Summary of the content on the page No. 1
8 10/100TX + 1 10/100/1000T/10/100 SFP Combo with
4 PoE Injectors Managed Switch
MIL-SM802GAF
8 10/100TX + 2 Gigabit Copper/SFP Combo with 8
PoE Injectors Managed Switch
MIL-SM8TXAF2GPA
User Manual
Rev.1.00
2007-07-13
Summary of the content on the page No. 2
Regulatory Approval - FCC Class A - UL 1950 - CSA C22.2 No. 950 - EN60950 - CE - EN55022 Class A - EN55024 Canadian EMI Notice This Class A digital apparatus meets all the requirements of the Canadian Interference-Causing Equipment Regulations. Cet appareil numerique de la classe A respecte toutes les exigences du Reglement sur le materiel brouilleur du Canada. European Notice Products with the CE Marking comply with both the EMC Directive (89/336/EEC) and the Low Voltage Dir
Summary of the content on the page No. 3
FCC Warning This Equipment has been tested and found to comply with the limits for a Class-A digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
Summary of the content on the page No. 4
Contents FCC Warning ......................................................................................i CE Mark Warning...............................................................................ii Introduction ............................................................................1 Features............................................................................................ 2 Software Feature ............................................................................
Summary of the content on the page No. 5
Trunk Commands Set .....................................................................................27 VLAN Commands Set .....................................................................................29 Spanning Tree Commands Set .......................................................................31 QOS Commands Set.......................................................................................33 IGMP Commands Set ........................................................
Summary of the content on the page No. 6
SNTP Configuration ........................................................................ 58 IP Security ...................................................................................... 61 User Authentication......................................................................... 62 Port Statistics.................................................................................. 63 Port Control..................................................................................... 64
Summary of the content on the page No. 7
802.1X/Radius Configuration ..........................................................................93 System Configuration ..................................................................................93 802.1x Per Port Configuration .....................................................................94 Misc Configuration.......................................................................................95 MAC Address Table .......................................................
Summary of the content on the page No. 8
Introduction Power-over-Ethernet (PoE) eliminates the need to run power to other devices on a wired LAN. Using Power-over-Ethernet systems installers needs to run only a single Category 5 Ethernet cable that carries both power and data to each device. This allows for greater flexibility in the location of network devices and significantly decreasing installation costs in many cases. There are two system components in PoE—the Power Sourcing Equipment (PSE) initiates the connection to
Summary of the content on the page No. 9
Features System Interface/Performance RJ-45 ports support Auto MDI/MDI-X Function Embedded 4-port or 8-port PoE injector function Store-and-Forward Switching Architecture Back-plane (Switching Fabric): 5.6Gbps (8 10/100TX + 2 Giga Copper/Mini-GBIC Combo model) Back-plane (Switching Fabric): 3.6Gbps (8 10/100TX + 1 10/100/1000T/100/1000 SFP Combo model) 1Mbits Packet Buffer 8K MAC Address Table VLAN Port Based VLAN Support 802.1 Q Tag VLAN GVRP Double
Summary of the content on the page No. 10
Spanning Tree Support IEEE802.1d Spanning Tree Support IEEE802.1w Rapid Spanning Tree X-ring X-ring, Dual Homing, and Couple Ring Topology Provide redundant backup feature and the recovery time below 300ms Support 802.1ab LLDP ** Bandwidth Control Ingress Packet Filter and Egress Rate Limit Broadcast/Multicast Packet Filter Control System Event Log System Log Server/Client SMTP e-mail Alert SNMP Trap Device cold start Authentication failure X
Summary of the content on the page No. 11
Software Feature SNMP v1 SNMP v2c Management SNMP v3 Web/Telnet/Console (CLI)/Menu Driven** Port based VLAN IEEE802.1Q Tag VLAN(256 entries) / VLAN ID(Up VLAN to 4K, VLAN ID can be assigned from 1 to 4094) GVRP (256 Groups) Double Tag VLAN (Q in Q)* Port Trunk with LACP Port Trunk: 4 trunk groups of maximum 4 LACP trunk members Supports LLDP that allows switch to advertise its LLDP** identification and capability on the LAN IEEE802.1d Spanning tree Spanning Tree IEEE802.1w
