MTX Audio TA2301 user manual

Summary of the content on the page No. 1

TA2301 Owners Manual
Introduction
Thank you for choosing MTX to help reach your ultimate goal with your vehicle. Adding MTX amplifiers and
matching MTX speakers and subwoofers with StreetWires connections will put you in a better position to
hear, feel and experience all of the music the artist intended you to hear.
Specifications
Primary Ratings:
Power Output: 150 Watts RMS x 1 Channel at 4 Ohms and ≤ 1% THD+N
Signal-to-Noise Ratio (1Watt): 73dB
Secondary Ratings
Power Output: 300 Watts RM

Summary of the content on the page No. 2

5. Gain Control – This feature is used to fine-tune the input sensitivity of the amplifier to the source unit’s output level. 6. Selectable 80Hz or 120Hz 24dB/oct X-over – This control allows the user to choose one of two low-pass frequency points the amplifier will play for the best possible performance. The upper end of the crossover frequency points can be selected from either 80Hz, 24dB per octave or 120Hz at 24dB per octave. 7. ThunderEQ (Switchable)- This feature will add 0 or 12dB of l

Summary of the content on the page No. 3

2. Speaker Wire Connections – When installing the speaker wires, please take proper measures to protect them. For example, when connecting the door speakers, the speaker wire should run from the amplifier’s output terminals, under the carpet and through the factory rubber boot (loom) that protects the wires in the inner door jam. If the factory boot cannot be used, take other measures to protect these wires. Sometimes the door has to be completely removed to use the factory boot. If this is

Summary of the content on the page No. 4

Feature Setup and Adjustments 1. Selecting The Input Sensitivity Range – Before you turn on your system, you must select the proper input sensitivity range on your amp using the button labeled INPUT SENS located in the GAIN CONTROL section of the control panel. • Setting for aftermarket Source Units: Refer to your aftermarket owner’s manual for line level output specification. If the specification is not available, please follow the instructions listed below. X1 POSITION: 100mV – 1V (Typic

Summary of the content on the page No. 5

Trouble Shooting Read this if you want to be a do-it-yourselfer or give us a call at 800-CALLMTX. PROBLEM CAUSE SOLUTION No LED indication No +12V at remote connection Supply +12V to terminal No +12V at Power connection Supply +12V to terminal Insufficient ground connection Verify ground connection Blown power fuse Replace fuse LED on, no output Volume on head unit off Increase volume on head unit Speaker connections not made Make speaker connections Gain control on amplifier o