Summary of the content on the page No. 1
TigerStack III 10/100
24-Port Fast Ethernet Switch
◆ 24 auto-MDI/MDI-X 10BASE-T/100BASE-TX ports
◆ 10BASE-T/100BASE-TX ports support PoE capabilities
◆ 2 Gigabit combo ports (RJ-45/SFP)
◆ 8.8 Gbps of aggregate bandwidth
◆ Stacks up to 8 units
◆ Non-blocking switching architecture
◆ Spanning Tree Protocol, RSTP, and MSTP
◆ Up to six LACP or static 4-port trunks
◆ RADIUS and TACACS+ authentication
◆ Rate limiting for bandwidth management
◆ CoS support for four-level priority
◆ Full support for VLA
Summary of the content on the page No. 2
Summary of the content on the page No. 3
TigerStack III 10/100 Installation Guide From SMC’s Tiger line of feature-rich workgroup LAN solutions 38 Tesla Irvine, CA 92618 June 2005 Phone: (949) 679-8000 Pub. # 150200037700A
Summary of the content on the page No. 4
Information furnished by SMC Networks, Inc. (SMC) is believed to be accurate and reliable. However, no responsibility is assumed by SMC for its use, nor for any infringements of patents or other rights of third parties which may result from its use. No license is granted by implication or otherwise under any patent or patent rights of SMC. SMC reserves the right to change specifications at any time without notice. Copyright © 2005 by SMC Networks, Inc. 38 Tesla Irvine, CA 92618 All rights r
Summary of the content on the page No. 5
LIMITED WARRANTY Limited Warranty Statement: SMC Networks, Inc. (“SMC”) warrants its products to be free from defects in workmanship and materials, under normal use and service, for the applicable warranty term. All SMC products carry a standard 90-day limited warranty from the date of purchase from SMC or its Authorized Reseller. SMC may, at its own discretion, repair or replace any product not operating as warranted with a similar or functionally equivalent product, during the applicable
Summary of the content on the page No. 6
LIMITED WARRANTY WARRANTIES EXCLUSIVE: IF AN SMC PRODUCT DOES NOT OPERATE AS WARRANTED ABOVE, CUSTOMER’S SOLE REMEDY SHALL BE REPAIR OR REPLACEMENT OF THE PRODUCT IN QUESTION, AT SMC’S OPTION. THE FOREGOING WARRANTIES AND REMEDIES ARE EXCLUSIVE AND ARE IN LIEU OF ALL OTHER WARRANTIES OR CONDITIONS, EXPRESS OR IMPLIED, EITHER IN FACT OR BY OPERATION OF LAW, STATUTORY OR OTHERWISE, INCLUDING WARRANTIES OR CONDITIONS OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. SMC NEITHER ASSUME
Summary of the content on the page No. 7
COMPLIANCES FCC - Class A This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause interference to radio commu- nications. It has been tested and found to comply with the limits for a Class A computing device pursuant to Subpart B of Part 15 of FCC Rules, which are designed to provide reason- able protection against such interference when operated in a commercial environment. Oper- ation of this e
Summary of the content on the page No. 8
COMPLIANCES CE Mark Declaration of Conformance for EMI and Safety (EEC) This information technology equipment complies with the requirements of the Council Directive 89/336/EEC on the Approximation of the laws of the Member States relating to Electromagnetic Compatibility and 73/23/EEC for electrical equipment used within certain voltage limits and the Amendment Directive 93/68/EEC. For the evaluation of the compli- ance with these Directives, the following standards were applied: RFI Emissi
Summary of the content on the page No. 9
COMPLIANCES Australia AS/NZS 3548 (1995) - Class A SMC contact for products in Australia is: SMC Communications Pty. Ltd. Suite 18, 12 Tryon Road, Lindfield NSW2070, Phone: 61-2-94160437 Fax: 61-2-94160474 Safety Compliance Warning: Fiber Optic Port Safety When using a fiber optic port, never look at the transmit laser while CLASS I it is powered on. Also, never look directly at the fiber TX port and LASER DEVICE fiber cable ends when they are powered on. Avertissment: Ports pour fibres optiq
Summary of the content on the page No. 10
COMPLIANCES • The socket outlet must be near to the unit and easily accessible. You can only remove power from the unit by disconnecting the power cord from the outlet. • This unit operates under SELV (Safety Extra Low Voltage) conditions according to IEC 60950. The conditions are only maintained if the equipment to which it is connected also operates under SELV conditions. France and Peru only † This unit cannot be powered from IT supplies. If your supplies are of IT type, this unit must be
Summary of the content on the page No. 11
