Extron electronic sMMX 32 AAP user manual

Summary of the content on the page No. 1

CONTACT
SYNC - TRI
PRE PEAK - ON
Connecting the control panel to an MMX 32 VGA MTP
See the drawing below. The wire connected to the 5 VDC pole
4
( on pages 2 and 3) should not be daisy chained. The power for
each AAP or MAAP must come directly from the +5V connector
Installation Guide
for the appropriate output on the MMX switcher.
See the drawing below. The wire connected to the Ground pole
5
( on pages 2 and 3) should not be shared or jumpered between
two AAPs and/or MAAPs. Run a se

Summary of the content on the page No. 2

Installation This guide describes how to connect the Extron MMX 32 architec- Control Panel Connections tural adapter plate (AAP) or MMX 32 mini architectural adapter plate To connect a panel to the switcher’s Remote and Tally Power connectors, (MAAP) to the MMX 32 VGA A and MMX 32 VGA MTP matrix switchers. wire the captive screw connectors on the rear of the panel as follows. In this manual, the term “switcher” refers to either the 4 3 MMX 32 VGA A or the MMX 32 VGA MTP. Where differences

Summary of the content on the page No. 3

CONTACT SYNC - TRI PRE PEAK - ON Connection Connection Only one MMX 32 AAP or MMX 32 MAAP control panel can 2 Input 2 pole — Connect this pole of the captive screw connector be used to control each output. to the appropriate connector on the connected switcher: � MMX 32 VGA A — Remote connector, pin 4 (to control input Extron recommends shielded twisted pair cable, such as selection for output 1) or pin 8 (for output 2) STP 22 Dual Plenum cable, part #22-162-03 (or equivalent), � MMX 32 V