Summary of the content on the page No. 1
COMPACT COMPONENT SYSTEM
CA-MXJ970V/CA-MXJ980V
CA-MXJ970V CA-MXJ980V
COMPACT COMPACT
COMPACT
SUPER VIDEO
DIGITAL VIDEO
DIGITAL AUDIO
INSTRUCTIONS
For Customer Use:
Enter below the Model No. and Serial
No. which are located either on the rear,
bottom or side of the cabinet. Retain this
information for future reference.
Model No.
Serial No.
GVT0047-001A
[ US, UT, UX ]
MXJ970[U]Cover 1 16/06/2000, 11:23 AM
Summary of the content on the page No. 2
Warnings, Cautions and Others Avisos, precauciones y otras notas Advertências, precauções e outras notas Caution –– switch! Disconnect the mains plug to shut the power off completely. The switch in any position does not disconnect the mains line. The power can be remote controlled. Precaución –– Interruptor ! Desconectar el cable de alimentación para desactivar la alimentación totalmente. Cualquier que sea la posición de ajuste del interruptor , la alimentación no es cortada completamente. La
Summary of the content on the page No. 3
CAUTION To reduce the risk of electrical shocks, fire, etc.: 1. Do not remove screws, covers or cabinet. 2. Do not expose this appliance to rain or moisture. PRECAUCIÓN Para reducir riesgos de choques eléctricos, incendio, etc.: 1. No extraiga los tornillos, los cubiertas ni la caja. 2. No exponga este aparato a la lluvia o a la humedad. PRECAUÇÃO Para reduzir riscos de choques elétricos, incêndio, etc.: 1. Não remova parafusos e tampas ou desmonte a caixa. 2. Não exponha este aparelho à chuva n
Summary of the content on the page No. 4
Caution: Proper Ventilation To avoid risk of electric shock and fire, and to prevent damage, locate the apparatus as follows: 1 Front: No obstructions and open spacing. 2 Sides/ Top/ Back: No obstructions should be placed in the areas shown by the dimensions below. 3 Bottom: Place on a level surface. Maintain an adequate air path for ventilation by placing on a stand with a height of 10 cm or more. Precaución: el aparato debe estar bien ventilado Para evitar posibles riesgos de descargas eléctri
Summary of the content on the page No. 5
IMPORTANT FOR LASER PRODUCTS / IMPORTANTE PARA PRODUCTOS LÁSER / IMPOTANTE PARA PRODUTOS LASER / / REPRODUCTION OF LABELS / REPRODUCCIÓN DE ETIQUETAS / REPRODUÇÃO DE ETIQUETAS / 2 WARNING LABEL, PLACED INSIDE THE UNIT 1 CLASSIFICATION LABEL, PLACED ON REAR ENCLOSURE 2 ETIQUETA DE ADVERTENCIA, PEGADA EN EL 1 ETIQUETA DE CLASIFICACIÓN, PEGADA EN LA PARTE POSTE- INTERIOR DE LA UNIDAD RIOR DE LA CAJA 2 ETIQUETA DE ADVERTÊNCIA LOCALIZADA NA PARTE 1 ETIQUETA DE CLASSIFICAÇÃO L
Summary of the content on the page No. 6
Introduction We would like to thank you for purchasing one of our JVC products. Before operating this unit, read this manual carefully and thoroughly to obtain the best possible performance from your unit, and retain this manual for future reference. Power sources About This Manual • When unplugging from the wall outlet, always pull the This manual is organized as follows: plug, not the AC power cord. • The manual mainly explains operations using the DO NOT handle the AC power cord with wet hand
Summary of the content on the page No. 7
Contents Location of the Buttons and Controls ......................................3 Front Panel ................................................................................. 3 Remote Control .......................................................................... 5 Getting Started...........................................................................6 Unpacking .................................................................................. 6 Putting the Batteries into the Remote C
Summary of the content on the page No. 8
Location of the Buttons and Controls Become familiar with the buttons and controls on your unit. Front Panel z Powered Rolling Panel a x s c PREV NEXT d v f b g n Press PANEL OPEN/ PBC MPX – VCD NUMBER + h m CLOSE to open the panel. j To close the panel, press , the button again. k . l P / Front Panel 1 w 2 e 3 4 r 5 t 6 7 y u 8 i 9 p o ; q – 3 – EN01-12.MX-J970[U] 3 16/06/2000, 11:17 AM English
Summary of the content on the page No. 9
Continued Display Window 13 2 45 67 1 2 3 p q 8 9 w See pages in the parentheses for details. h CD REC START button (22, 23) j TAPE A/B button (20) k PBC (Playback Control) button (17) Front Panel l MPX button (19, 24) 1 Disc trays / SET button (9, 12, 26 – 28) 2 (Standby/On) button and STANDBY lamp (9) z7 (stop) button (13 – 23) 3 Display window x TUNING – / + buttons (12) 4 SUBWOOFER VOLUME control (10) 1 / ¡ (fast left/fast right) buttons (11, 14, 20) 5 Remote sensor c SEA CONTROL button (11)
Summary of the content on the page No. 10
Remote Control Remote Control 1 Disc number buttons (CD1, CD2, and CD3) (13) Pressing one of these buttons also turns on the unit. 2 SOUND MODE button (10) 3 VOCAL MASKING button (24) 4 Number buttons (12, 14, 19) t 1 5 ON SCREEN button (18) 2 y 6 V.INTRO button (18) 3 u 7 KEY CONTROL I button (25) 8 KEY CONTROL i button (25) 9 REC START/STOP button (21, 23) 4 p TAPE A/B button (20) i q PREV 1 / 4 (fast left/reverse search) button (14, 15, o 17, 20) 5 ; w SUBWOOFER + / – buttons (10) 6 a e CD £
Summary of the content on the page No. 11
