Metra Electronics 99-9303 user manual

Summary of the content on the page No. 1

INSTALLATION INSTRUCTIONS FOR PART 99-9303
APPLICATIONS
BMW Z4
2003-2008
99-9303
KIT FEATURES
• DIN Head Unit Provision
KIT COMPONENTS
A) Radio Housing TOOLS REQUIRED:
Small Flat Blade Screwdriver • Phillips Screwdriver
A
WIRING AND ANTENNA CONNECTIONS
(Sold Separately)
• 40-EU10 - European antenna adapter
• 70-9003 - European harness
TABLE OF CONTENTS
Dash Disassembly: pg. 1
Kit Assembly: pg. 2
Final Assembly: pg. 3
1-800-221-0932 www.metraonline.com
REV. 04-17-09 © COPYRIGHT

Summary of the content on the page No. 2

99-9303 BMW Z4 2003-2008 A 1 Disconnect the negative battery terminal to prevent an accidental short circuit. NOTE: Make sure the vent on/off dials are in the middle position. 2 Using a small flat blade screwdriver, release the metal clip located inside the vents facing upward on the left B and right side while pulling the vents outward from the dash. (Figure A) 3 Remove (2) Phillips screws exposed at top of radio and remove. (Figure B) 1 DASH DISASSEMBLY

Summary of the content on the page No. 3

KIT ASSEMBLY 99-9303 DIN HEAD UNIT PROVISION A NOTE: The bottom bar connecting the two sides of the 99-9303 will need to be cut and removed prior to Kit Assembly. (Figure A) Screw the 99-9303 housing into the 1 dash opening instead of the factory radio. (Figure B) B Slide the DIN cage into the space in 2 the 99-9303 and secure by bending the metal locking tabs outward. (Figure C) Slide the aftermarket head unit into 3 the DIN cage until secure. (Figure D) C D 2

Summary of the content on the page No. 4

99-9303 A A) Strip wire ends back 1/2" B B) Twist ends together C) Solder C D) Tape D Locate the factory wiring harness in the 1 dash. Metra recommends using the proper mating adapter and making the connections as shown. (Isolate and individually tape off the ends of any unused wires to prevent electrical short circuit) 2 Re-connect the negative battery terminal and test the unit for proper operation. 3 Reassemble radio and dash assemblies in reverse order of disassembly. KNOWLEDGE IS POWER Enh