Summary of the content on the page No. 1
.-......_-.®
Model ZS5300 User Guide
Multi Zone Selector
Summary of the content on the page No. 2
CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK) NO USER-SERVICEABLE PARTS INSIDE REFER SERVICING TO QUALIFIED SERVICE PERSONNEL The lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within
Summary of the content on the page No. 3
IMPORTANT SAFETY INSTRUCTIONS READ BEFORE OPERATING EQUIPMENT This product was designed and manufactured to meet strict 13.Power-Cord Protection - Power-supply cords should be quality and safety standards. There are, however, some routed so that they are not likely to be walked on or pinched installation and operation precautions which you should be by items placed upon or against them, paying particular particularly aware of. attention to cords at plugs, convenience receptacles, and the point w
Summary of the content on the page No. 4
16.Lightning - For added protection for this product during a lightning storm, or when it is left unattended and unused for long periods of time, unplug it from the wall outlet and disconnect the antenna or cable system. This will prevent damage to the product due to lightning and power-line surges. 17.Power Lines - An outside antenna system should not be located in the vicinity of overhead power lines or other electric light or power circuits, or where it can fall into such power lines or circu
Summary of the content on the page No. 5
Table of Contents Introduction 2 Features 2 About the keypad 3 Accessories 3 Functional Overview 4 Front panel 4 Rear panel 5 Remote control unit (RC5300ZS) 6 ID Code Setup 8 Preparation and Connection 9 Connecting speakers 9 Connection example 10 Operation Examples...................••.•.....•.........15 Remote Code List 16 Troubleshooting 17 Care and Maintenance 17 Specification 18 1
Summary of the content on the page No. 6
Introduction Features ZS5300 is a 2ch x 3 zones amplifier with Multi-Zonel Thank you for purchasing the Marantz ZS5300 Multi Zone Selector Amplifier. Source selector. This remarkable component has been engineered to provide you with many years of whole house audio • All channels identically designed, complete enjoyment. discrete construction class-O power amplifier. Please take a few minutes to read this manual To maximize sound performance, a large R-core thoroughly before you connect and opera
Summary of the content on the page No. 7
IAbout. the keypad ... Accessories You can connect the majority of keypads, IR receivers as well as some control related products available in • AC power cord x 1 the market. These are examples of systems that have been tested by Marantz America: .:. NILES Keypad : IntelliPad IR Main System unit : IRP6+ IR Sensor :MS2 IR Flasher : IRC-2 • Remote control unit x 1 _NILES® The Niles logo and IntelliPad are registered trademark of Niles Audio Corporation. •:. XANTECH Keypad :SMARTPAD3 Connecting blo
Summary of the content on the page No. 8
Functional Overview IFront panel 6 5 4 ~~""'''.roHE5B.ECTORI~ o ~II--~I 1 2 3 CD Main power switch (POWER ON I STANDBY) @ Standby indicator (STANDBY) This indicator lights up when any of the zones are in Press this button to turn the main power on. Press again to turn it off. When the main power is turned on, Zonei, standby. Zone1, Zone2 and Zone3 can be in standby Zone2 and Zone3 turn into standby mode and power for mode independently. Power for each zone can be each zone can be switched with t
Summary of the content on the page No. 9
IR~ar panel rn Audio input terminal (AUDIO IN) mStatus output terminal (STATUS OUT) Connect the analog audio output from your audio device These terminals are DC trigger output terminals to (CD player, TV, DVD player, etc.). Up to 3 audio devices determine whether power of a zone is on or off. can be connected. Connect these terminals to Keypads, etc. • Rating of status output: 12V 100mA. rn Audio output terminal (AUDIO OUT) These terminals are designed as an Audio pass through. II] Flasher inpu
Summary of the content on the page No. 10
8 DIRECT POWER button IRemote control unit (RC5300ZS) You can control power for each zone independently with these buttons. • ZONE 1 DIRECT ON button Turn the power on for Zone 1 independently. • ZONE 1 DIRECT OFF button Turn the power off for Zone 1 independently. • ZONE 2 DIRECT ON button Turn the power on for Zone 2 independently. • ZONE 2 DIRECT OFF button Turn the power off for Zone 2 independently. • ZONE 3 DIRECT ON button Turn the power on for Zone 3 independently. • ZONE 3 DIRECT OFF bu
Summary of the content on the page No. 11
2. Loading batteries .:. Using the remote control unit Batteries in this remote control unit have a life of approximately 1 year under normal operating 1. Remote control conditions. When the remote control unit is not to Operate the remote control unit (RC5300ZS) within a being used for an extended period of time, remove distance of approximately 16 feet (5m) from the IR the batteries. Also, when you notice that the batteries (remote control) window on the front of the unit. are starting to run