COMPLIANCES • Le coupleur d’appareil (le connecteur du groupe et non pas la prise murale) doit respecter une configuration qui permet un branchement sur une entrée d’appareil EN 60320/IEC 320. • La prise secteur doit se trouver à proximité de l’appareil et son accès doit être facile. Vous ne pouvez mettre l’appareil hors circuit qu’en débranchant son cordon électrique au niveau de cette prise. • L’appareil fonctionne à une tension extrêmement basse de sécurité qui est conforme à la norme IE
Summary of the content on the page No. 12
COMPLIANCES • Die Netzsteckdose muß in der Nähe des Geräts und leicht zugänglich sein. Die Stromversorgung des Geräts kann nur durch Herausziehen des Gerätenetzkabels aus der Netzsteckdose unterbrochen werden. • Der Betrieb dieses Geräts erfolgt unter den SELV-Bedingungen (Sicherheitskleinstspannung) gemäß IEC 60950. Diese Bedingungen sind nur gegeben, wenn auch die an das Gerät angeschlossenen Geräte unter SELV-Bedingungen betrieben werden. Stromkabel. Dies muss von dem Land, in dem es ben
Summary of the content on the page No. 13
COMPLIANCES Warnings (in German) Warung: Dieses Produkt enthält keine Teile, die eine Wartung vom Benutzer benötigen. Warung: Installation und Deinstallation des Gerätes müssen von qualifiziertem Servicepersonal durchgeführt werden. Warung: Wenn das Gerät an eine Steckdose angeschlossen wird, muß der Masseanschluß am dreipoligen Netzstecker mit Schutzerde verbunden werden, um elektrische Gefahren zu vermeiden. Warung: Dieses Gerät nutzt Laser zur Signalübertragung über Glasfasern. Die Laser
Summary of the content on the page No. 14
COMPLIANCES Audience This guide is for system administrators with a working knowledge of network management. You should be familiar with switching and networking concepts. Zielgruppe Dieser Anleitung ist fuer Systemadministratoren mit Erfahrung im Netzwerk- mangement. Sie sollten mit Switch- und Netzwerkkonzepten vertraut sein. Related Publications The following publication gives specific information on how to operate and use the manage- ment functions of the switch: The 24-Port Fast Ethernet P
Summary of the content on the page No. 15
TABLE OF CONTENTS 1 About the TigerStack III 10/100 . . . . . . . . . . . . . . . . . . .1-1 Overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-1 Switch Architecture . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-2 Power-over-Ethernet Capability . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-2 Network Management Options . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-3 Description of
Summary of the content on the page No. 16
TABLE OF CONTENTS Mounting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-4 Rack Mounting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-4 Desktop or Shelf Mounting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-7 Installing an SFP Transceiver . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-8 Stacking Switches . . . . . . . . . . . . . . . . . . . . . . . . . .
Summary of the content on the page No. 17
TABLE OF CONTENTS APPENDICES: A Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . A-1 Diagnosing Switch Indicators . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .A-1 Diagnosing Power Problems with the LED Indicators . . . . . . . . .A-2 Power and Cooling Problems . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .A-2 Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Summary of the content on the page No. 18
TABLES Table 1-1 Port Status LED Indicators . . . . . . . . . . . . . . . . . . . . . . . . . . 1-5 Table 1-2 System Status LED Indicators . . . . . . . . . . . . . . . . . . . . . . . . 1-7 Table 3-1 Serial Cable Wiring . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-13 Table 4-1 Maximum 1000BASE-T Gigabit Ethernet Cable Length . . . 4-8 Table 4-2 Maximum 1000BASE-SX Gigabit Ethernet Cable Lengths . 4-8 Table 4-3 Maximum 1000BASE-LX Gigabit Ethernet Cable Length . 4-8 Table
Summary of the content on the page No. 19
FIGURES Figure 1-1 Front and Rear Panels. . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-2 Figure 1-2 Port LED Indicators . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-5 Figure 1-3 System LED Indicators . . . . . . . . . . . . . . . . . . . . . . . . . . 1-7 Figure 1-4 Stack Master Button . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-8 Figure 1-5 Mode Selection . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-9 Figure 1-6 Optional Stack
Summary of the content on the page No. 20
FIGURES xiv
