Summary of the content on the page No. 1
™
Prowler 720 and 730
Robotic Inground Pool Cleaners
Installation
and
User's Guide
IMPORTANT SAFETY INSTRUCTIONS
READ AND FOLLOW ALL INSTRUCTIONS
SAVE THESE INSTRUCTIONS
Summary of the content on the page No. 2
Customer Service If you have questions about ordering Pentair replacement parts, and pool products, please use the following contact information: Customer Service (8 A.M. to 5 P.M. — Eastern and Pacific Times) Phone: (800) 831-7133 Fax: (800) 284-4151 Technical Support Sanford, North Carolina (8 A.M. to 5 P.M. — Eastern Time) Phone: (919) 566-8000 Fax: (919) 566-8920 Moorpark, California (8 A.M. to 5 P.M. — Pacific Time) Phone: (805) 553-5000 (Ext. 6312) Fax: (805) 553-5502 Web site visit www.pe
Summary of the content on the page No. 3
i Contents Important Safety Precautions..............................................................................................ii Section 1: Introduction .....................................................................................................1 ™ Prowler 720 and 730 Overview .............................................................................1 ™ Prowler 720 and 730 Features ..............................................................................2 Section 2: Insta
Summary of the content on the page No. 4
ii IMPORTANT SAFETY PRECAUTIONS Important Notice: Attention Installer: This guide contains important information about the installation, operation and safe use of this product. This information should be given to the owner and/or operator of this equipment after installation of the pool cleaner. Attention User: This manual contains important information that will help you in operating and maintaining this pool cleaner. Please retain it for future reference. Consult Pentair Water with any
Summary of the content on the page No. 5
1 Section 1 Introduction ™ The Prowler 720 and 730 Overview Vacuums what you can see, filters what you can’t... ™ Prowler 720 and 730 are the computer-controlled, programmed cleaners that scrub and vacuum your pool’s bottom, walls and steps and provides supplemental filtration of pool water. Powerful, efficient, and smart! ™ The Prowler 720 and 730 features the patented Aqua Smart System. This intelligent program enables the cleaner to fully cover and efficiently clean any standard residential s
Summary of the content on the page No. 6
2 General Features Two-way cleaning performance: • Powerful vacuum action removes fine particles and larger debris. • Integrated filtration system captures dirt and debris in handy collection bag. • Integrated filter reduces run time of your primary filtration system by 25% to save on pump energy use and normal wear and tear. • Works fast; thoroughly scrubs and vacuums pools up to 20 x 50 feet in just 60–90 minutes. • Auto-reverse feature prevents hang-ups in corners and by steps and ladders for
Summary of the content on the page No. 7
3 Section 2 Installation ™ The following general information describes how to install the Prowler 720 and 730 robotic pool cleaners. ™ Carefully read the following so that you are fully aware of all the capabilities and features this Prowler cleaner has to offer. NOTE: Before installing this product, read and follow all warning notices and instructions starting on page ii. ™ Introducing your new Prowler Cleaner Dear Customer, Congratulations! You have purchased one of the best pool cleaners th
Summary of the content on the page No. 8
4 ™ Operating the Prowler 720 and 730 Cleaners WARNING — Your Cleaner should not be used while people are swimming in the pool. The cable can trip or entangle swimmers which could result in drowning. WARNING — Risk of electrical shock or electrocution. A Ground Fault Current Interrupter (GFCI-USA) or a Residual Current Device (RCD-EUROPE) must be installed to protect your electric outlet and to prevent any possible electrical shock. Failure to do so could create an electrical hazard which cou
Summary of the content on the page No. 9
5 ™ Operating the Prowler 720 and 730 Cleaners, cont’d. 1. Place the power supply, (transformer), at least ten feet / three meters from the pool as shown in Figure 2. The transformer will supply low voltage to the cleaner. 2. Uncoil the cable as shown in Figure 3. 3. For proper operation, lock the moveable handle diagonally across the top of the cleaner's body. Push down on the handle lock mechanism and slide the handle all the way to the end, (we recommend one slot Figure 2. before the end), th
Summary of the content on the page No. 10
