Summary of the content on the page No. 1
Model 6511RC
Matrix Switch
User Manual
Sales Office: +1 (301) 975-1000
Technical Support: +1 (301) 975-1007
E-mail: support@patton.com
WWW: www.patton.com
Part Number: 07MD6511RC-GS, Rev. B
Revised: February 20, 2012
Summary of the content on the page No. 2
Patton Electronics Company, Inc. 7622 Rickenbacker Drive Gaithersburg, MD 20879 USA tel: +1 (301) 975-1000 fax: +1 (301) 869-9293 support: +1 (301) 975-1007 url: www.patton.com e-mail: support@patton.com Copyright © 2012, Patton Electronics Company. All rights reserved. The information in this document is subject to change without notice. Patton Electronics assumes no liability for errors that may appear in this document. The software described in this document is furnished under a license and
Summary of the content on the page No. 3
Contents Contents ......................................................................................................................................................... 3 Compliance Information ................................................................................................................................ 7 Radio and TV Interference ...............................................................................................................................7 Industry Canada N
Summary of the content on the page No. 4
Contents Model 6511RC User Manual Temperature ...................................................................................................................................................27 Altitude ...........................................................................................................................................................27 Humidity ................................................................................................................................
Summary of the content on the page No. 5
Model 6511RC User Manual Contents Configuring the SDH path trace parameters .............................................................................................57 Configuring DS0 idle codes ............................................................................................................................58 Accessing the idle code configuration ........................................................................................................59 Defining the DS0 idle code c
Summary of the content on the page No. 6
Contents Model 6511RC User Manual Contact information............................................................................................................................................102 Warranty Service and Returned Merchandise Authorizations (RMAs).................................................................102 Warranty coverage ........................................................................................................................................102 Out-of-warran
Summary of the content on the page No. 7
Compliance Information Radio and TV Interference The Model 6511RC generates and uses radio frequency energy, and if not installed and used properly—that is, in strict accordance with the manufacturer's instructions—may cause interference to radio and television recep- tion. The Model 6511RC has been tested and found to comply with the limits for a Class A computing device in accordance with the specifications in Subpart B of Part 15 of FCC rules, which are designed to provide rea- sonable prot
Summary of the content on the page No. 8
Compliance Information Model 6511RC User Manual If trouble is experienced with this equipment, for repair or warranty information, please contact our company. If the equipment is causing harm to the telephone network, the telephone company may request that you dis- connect the equipment until the problem is resolved. Connection to party line service is subject to state tariffs. Contact the state public utility commission, public service commission or corporation commission for information. In
Summary of the content on the page No. 9
About this guide This guide describes installing and configuring a Patton Electronics Model 6511 TDM-Digital Access Con- centrator (Matrix Switch). By the time you are finished with this guide, your Matrix Switch will be connected to the remote DSL modems and transferring data. The instructions in this guide are based on the following assumptions: • The Matrix Switch is installed in a Patton ForeFront chassis • The Matrix Switch will connect to an SDH/STM-1 network • There is a LAN connected t
Summary of the content on the page No. 10
About this guide Model 6511RC User Manual Precautions Notes and cautions, which have the following meanings, are used throughout this guide to help you become aware of potential Matrix Switch problems. Warnings relate to personal injury issues, and Cautions refer to potential property damage. Note Calls attention to important information. The shock hazard symbol and WARNING heading indicate a potential electric shock hazard. Strictly follow the warning instructions to avoid injury caused by
Summary of the content on the page No. 11
Model 6511RC User Manual About this guide Table 1. General conventions (Continued) Convention Meaning Are you ready? All system messages and prompts appear in the Courier font as the system would display them. % dir *.* Bold Courier font indicates where the operator must type a response or command Mouse conventions The following conventions are used when describing mouse actions: Table 2. Mouse conventions Convention Meaning Left mouse button This button refers to the primary or leftmost mouse
Summary of the content on the page No. 12
About this guide Model 6511RC User Manual 12
Summary of the content on the page No. 13
Chapter 1 Introduction Chapter contents Model 6511RC Matrix Switch overview................................................................................................................14 Hardware overview................................................................................................................................................16 ForeFront chassis architectures ..................................................................................................................
