Summary of the content on the page No. 1
English
ACCESS VHF SERIES USER GUIDE
This user guide provides detailed instructions for your Access VHF series wireless system. To get your system up and
running in minutes, see the Access VHF Series Quick Set Up Guide.
Your new Access VHF Series system is designed to give you both the freedom of a wireless system and world-famous
Shure sound quality. This manual covers both Single antenna and Diversity versions of the Access VHF Series systems:
the AXS31/58 handheld systems; the AXSGW bodypack
Summary of the content on the page No. 2
English TRANSMITTER FEATURES 3 4 10 5 11 6 7 8 1 9
Summary of the content on the page No. 3
English SYSTEM SETUP BATTERY INSTALLATION BODYPACK TRANSMITTER SETUP 1. Attach the transmitter to your belt, guitar strap, or waistband 1. Slide the transmitter POWER ON/OFF switch to the OFF as shown in Figure 6. Depress the tab marked PRESS and position. slip the belt or strap between the transmitter body and the 2. AXB1, AXB1G: Press down on the OPEN side of the battery belt clip. For added stability, draw the strap or belt toward the compartment cover, slide it back and flip it open, as show
Summary of the content on the page No. 4
English WIRELESS SYSTEM OPERATION T1G AXR3 AXR4N 45° SHURE 45° AXR3 AXR4
Summary of the content on the page No. 5
English WIRELESS SYSTEM ADJUSTMENTS TRANSMITTER AUDIO GAIN ADJUSTMENT RECEIVER VOLUME ADJUSTMENT AXSGW Systems: The audio gain control on the transmitter in The volume control on the front panel of the AXR3 and AXR4N these systems is factory-preset at the minimum setting (full receivers can be adjusted to make the wireless system output counterclockwise) to reduce the risk of overload and distortion. level identical to that of a cabled guitar or bass or wired micro- If the red TRANSMITTER AUDIO
Summary of the content on the page No. 6
English TROUBLESHOOTING INDICATOR STATUS = on = flickers on loud peaks PROBLEM SOLUTIONS AXR4N RECEIVER TRANS- MITTER AXR3 RECEIVER TRANSMITTER AUDIO POWER ANTENNA POWER • Slide transmitter POWER switch to ON. • Make sure battery is inserted properly (+/– battery terminals must ON A B PEAK match transmitter terminals). LOW BATT RF POWER PEAK • Insert fresh battery. TRANSMITTER AUDIO POWER ANTENNA POWER • Make sure AC adapter is securely plugged into electrical outlet and into DC input connector
Summary of the content on the page No. 7
English SYSTEM AND COMPONENT SPECIFICATIONS RF Carrier Frequency Range AXR3 AND AXR4N RECEIVER SPECIFICATIONS 169.445 to 240.000 MHz AXR4N AXR3 Operating Range:100 m (328 ft.) under typical conditions Audio Frequency Response: 50 to 15,000 Hz, 3 dB Connector 3-Pin XLR (Male) and 1/4” Phone Jack Image Rejection: 75 dB typical 1/4” Phone Plug Spurious Rejection: 75 dB typical Maximum Output 1/4”: + 5dBV –6.8 dBV System Distortion (ref. 15 kHz deviation, 1 kHz modula- Levels at 15 KHz XLR: –10
Summary of the content on the page No. 8
English ACCESSORIES, LICENSING AND WARRANTY FURNISHED ACCESSORIES DECLARATION OF CONFORMITY Screwdriver . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 65A1659 We of Sew–in Mounting Block (WL93 AXSLWD Only) . . . . . . . . . . . . . . . . . . . 65B1733* Shure Incorporated Receiver AC Adapter . . . . . . . . . . . . . . . . . . . . . PS20 (120V) 222 Hartrey Ave. Guitar Cables (2) (AXSGW systems Only) . . . . . . . WA303 Evanston IL 60202–3696 U.S.A. Swivel Adapter (AXS31/58 system