Continued Getting Started Unpacking Connecting Antennas After unpacking, check to be sure that you have all the FM antenna following items. The numbers in the parentheses indicate the quantity of the pieces supplied. FM antenna (supplied) • AM loop antenna (1) • FM antenna (1) • Remote control (1) • Batteries (2) • AC plug adaptor (1) • Video cord (1) If any is missing, consult your dealer immediately. 1 Attach the FM antenna to the FM 75 Ω Putting the Batteries into the Remote Control COAXIAL t
Summary of the content on the page No. 12
AM antenna Connecting Speakers 1 2 3 2, 3 1 Vinyl-covered wire ANTENNA (not supplied) Blue AM EXT AM LOOP Speaker Speaker cord cord (blue/black) (blue/black) FM 75 COAXIAL Red Black AM loop antenna (supplied) Black 1 Connect the AM loop antenna to the AM Speaker cord LOOP terminals as illustrated. (red/black) 2 Turn the AM loop antenna until you have the best reception. To connect an outdoor AM antenna When reception is poor, connect a single vinyl-covered wire To right To left to the AM EXT ter
Summary of the content on the page No. 13
To connect a TV set Connecting Other Equipment You can connect a TV with a video input jack: used as a You can connect both analog and digital equipment. monitor for video CD playback. • DO NOT connect any equipment while the power Auxiliary Equipment is on. ANTENNA AM EXT AM LOOP TV • DO NOT plug in any equipment until all FM 75 COAXIAL VIDEO OUT connections are complete. VIDEO CD OPTICAL DIGITAL OUT OUTPUT AUX RIGHT LEFT IN OUT To video input MAIN SPEAKERS To connect an analog component CAUTI
Summary of the content on the page No. 14
Common Operations To check the clock time Turning On and Off the Power Press DISPLAY while playing any source. To turn on the unit, press so that the • Each time you press the button, the source STANDBY lamp goes off. indication and the clock time alternate on the display. The Powered Rolling Panel opens automatically. To adjust the clock again If you have adjusted the clock before, you need to press To turn off the unit (on standby), press CLOCK/TIMER repeatedly until the clock setting mode i
Summary of the content on the page No. 15
Continued Adjusting the Volume Reinforcing the Bass Sound You can adjust the volume level only while the unit is turned The SUBWOOFER VOLUME control provided for this unit on. can enhance the subwoofer sound if subwoofers are connected to the rear of this unit (see page 7). Turn the VOLUME control clockwise to This function only affects the playback sound, but does not increase the volume or counterclockwise affect your recording. to decrease it. • The volume level can be adjusted in 32 Turn the
Summary of the content on the page No. 16
Surround modes *: 2 Adjust the SEA pattern. D.CLUB: Increases resonance and bass. HALL: Adds depth and brilliance to the sound. 1) Press 4 or ¢ to select STADIUM: Adds clarity and spreads the sound, like in an the frequency range to outdoor stadium. adjust (LOW, MID, HIGH). SEA (Sound Effect Amplifier) modes: 2) Press 1 or ¡ to adjust the ROCK: Boosts low and high frequency. Good for level (–3 to +3) of the selected acoustic music. frequency range. POP: Good for vocal music. CLASSIC: Good for cl
Summary of the content on the page No. 17
Listening to FM and AM Broadcasts Tuning in a Station On the unit ONLY: 1 Tune in the station you want to preset. 1 Press FM/AM. • See “Tuning in a Station.” The unit automatically turns on and tunes in the previously tuned station (either FM or MHz AM). The Powered Rolling Panel automatically opens. 2 Press SET. • Each time you press the button, the band alternates between FM and AM. 2 Start searching for stations. On the unit: 3 Press PRESET – / + to select a Press and hold TUNING – / + for pr
Summary of the content on the page No. 18
Playing Back Audio CDs Loading CDs Playing Back Several Discs — Continuous Play You can play CDs continuously. On the unit ONLY: 1 Load CDs. 1 Press 0 for the disc tray (CD1 to 3) 3 you want to load a CD onto. 2 Press one of the disc number The unit automatically turns on and the disc buttons (CD1, CD2, and CD3) for 2 tray slides out. The Powered Rolling Panel the disc you want to start play also opens automatically. 1 from. CD play starts from the first track of the 2 Place a disc correctly in
Summary of the content on the page No. 19
Continued • Each time you press the button, CD play mode changes To locate a particular point in a track as follows: During play, press and hold 1 or ¡. •1: Fast reverses the disc. Random Play Program Play •¡: Fast forwards the disc. Continuous Play When using the remote control, press and 3 hold 1 / 4 or ¢ / ¡. 3 Press one of the disc number buttons (CD1, CD2, and CD3) to 2 To go to another track select the disc number you want to 1 Press 4 or ¢ repeatedly before or play. during playback. Track
Summary of the content on the page No. 20
To stop during play, press 7 . To check the program contents • Random play also stops when one of the disc trays is Before playing, you can check the program opened. contents by pressing 1 / 4 or ¢ / ¡ on the remote control. To exit from Random play mode, press PROGRAM/ •¢ / ¡: Shows the programmed tracks RANDOM repeatedly again before or after play so that the in the programmed order. unit enters another play mode. •1 / 4: Shows them in the reverse order. Even if you press 4 (or 1 / 4 on the re