Summary of the content on the page No. 12
Supports100 entries of MAC address for static Port Security MAC and another 100 for MAC filter Supports 3 mirroring types: “RX, TX and Both Port Mirror packet” Supports IGMP snooping v1 and v2 IGMP 256 multicast groups IGMP query mode Supports 10 IP addresses that have permission to IP Security access the switch management to prevent unauthorized intruder Supports ingress packet filter and egress packet limit The egress rate control supports all of packet type and the limit rate
Summary of the content on the page No. 13
Supports System log record and remote system System log log server Supports SMTP Server and 6 email accounts for SMTP receiving event alert Up to 3 Trap stations Cold start, Port link down, Port link up, SNMP Trap authorization failure, PoE status, X-ring topology change DHCP Client DHCP DHCP Server Provides DNS client feature and supports Primary DNS and Secondary DNS server Supports Simple Network Time Protocol to SNTP synchronize system clock in Internet Firmware Suppor
Summary of the content on the page No. 14
Package Contents Unpack the contents of the 8 10/100TX + 2 Gigabit copper/Mini-GBIC Combo with 8 PoE Injectors Managed Switch or 8 10/100TX + 1 10/100/1000T/100/1000 SFP Combo with 4 PoE Injectors Managed Switch then verify them against the checklist below: (1) 8 10/100TX + 2 Gigabit copper/Mini-GBIC Combo with 8 PoE Injectors Managed Switch or (1) 8 10/100TX + 1 10/100/1000T/100/1000 SFP Combo with 4 PoE Injectors Managed Switch (4) Rubber Pads (1) RS-232 cable (1) Powe
Summary of the content on the page No. 15
Hardware Description This section mainly describes the hardware of the PoE Injector Managed Switch and gives a physical and functional overview on the certain switch. Physical Dimension (MIL-SM802GAF) 8 10/100TX + 1 10/100/1000T/100/1000 SFP Combo with 4 PoE Injectors Managed Switch’s physical dimensions is 217mm(W) x 140mm(D) x 43mm(H). (MIL-SM8TXAF2GPA) 8 10/100TX + 2 Gigabit copper/Mini-GBIC Combo with 8 PoE Injectors Managed Switch’s physical dimensions is 270mm(W) x 210m
Summary of the content on the page No. 16
RJ-45 Ports: 8 x 10/100 N-way auto-sensing for 10Base-T or 100Base-TX connections. Ports 1 ~ 4 are general 10/100Base-TX Ethernet ports; Ports 5 ~ 8 are for Data in/out and Power out. In general, MDI means connecting to another Hub or Switch while MDIX means connecting to a workstation or PC. Therefore, Auto MDI/MDIX would allow the unit to connect to another switch or workstation without changing non-crossover or crossover cabling. 1 Giga port: 1 x 10/100/1000TX N-Way auto-sensing
Summary of the content on the page No. 17
LED Indicators The LED Indicators display real-time information of systematic operation status. The following table provides descriptions of LED status and their meaning. The LED indicators description of 8 10/100TX + 2 Gigabit Copper/Mini-GBIC Combo model (MIL-SM8TXAF2GPA) LED Status Description Green Power On Power OFF No power inputs The port is supplying power to the Green connected powered-device FWD (port 1~8) No powered device attached or power OFF supplying fail
Summary of the content on the page No. 18
Green Connected to network LK/ACT Blinking Networking is active (MINI GBIC 9, 10) OFF Not connected to network The LED indicators description of 8 10/100TX + 1 10/100/1000T/100/1000 SFP Combo model (MIL-SM802GAF) LED Status Description Green Power On Power OFF No power inputs Green The port is operating at speed of 1000M COPPER 1000M The port is disconnected or not operating OFF at speed of 1000M Green Connected to network LNK/ACT Blinking Networking is active (port
Summary of the content on the page No. 19
No powered device attached or power OFF supplying failed Green The port is operating at speed of 100M 100M The port is disconnected or not operating OFF at speed of 100M Orange Full duplex FDX/COL (port 1~8) Blinking Collision of packets occurs OFF Half duplex or not connected to network Rear Panel The 3-pronged power plug is located on the rear panel of the 8 10/100TX + 1 10/100/1000/100/1000 SFP Combo with 4 PoE Injectors Managed Switch as shown below. The switch will wo
Summary of the content on the page No. 20
Frequency of 50-60Hz, or work with DC 48V which is the redundant power supply for the switch. The Rear Panel of the 8 10/100TX + 2 Gigabit copper/ MINI GBIC Combo with 8 PoE Injector Managed Switch (MIL-SM8TXAF2GPA) Desktop Installation Set the switch on a sufficiently large flat space with a power outlet nearby. The surface where you put the switch should be clean, smooth, level and sturdy. Make sure there is enough clearance around the switch to allow attachment of cables, po
