UNICOM Electric FEP-31024T-1 user manual

Summary of the content on the page No. 1

Dyna-Switch/16
Dyna-Switch/24
16 Port or 24 Port
10/100Base-TX Switch
FEP-31016T-1
FEP-31024T-1
908 Canada Court
City of Industry, CA 91748 U.S.A.
Phone: 626.964.7873 or 800.346.6668 Fax: 626.964.7880
www.unicomlink.com e-mail: info@unicomlink.com
USER’S MANUAL
©UNICOM 2001. UNICOM and “A Network Systems Solution” are trademarks of UNICOM Electric, Inc.
All rights reserved. Specifications subject to change without notice.
Rev: 12.02

Summary of the content on the page No. 2

Necessary Cables: UTP (Unshielded Twisted Pair) Cable Package Contents LED Indicators: Per Device: Power Per Port: LINK/ACT, FDX/COL Package includes the following:  Dyna-Switch/16 or 24 Performance Specifications  Rack-mounting brackets Transmission Method: Store and forward  AC power cord MAC address table: 8K-entry MAC address table  Four (4) adhesive-backed rubber feet Maximum Forwarding Rate: 14,880 pps /10Base-T  User’s manual (64byte packets) 148,800 pps /100Base-TX  Warranty card M

Summary of the content on the page No. 3

Introduction Troubleshooting The Switch can be easily monitored through panel indicators to assist in The Dyna-Switch/16 and Dyna-Switch/24 (Auto MDI/MDIX) are Fast identifying problems. This section describes common problems you may Ethernet switches that provide wire-speed, a Fast Ethernet switching encounter and possible solutions. function which allows high-performance, low-cost connections to Full- duplex, Half-duplex, 10Mbps and 100Mbps Ethernet networks. The  Power Switches are targeted

Summary of the content on the page No. 4

Segment Bridge Hardware Description For enterprise networks where large data broadcasts are constantly The Front Panel processed, these switches are an ideal solution for department users to The Front Panels of the Dyna-Switch/16 and 24 consist of connect to the corporate backbone. 10/100Base-TX RJ-45 ports and LED Indicators. In the illustration below, two Ethernet switches, with PCs, print servers, and a local server attached, are both connected to a Dyna-Switch. All of LK/ACT Dyna-Switch/16

Summary of the content on the page No. 5

Network Application LK/ACT Dyna-Switch/16 FD/COL This section provides a few samples of network topology in which the LK/ACT 16 Port 10/100Base-TX Switch FD/COL Switches are used. The Dyna-Switch/16 and 24 are designed to be POWER used as segment switches. With their large address tables (8K MAC address) and high performance, they are ideal for interconnecting LINK/ACT and FDX/COL networking segments. Power Indicator Indicators You can use the Dyna-Switch/16 and 24 to connect PCs, workstations