Summary of the content on the page No. 1
8.5x11-inch cover with bleed on 4 sides
®
Enterasys
NAC Controller
Hardware Installation Guide
2S4082-25-SYS
7S4280-19-SYS
P/N 9034376
Summary of the content on the page No. 2
Summary of the content on the page No. 3
Electrical Hazard: Only qualified personnel should perform installation procedures. Riesgo Electrico: Solamente personal calificado debe realizar procedimientos de instalacion. Elektrischer Gefahrenhinweis: Installationen sollten nur durch ausgebildetes und qualifiziertes Personal vorgenommen werden. Notice EnterasysNetworks reserves the right to make changes in specifications and other information contained in this document and its web site without prior notice. The reader should in all cases
Summary of the content on the page No. 4
Regulatory Compliance Information Federal Communications Commission (FCC) Notice This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE: This equipment has been tested and found to comply with the limits for a class A digital device, pursuant to Part 15 of the FCC rules.
Summary of the content on the page No. 5
Electromagnetic Compatibility (EMC) This product complies with the following: 47 CFR Parts 2 and 15, CSA C108.8, 2004/108/EC, EN 55022, EN 61000‐3‐2, EN61000‐3‐3, EN 55024, AS/NZS CISPR 22, VCCI V‐3. Compatibilidad Electromágnetica (EMC) Este producto de Enterasys cumple con lo siguiente: 47 CFR Partes 2 y 15, CSA C108.8, 2004/108/EC, EN 55022, EN55024, EN61000‐3‐2, EN 61000‐3‐3, AS/NZS CISPR 22, VCCI V‐3. Elektro- magnetische Kompatibilität ( EMC ) Dieses Produkt entspricht den folgenden Ri
Summary of the content on the page No. 6
Supplement to Product Instructions (Hazardous Substance) (Parts) (Metal Parts) (Circuit Modules) (Cables & Cable Assemblies) (Plastic and Polymeric parts) (Circuit Breakers) SJ/T 11363-2006 Indicates that the concentration of the hazardous substance in all homogeneous materials in the parts is below the relevant threshold of the SJ/T 11363-2006 standard. SJ/T 11363-2006 Indicates that the concentration of the hazardous substance of at least one o
Summary of the content on the page No. 7
VCCI Notice This is a class A product based on the standard of the Voluntary Control Council for Interference by Information Technology Equipment (VCCI). If this equipment is used in a domestic environment, radio disturbance may arise. When such trouble occurs, the user may be required to take corrective actions. BSMI EMC Statement — Taiwan This is a class A product. In a domestic environment this product may cause radio interference in which case the user may be required to take adequate mea
Summary of the content on the page No. 8
Declaration of Conformity Application of Council Directive(s): 2004/108/EC 2006/95/EC Manufacturer’s Name: EnterasysNetworks,Inc. Manufacturer’s Address: 50 Minuteman Road Andover, MA 01810 USA European Representative Address: EnterasysNetworks, Ltd. Nexus House, Newbury Business Park London Road, Newbury Berkshire RG14 2PZ, England Conformance to Directive(s)/Product Standards: EC Directive 2004/108/EC EN 55022 EN 61000‐3‐2 EN 61000‐3‐3 EN 55024 EC Directive 2006/95/EC EN 60950 EN 60825 Equipme
Summary of the content on the page No. 9
2. RESTRICTIONS. Except as otherwise authorized in writing by Enterasys, You may not, nor may You permit any third party to: (a) Reverse engineer, decompile, disassemble or modify the Program, in whole or in part, including for reasons of error correction or interoperability, except to the extent expressly permitted by applicable law and to the extent the parties shall not be permitted by that applicable law, such rights are expressly excluded. Information necessary to achieve interoperabili
Summary of the content on the page No. 10
8. AUDIT RIGHTS. You hereby acknowledge that the intellectual property rights associated with the Program are of critical value to Enterasys, and, accordingly, You hereby agree to maintain complete books, records and accounts showing (i) license fees due and paid, and (ii) the use, copying and deployment of the Program. You also grant to Enterasys and its authorized representatives, upon reasonable notice, the right to audit and examine during Your normal business hours, Your books, records,
Summary of the content on the page No. 11
Contents Who Should Use This Guide ............................................................................................................................xv How to Use This Guide .....................................................................................................................................xv Related Documents .........................................................................................................................................xvi Typographical Convent
Summary of the content on the page No. 12
Installing the Rubber Feet ........................................................................................................................ 3-3 Installing the Chassis into a Rack ................................................................................................................... 3-3 Installing the Chassis on the Rack Shelf .................................................................................................. 3-3 Installing the Chassis Directly to the Rack .....
Summary of the content on the page No. 13
Regulatory Requirements ........................................................................................................................A-2 NAC Controller Engine Interface Specifications .......................................................................................A-3 NAC Controller Engine COM Port Pinout Assignments ...........................................................................A-4 NAC Controller PEP 2S4082-25 Module Specifications ..................................
Summary of the content on the page No. 14
5-1 LANVIEW LEDs for the 2S4082-25.................................................................................................... 5-2 5-1 LANVIEW LEDs for the 7S4280-19.................................................................................................... 5-2 5-2 OFFLINE/RESET Switch for the 2S4082-25 ...................................................................................... 5-6 5-2 OFFLINE/RESET Switch for the 7S4280-19 .............................................
Summary of the content on the page No. 15
A-10 Mini-GBIC Input/Output Port Specifications .......................................................................................A-7 A-11 COM Port Pin Assignments................................................................................................................A-7 A-12 MGBIC-LC01 / MGBIC-MT01 Optical Specifications .........................................................................A-8 A-13 MGBIC-LC01 / MGBIC-MT01 Operating Range ..........................................
Summary of the content on the page No. 16
xiv
Summary of the content on the page No. 17
About This Guide This guide provides an overview, installation and troubleshooting instructions, and specifications for the 2S4082‐25‐SYS and 7S4280‐19‐SYS EnterasysNACController. For information about the CLI (Command Line Interface) set of commands used to configure and manage the NACControllers, refer to the Enterasys Networks™ DFE‐Platinum and Diamond Series Configuration Guide. For information about the technical considerations for the planning and design of the Enterasys Network Access
Summary of the content on the page No. 18
Related Documents For... Refer to... An overview of the Enterasys NAC Controllers Chapter 1, Introduction Pre-installation site guidelines for the NAC Controller Chapter 2, Installation Requirements and Guidelines Instructions on setting up the Enterasys Matrix N1 Chassis Chapter 3, Enterasys Matrix N1 Chassis Setup Instructions for installing the DFE-Platinum module Chapter 4, NAC Controller PEP 2S4082-25 and DFE-Diamond module 7S4280-19 and the Installation Mini-GBICs interface modules Inst
Summary of the content on the page No. 19
Typographical Conventions Typographical Conventions The following typographical conventions and icons are used in this document. blue type Indicates a hypertext link. When reading this document online, click the text in blue to go to the referenced figure, table, or section. Lowercase x Indicates the general use of an alphanumeric character (for example, 6x1xx, the x’s indicate a combination of numbers or letters). Note: Calls the reader’s attention to any item of information that may be of sp
Summary of the content on the page No. 20
Getting Help Getting Help For additional support related to the NACController or this document, contact EnterasysNetworks using one of the following methods: World Wide Web www.enterasys.com/services/support/ Phone 1-800-872-8440 (toll-free in U.S. and Canada) or 1-978-684-1000 For the Enterasys Networks Support toll-free number in your country: www.enterasys.com/services/support/ Internet mail support@enterasys.com To expedite your message, please type [N-Series] in the subject line. To send