Summary of the content on the page No. 12
/0 Code Setup .:. Setting 10 code Ex.) Set to 10-1 Remote control unit Rear panel of the unit , SP, I @ ZONE' R , flDlOT'e COHTl'IOl. ID :) SELECTOR @w @ @ - 0 0 -I @©2.~ is " 1- @ Press and hold SET, then Press 10-1 and release both. Set to "1", The ZS5300 system can be expanded up to 3 units. When using 1 unit alone, set the 10 switch on the rear panel to "1", To set the remote control unit to the 10 number of the unit, follow the procedure below. 1. Press the SET button and hold it, then pres
Summary of the content on the page No. 13
Preparation and Connection .:. Before making connections Be sure to turn the power off for the ZS5300 and other products to be connected to ZS5300 before making connections. Please refer the instruction manuals for other products to make sure of the proper connections and terminals. •:. Keypad The keypads that can be connected to the unit are keypads and connecting boxes made by NILES and XANTECH shown below. If you want to use products that are not in the list below or made by other manufacture
Summary of the content on the page No. 14
I Connection example .:. NILES system Remote IR Data Status Flasher To cascade connection Analog Speaker ZS5300 : I , .. ----- ---------------- --- ..~~l~~:::;.========:'l , , : ~~!~!~!~I~lwg ® , 12 ~ ~I~ ~ ~1i2 ~ ~1i2 ~ ~112 ~ ~112 ~ ~ v 0 T V 0 T V 0 T V 0 T V 0 T V 0 T A A A A A A · , Set8JR INPUTS-------' · · · , · _NILES l\ __~~ _ MODB. IAP6+ r flASHER lEVEL---, IR --- .. ::11~::~::~~ : ':-----------------...... I :'r::::--------='" o o DC power supply ~~~ .r~~K _~LES plugged into an ~--~
Summary of the content on the page No. 15
.:. XANTECH system Remote IR Data Status Flasher To cascade connection Analog Speaker Z85300 Speaker L R ---- -;------ ---6'l a c: PM110 I SMART PAD!" ' ~~ PROGRAMMABLE MODULE i 0 0 789-44 ;.,~ 480-30 series ' IR Receivers CONNECTING BLOCK I 0 0 ~~~!~:~ @ @ ~~l~, White stripe ... 0 U) 0 :::> L'~;~RR+ L'~":~RR. 1 ..~_.?_~~.. 1 '\ ~~~ ..~_ > Q t:c z N IR ___ L __ INPUT OUTPUT fi lit .............. GND I \ 0 0 t3~g; .. RCVR ... .. - ': 7-1001 ribbon cabte with - ' : ~ 'mini plug removed , I , ~ ~'7
Summary of the content on the page No. 16
.:. Cascade connection Note: To change the positions of the EXT./INT. switch and the ID switch, turn off the main power switch of the ZS5300. When the main power switch is on, changing the positions do not affect. ZS5300 (Master) ZS5300 (Slave) EXT. INT. 123 Set to EXT Set to 2 00 ~ ~ + "- --- Remote CD Player --Analog MARANTZ '---' "- DVD Player MARANTZ '---' "- ~ Analog '@ out Tuner MARANTZ '---' ! /~----·I----~ "- @ @ @ ! 1 Analog @ @ @ l 1 out 2 3 4 HOD Player -- -T~ Remote MARANTZ ""--' '--
Summary of the content on the page No. 17
.:. Connection with the DH9300 Z85300 [ "=,-;,-='-1"·;~ !~1:j~I~ ~~ --- Remote --Analog -- Speaker - - - - - - - Video o Zone-1 Speaker Zone-2 ,-----------------------------, TV Zone-3 Speaker ,,-----------------~------------------------------ , I ,--------------, l _ _ _ _ _ j-.J -':"-_-~-_-:':""- ..-"'''''''''''''''''''''''''''''''''''''''''''''''' --- .. DH9300 : :: I ~..;..;:;..,,;:....::..;;'-----------:-:-: 1 -------...... I • f OUT' 1II11Oft101 0' '0 ~.;~,;~.; @. @. @, ~~ o' '0 @j @j @j @
Summary of the content on the page No. 18
.:. Connecting external power amplifier When using speakers which might need high power to drive (ex. some outdoor speakers), you might need more power than the ZS5300 can provide. If you need more power, you can connect the "ZONE 3 PRE OUT" to an external power amplifier. Sound level can be adjusted with Volume Up/Down on ZS5300. Power amplifier Power amplifier I ,---+.....,@- @-: @ @ @= @- @= -~. Z85300 MA61 00 MA6100 Outdoor speaker Outdoor speaker .:. Connecting power cord When all the conne
Summary of the content on the page No. 19
Operation Examples .:. Refer to connection example "NILES system II(~ P.10) - .__------------- ZONE 1 Main room 1. 2. 1. light up --- o 0 o .----.0 , t 3 • 5 • ~~----' ~. "@ J) 6. light up -I 3. light up 4. flash 1. 4. 1. 6. 1. Press the CD button on the keypad. The power of ZS5300's Zone 1 is turned on and the input source is switched to Input 3. Pressing the POWER button on the keypad also turns on the power. 2. Press the PLAY button on the keypad. CD player begins to play. 3. Press the VOLUME
Summary of the content on the page No. 20
Remote Code List .:. Remote code list (RC-S extension) Power ON/OFF 161210 161210 161210 Global control code Power ON 161211 161211 161211 Global control code Power OFF 161212 161212 161212 Global control code Volume up 161600 161600 161600 Global control code Volume down 161700 161700 161700 Global control code Mute 161319 161319 161319 Global control code INPUT 1 160039 160039 160039 Global control code INPUT 2 160049 160049 160049 Global control code INPUT 3 160059 160059 160059 Global contro
