Network Technologies MAN049 user manual

Summary of the content on the page No. 1

NETWORK
Tel:330-562-7070
1275 Danner Dr
TECHNOLOGIES
Aurora, OH 44202 Fax:330-562-1999
INCORPORATED
NTI NTI
KEEMUX-P2 (2-Port PS/2 KVM Switch)
INSTALLATION / USER GUIDE
MAN049 Rev 8-28-01
NETWORK
TECHNOLOGIES
NTI
PS/2
PS/2
1
CPU 2 CPU 1 SELECT
CPU
KEEMUX-P2
INCORPORATED

Summary of the content on the page No. 2

TABLE OF CONTENTS Introduction......................................................................................... 2 Materials Materials Supplied............................................................................ 2 Materials NOT supplied but required................................................ 2 Installation........................................................................................... 2 Using the NTI Switch Front Panel Control.......................................

Summary of the content on the page No. 3

INTRODUCTION The KEEMUX-P2 switch allows one user to access two PS/2 computers with only one keyboard, monitor and mouse. Internal auto-boot circuitry allows both computers to boot simultaneously and error-free without the need for a keyboard, monitor and mouse on each computer. MATERIALS Materials Supplied with this kit: 1. NTI PS/2 KVM Switch Materials Not Supplied, BUT REQUIRED: 1. A set of 2 cables for each computer being connected to the switch must be used: 1. VEXT-xx-MM (high res) or

Summary of the content on the page No. 4

SCAN SCAN Mode is indicated by a flashing CPU port LED. The switch scans to either port with a CPU powered ON. That port remains active for the configured dwell time (default time is 5 seconds) before switching to the other powered ON CPU port. See Keyboard Control Section for configuring the scan dwell time. NOTE: The keyboard and mouse must remain idle for the full SCAN dwell time before the switch selects the other port. BROADCAST (use with extreme caution) BROADCAST Mode is indicated when bo