Summary of the content on the page No. 14
1 • Introduction Model 6511RC User Manual Model 6511RC Matrix Switch overview The Model 6511RC Matrix Switch (see figure 1) combines TDM aggregation and cross-connection with high- speed packet switching over synchronous digital hierarchy (SDH) and Ethernet uplinks for the Patton Fore- Front Access Infrastructure Solutions (AIS) system. The web-manageable Matrix Switch provides a fully non- blocking mapping and switching matrix for TDM and Ethernet traffic traversing the ForeFront chassis or cha
Summary of the content on the page No. 15
Model 6511RC User Manual 1 • Introduction Figure 2 shows the major functions and connections the Matrix Switch provides within the ForeFront chassis. Each Model 6511RC enables service providers to perform SDH multiplexing and demultiplexing with any-to- any timeslot mapping for up to 2048 DS0 channels. The on-board TDM multiplexer can map any of the 4096 DS0 timeslots on the TDM bus in the chassis midplane to any of the 2048 DS0s on the STM-1 uplink. Each DS0 consists of a 64 kbps communicati
Summary of the content on the page No. 16
1 • Introduction Model 6511RC User Manual Hardware overview The Model 6511RC combines DS0 cross-connection and concentration with powerful Ethernet switching in a single-slot blade for installation in a standard CPCI chassis. The Matrix Switch card-set comprises two mod- ules, a processor blade (see figure 1 on page 14) inserted from the front of the ForeFront chassis, and a rear interface blade (see figure 3) inserted opposite to the processor blade. The front and rear blades mate at the mid
Summary of the content on the page No. 17
Model 6511RC User Manual 1 • Introduction Figure 5. Model 6511RC front panel LEDs and ports The front panel of the processor blade presents LED status indicators, an RS-232 configuration port and a 10/100 Ethernet management port (see figure 5). The rear entry interface blade (see figure 6 on page 18) pre- sents LEDs indicating alarm and WAN status, physical connectors for the STM-1 port, as well as two 10/100/1000 Ethernet RJ-45 connectors with embedded link and activity status indicator LEDs
Summary of the content on the page No. 18
1 • Introduction Model 6511RC User Manual Figure 6. Model 6511RCT rear entry car front panel LEDs and ports Three versions of the rear card offer the following connector types for the STM-1 port: • SC20—Optical interface presented on Rx and Tx SC connectors for singlemode fiber with a wavelength of 1310 nm. The interface complies with ITU specifications G.957 and G.652. • EBNC—Electrical interface presented on Rx and Tx 75-ohm BNC connectors. • SC20/EBNC—Optical and electrical interfaces as des
Summary of the content on the page No. 19
Model 6511RC User Manual 1 • Introduction ForeFront chassis architectures The Model 6511RC can be installed in the following ForeFront cPCI chassis: • Model 6476 6U chassis • Model 6676 9U chassis ForeFront Model 6476 6U cPCI chassis The ForeFront Model 6476 6U cPCI chassis provides 8 slots for installing cPCI processor blades (see figure 7). The Model 6476 chassis accepts up to two Model 6511RC blades, installed in the fabric slots (designated by a yellow blade guide). Using the H.110 TDM and
Summary of the content on the page No. 20
1 • Introduction Model 6511RC User Manual Figure 8. Model 6676 chassis, front view The ForeFront Model 6676 9U chassis The ForeFront Model 6676 9U chassis offers 17 slots for installing cPCI processor blades (see figure 8). The Model 6676 midplane is divided into segment R (slots 1 through 8) and segment L (slots 9 through 17). Each mid-plane segment contains its own H.110 and PICMG 2.16 bus, so since each 6511RC connects to one mid- plane segment, two Matrix Switch blades, installed in each o