6 Setting Up the Standard Power Supply (Transformer) To plug the cable into the transformer socket on the power supply, follow these steps: 1. Prepare the plug with the key and three outside slots as shown in Figure 9. 2. Fit the key and the slots Transformer from cable plug exactly Socket with the corresponding key and slots from the Transformer transformer socket. Socket 3. Push the plug all the way into the socket of the transformer. 4. Once the plug is in, rotate the plug to the right to Pus
Summary of the content on the page No. 11
7 ™ Wireless Remote Control - only for Prowler 730 cleaners equipped with Remote Control Using Radio Remote Control Feature and Accessing Cleaning Modes The Remote Control Model is equipped with a multi-directional radio transmitter, see Figure 12. This feature will enable you to guide the pool cleaner directly to areas of the pool requiring additional cleaning attention or for quick clean-ups. When you Forward / Reverse press the Right or Left buttons, the cleaner will turn until the button is
Summary of the content on the page No. 12
8 Replacing the Remote Control Battery 1. Remove the top screw (see Figure 13, Step 1). 2. Pull the top of the cover away from the transmitter and then pull upwards (Step 2). 3. Replace the battery and make sure the polarity is the same as the existing battery (Step 3). 4. Push the cover downwards into the 2 slots (Step 4). 5. Push the top of the cover towards the battery until it snaps into place (Step 5). 6. Put the screw back into place. Figure 13. ™ Prowler 720 and 730 Installation and
Summary of the content on the page No. 13
9 Section 3 Maintenance ™ Maintaining the Prowler 720 and 730 Cleaner Clean the Filter Bag after every Cleaning Cycle 1. Unplug the power supply. (Keep the plug away from contact with water.) 2. If the unit is in the pool, gently pull the cleaner toward you using the cable until the handle is within reach. Use the handle (not the cable) to pull the cleaner out of the pool after allowing most of the water to drain from the unit. 3. Lay the unit on its back on a smooth surface, (in order to preven
Summary of the content on the page No. 14
10 Changing the Drive Belts Depending on usage, the drive belts, (located behind the side plate), will stretch. When this happens, in order to maintain the optimum performance of the unit, these Figure 15. drive belts have to be changed. 1. Turn the robot upside down and remove the bottom lid assembly as shown on page 9, Figure 14, Steps 1-4. 2. Inside, locate four screws on drive motor side which hold the side plate in place, see Figure 15. 7b 3. Take out these four screws and remove the side p
Summary of the content on the page No. 15
11 Cable Care The cable may become twisted after a period of use. To correct this condition, simply lock the moveable handle on the top of the cleaner in the opposite diagonal direction. The pool cleaner will now travel in the opposite direction while cleaning your pool and the cable will uncoil. Check the cable periodically for external damage. If the problem persists, use the E-Z Swivel E-Z SWIVEL - Location device. Place the Robot on the ground and unplug the cable from the transformer. With
Summary of the content on the page No. 16
12 Section 4 Replacement Parts ™ Prowler 720 Model 2 4 11 35 34 10 46 8 1 9 5 6 7 33 20 42 15 17 31 3 16 14 12 13 32 40 30 22 26 23 24 29 21 41 47 25 20 28 27 18 45 44 43 19 39 36 38 37 ™ Prowler 720 and 730 Installation and User’s Guide
Summary of the content on the page No. 17
13 ™ Replacement Parts List for the Prowler 720 Model ITEM NO. PART NO. DESCRIPTION 1 P12100 4 PIN PLUG 2 P12101 CABLE ASSY. - INCLUDES P/N P12100, P12125 3 SEALING GROMMET 4 P12102 HANDLE ASSY. 5 PUSH BUTTON LOCK 6 P12103 SPRING 7 CLEVIS PIN 8 R PIN FOR HANDLE 9 SCREW FOR PUMP 10 OUTLET TOP 11 SCREW (OUTLET TOP) 12 P12104 LOCK TAB 13 SCREW 14 P12105 NUT 15 P12106 SCREW 16 P12107 SCREW 17 RUBBER VALVE 18 P12108 SIDE PLATE 19 P12122 TRIM PANEL 20 P12109 BUSHING 21 SMALL ROLLER
Summary of the content on the page No. 18
14 ™ Prowler 730 Model 4 2 11 15 34 10 43 8 9 1 5 6 7 41 33 45 15 44 17 32 16 12 14 3 31 13 30 22 39 25 23 29 21 40 24 46 20 28 26 27 18 42 19 38 35 37 36 ™ Prowler 720 and 730 Installation and User’s Guide
Summary of the content on the page No. 19
15 ™ Replacement Parts List for the Prowler 730 Model ITEM No. PART No. DESCRIPTION 1 P12100 4 PIN PLUG 2 P12126 CABLE ASSY. - INCLUDES P/N’s P12100, P12123 3 SEALING GROMMET 4 P12102 HANDLE ASSY. 5 PUSH BUTTON LOCK 6 P12103 SPRING 7 CLEVIS PIN 8 R PIN FOR HANDLE 9 SCREW FOR PUMP 10 OUTLET TOP 11 SCREW (OUTLET TOP) 12 P12104 LOCK TAB 13 SCREW 14 P12105 NUT 15 P12106 SCREW 16 P12107 SCREW 17 RUBBER VALVE 18 P12108 SIDE PLATE 19 P12122 TRIM PANEL 20 P12109 BUSHING 21 SMALL ROL
Summary of the content on the page No. 20
16 Notes ™ Prowler 720 and 730 Installation and User’s Guide
