Summary of the content on the page No. 1
®
LEGEND
Pressure Side Pool Cleaner
Installation Guide
IMPORTANT SAFETY INSTRUCTIONS
READ AND FOLLOW ALL INSTRUCTIONS
SAVE THESE INSTRUCTIONS
LEGEND® PLATINUM INSTALLATION MANUAL
Summary of the content on the page No. 2
Customer Service If you have questions about ordering Pentair replacement parts, and pool products, please use the following contact information: Customer Service (8 A.M. to 5 P.M. — Eastern and Pacific Times) Phone: (800) 831-7133 Fax: (800) 284-4151 Technical Support Sanford, North Carolina (8 A.M. to 5 P.M. — Eastern Time) Phone: (919) 566-8000 Fax: (919) 566-8920 Moorpark, California (8 A.M. to 5 P.M. — Pacific Time) Phone: (805) 553-5000 (Ext. 5591) Fax: (805) 553-5515 Web site visit www.pe
Summary of the content on the page No. 3
® LEGEND LL105PM / LL105PMG LL105PMTGG / LL105PMTWW LL105PMTRW / LL105PMTYW Important Information: ® The Legend Platinum automatic pool cleaner comes ready to connect into a female threaded 1-1/2" line, dedicated to our Universal Booster Pump. Also, if you have a chlorinator, solar system or other air inducing equipment, contact our Technical Support Department at 1-800-831-7133 before you install the ® Legend Platinum. (See diagram on page 2). ® The following are important facts to reme
Summary of the content on the page No. 4
TABLE OF CONTENTS I. Introduction ................................................................................................................................1 ® A. Thank You for Choosing the Legend Platinum.................................................................. 1 ® B. What to Expect from the Legend Platinum. ..................................................................... 1 II. Installation Instructions ........................................................................
Summary of the content on the page No. 5
I. Introduction ® A. Thank You for Choosing the B. What to Expect from the Legend ® Legend Platinum Pool Cleaner Platinum ® Congratulations on the purchase of your new When operating correctly, the Legend Platinum will ® automatic pool cleaner. The Legend Platinum is travel randomly throughout the pool, vacuuming and designed to give you years of dependable and sweeping the bottom. The climbing ability of the ® ® efficient service. With the Legend Platinum, you and Legend Platinum is dependent
Summary of the content on the page No. 6
II. Installation Instructions ® A. Legend Platinum Components B. Pool Connections ® ® The Legend Platinum Box Contains: The Legend Platinum comes equipped to connect to a female threaded 1-1/2 in. line, dedicated to our 1. Cleaner Head Universal Booster Pump. 2. Sand & Silt Bag 3. Sweep Hose Also, if the pool doesn't have a dedicated cleaner 4. Complete Feed Hose line please contact our Technical Support a. 1 - 8½ in. hose Department at 1-800-831-7133. b. 2 - 10 ft. long hoses c. 1 - 30 in. sof
Summary of the content on the page No. 7
E. Cutting the Feed Hose D. Installing the Twist Lock Pressure Relief Valve (Wall Fitting) The Hose assembly comes in 5 sections now covering approximately 30 ft. of the pool, which 1. Take out any existing pool cleaner and/or wall provides ample hose for most residential pools. The fitting. Back-Up Valve is now 30 in. from the head cleaner 2. Turn on the filtration pump and booster pump, and should always remain this distance. For larger flush out the plumbing line. pools see #14 on page 6 f
Summary of the content on the page No. 8
EXAMPLE OF HOSE ASSEMBLY STEPS 1. With the feed hose assembly attached to the pool wall, hold the feed hose assembly BEFORE CUTTING TO LENGTH by the opposite end with the clear hose and walk the perimeter of the pool to locate the farthest point on the perimeter from the wall fitting without stretching the hose assembly. 2. Measure the distance that the hose assembly extends beyond the pool perimeter farthest point located in Step 1 — (7½ ft. in this example). 3. Cut half of the length obtained
Summary of the content on the page No. 9
7. Re-assemble the hoses and the swivel using E. Cutting the Feed Hose - (cont.) mender nuts (see Figure below, Step 1). Put mender nut on swivels first, then push hose over 3. Lay the telepole next to the clear (soft) hose. If swivel (see Figure below, Step 2). Rotate mender the clear (soft) hose is longer than the mark on nut over hose clockwise until tight. Note: Keep the telepole, cut the excess from the end attached as many floats as possible on the long feed to the white (hard) hose. Do
Summary of the content on the page No. 10
E. Cutting the Feed Hose - (cont.) ® 8. When cutting hoses, please use strong scissors 12.Lower your complete Legend Platinum assembly into your pool carefully. It should look or a sharp knife. Be sure to slide the floats out of the way when cutting hose. like figure below. ® 9. Put extra mender nut on the Legend Platinum FIRST SECOND mast and push soft hose gently over mast at THIRD SWIVEL SWIVEL SWIVEL 1/2 in., turn mender nut around soft hose tight. LONG LONG Note: The Back-Up Valve still sh
