Automatic Operation The TRAV’LER interface offers a simple one button operation. The steps below show the screens that will be displayed as the TRAV’LER Automatic Multi-Satellite Antenna searches for satellites during operation. This one button operation is used for both general operation and for setting up the receiver. 1 2 WINEGARD COMPANY connecting to POWER ON antenna Table of Contents Installation Press and hold [POWER] for two Now that the power is on, release the Specifications.......
Summary of the content on the page No. 8
DIRECTV Receiver Setup Manual Operation The following instructions assume that the TRAV’LER antenna has found and locked onto The TRAV’LER antenna is a versatile satellite antenna and can be manually set to find many different satellites satellites 101°, 110°, 119°, 99° and 103°. There should be an asterisk next to 101°, 110°, and 119° individually. Note: this function is rarely used. The instructions below assume that the TRAV’LER antenna is already in on the TRAV’LER interface. the stowe
Summary of the content on the page No. 9
Receiver Setup, Continued Emergency Power Off The Winegard TRAV’LER antenna comes with an Emergency Power Off feature. To activate it, press and hold The program The receiver will 9 10 guide will run Data Feed and [POWER] and then press [SELECT] while still holding [POWER]. The TRAV’LER antenna will stop and turn off. download. Guide Feed Tests If the Emergency Power Off feature is used, the TRAV’LER antenna may not be in a safe position for travel. for a few moments. When the status Do no
Summary of the content on the page No. 10
Troubleshooting ANTENNA CONNECTION Check the data cable connection on the back of the TRAV’LER interface box. It may FAILED not be connected properly. EL HOME FAILURE Something is preventing the TRAV’LER mount from raising as it attempted to find the HOME position. Look for obstructions if unit has recently been manually raised or if the electronics have been replaced. The calibration may need to be reset. Contact Winegard Technical Support 1-800-788-4417. AZ MOTOR STALLED Something is preve