Summary of the content on the page No. 11
® F. Checking Operation If the Legend Platinum does not travel to all areas of the pool, turn off the booster pump and pool ® filtration pump and make the necessary adjustments When operating correctly, the Legend Platinum will from the instructions in the next section. travel in a random pattern throughout the pool, vacuuming and sweeping the bottom. The climbing ® ability of the Legend Platinum is dependent on the ® G. Fine Tuning the Legend Platinum pools structure and water flow coming int
Summary of the content on the page No. 12
3. Checking Wheel RPM ® To determine whether the Legend Platinum is receiving the proper water pressure, turn off the booster pump, pool pump and carefully remove the ® Legend Platinum from the pool. Mark the front drive Tire/Wheel with a marker, or use the Logo located on the side of tire as a marker to count the rotations of the wheel per minute. Have someone turn on pool pump and then booster If you have any additional questions, please ® pump while you place the Legend Platinum in contact o
Summary of the content on the page No. 13
III. Operation/Periodic Maintenance D. Periodic Maintenance The following parts are wear items that should be A. Connecting/Disconnecting the checked, maintained or replaced as needed. Wear ® Legend Platinum items are considered any working or moving part(s) being worn due to the use of the cleaner. Wear items Turn off booster pump and pool pump. Then take the are not covered under warranty. Wall Fitting and twist lock the Wall Fitting clockwise ® into the Wall Adapter. To disconnec
Summary of the content on the page No. 14
III. Operation/Periodic Maintenance - 5. Sweep Hose (cont.) The Sweep Hose is provided to help keep the bottom and sides of your pool clean. The Sweep Hose is 2. Tires & Bearings warranted free of defects when shipped from the factory, and is considered a wear item. The tires are designed to protect the bottom of your pool and provide better traction. You need to rotate 6. Debris Valve or replace the tires when edges become rounded. This valve is located under the Debris Bag, it is The Whee
Summary of the content on the page No. 15
IV. TROUBLESHOOTING AND PERFORMANCE TIPS To insure the best performance from your cleaner, follow the troubleshooting guide listed below. A. PROBLEMS & SOLUTIONS ® ® Problem: Legend Platinum doesn't move or Problem: Legend Platinum will not back up. moves sluggishly or hangs up on steps. Solution: 1. Determine if the Back-Up Valve is Solution: 1. Be sure filter pump and booster pump cycling. (Hold the valve out of the are on and working properly. (You may water and the jet should come on for
Summary of the content on the page No. 16
IV. TROUBLESHOOTING AND PERFORMANCE TIPS A. PROBLEMS & SOLUTIONS - (cont.) Problem: Sweep Hose is sucked into the cleaner. Problem: Sweep Hose breaks surface and sprays nearby windows, patio decks and Solution: 1. Adjust the Sweep Hose using the bystanders. Adjustment Screw located on the bottom of the Swivel Mast. Turn Solution: 1. Adjust Sweep Hose to a gentle Adjustment Screw clockwise until the sweeping motion. Sweep Hose is in a gentle sweeping 2. Add optional Sweep Hose weight motion.
Summary of the content on the page No. 17
® LEGEND PLATINUM PARTS LIST Diagram # Part # Description Quantity 1 LLU5PM Top Cover - Gray 1 2 LLU145N Main Frame - White 1 2 LLU145NG Main Frame - Gray 1 3 EU10N Bottom Cover - White 1 3 LLU10NG Bottom Cover - Gray 1 4 LLU6 Feed Mast w/O-Ring - White 1 4 LLU6G Feed Mast w/O-Ring - Gray 1 5 EC86 Turbine Drive Shaft - Complete 1 6 EC83 Turbine Spacers 1 7 EC80 Turbine Bearings - Gray 2 8 EA40 Turbine Shaft Shield - White 1 8 LLA40G Turbine Shaft Shield - Gray 1 9 EC110 Turbine Cover w/Elbow - W
Summary of the content on the page No. 18
® LEGEND PLATINUM PARTS LIST Diagram # Part # Description Quantity 29 LLC60PM Wheel Bearings Only - Gray 8 30 E10 1 Back-Up Valve - White 30 LL10PM 1 Back-Up Valve - Gray EC55 31 Wheel Screw - Plastic - White 4 31 LLC55PM Wheel Screw - Plastic - Gray 4 32 LLC1PM Wheel - Rubber Tire - White 4 32 LLC1PMG Wheel - Rubber Tire - Gray 4 33 EB15 Hose Clamp 5 34 EC40 8 Screw LLD50 35 Feed Hose - clear soft - 10' 1 LLD50PM 35 Feed Hose - Gray soft - 10' 1 36 ED10P Float - Feed Hose - White 10 36 LLD10PM
Summary of the content on the page No. 19
® LEGEND PLATINUM EXPLODED VIEW 8.5" FIRST 10' SECOND 10' HOSE HOSE 30" SOFT 7.5' SOFT HOSE HOSE 15 LEGEND® PLATINUM INSTALLATION MANUAL
Summary of the content on the page No. 20
5/31/06 P/N YYPLATINSTALL REV. C © Pentair Water Pool and Spa, Inc. All rights reserved. Printed in USA. LEGEND® PLATINUM INSTALLATION MANUAL
