Summary of the content on the page No. 1
MICRO COMPONENT SYSTEM
—Consists of CA-UXH9 and SP-UXH9
UX-H9
TIMER
TIMER SET ON/OFF STANDBY/ON
INTRO
/RDS SEARCH RANDOM SLEEP
STANDBY/ON
REMAIN REPEAT
/RDS MODE PROGRAM ST/MONO
VOLUME
TAPE TUNER CD
/BAND
CD
BEAT CUT
STANDBY
MICRO COMPONENT SYSTEM
UX-H9
DISPLAY
/CLOCK SET
SOUND VOLUME
MUTING /BASS
RM-SUXH9R REMOTE CONTROL
CD SYNCHRO RECORDING
OPEN
INSTRUCTIONS
LVT1115-003B
[B]
COVER_UX-H9[B]ff.p65 1 03.9.26, 9:10 AM
Summary of the content on the page No. 2
Warnings, Cautions and Others IMPORTANT FOR LASER PRODUCTS IMPORTANT for the U.K. DO NOT cut off the mains plug from this equipment. If the plug REPRODUCTION OF LABELS fitted is not suitable for the power points in your home or the cable is too short to reach a power point, then obtain an appro- 1 CLASSIFICATION LABEL ON EXTERIOR SURFACE priate safety approved extension lead or consult your dealer. BE SURE to replace the fuse only with an identical approved type, as originally fitted. CLASS
Summary of the content on the page No. 3
SAFETY INSTRUCTIONS “SOME DOS AND DON’TS ON THE SAFE USE OF EQUIPMENT” This equipment has been designed and manufactured to meet international safety standards but, like any electrical equipment, care must be taken if you are to obtain the best results and safety is to be assured. ✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮ Do read the operating instructions before you attempt to use the equipment. Do ensure that all electrical connections (including the mains plug, extension leads and inter
Summary of the content on the page No. 4
Introduction We would like to thank you for purchasing one of our JVC products. Before operating this unit, read this manual carefully and thoroughly to obtain the best possible performance from your unit, and retain this manual for future reference. Power sources About This Manual • When unplugging the unit from the wall outlet, always pull This manual is organized as follows: on the plug, not the AC power cord. • This manual mainly explains operations using the DO NOT handle the AC power cord
Summary of the content on the page No. 5
Contents Location of the Buttons and Controls ............................. 3 Main unit ................................................................................... 3 Remote Control ......................................................................... 5 Getting Started .................................................................. 6 Unpacking ................................................................................. 6 Putting the Batteries into the Remote Control ..........
Summary of the content on the page No. 6
Location of the Buttons and Controls Become familiar with the buttons and controls on your unit. Main Unit Top view 1 OPEN 5 6 TIMER ON/OFF BAND MULTI SOUND 2 CONTROL /BASS TAPE TUNER CD 7 PHONES CD CONTROL 3 4 8 Front view 9 STANDBY/ON VOLUME p e STANDBY MICRO COMPONENT SYSTEM q r w CD SYNCHRO RECORDING OPEN t Inside the front cover y 3 EN01-05_UX-H9[B]f.p65 3 03.6.23, 11:40 AM
Summary of the content on the page No. 7
Continued Display window on the front panel 12 3 4 56 7 8 ON OFF SLEEP ST MONO SOUND BASS CD SYNC MHz kHz 1ALL PROG RANDOM INTRO TOTAL REMAIN 9 p q w e r t See pages in parentheses for details. Main unit Display window 1 Disc cover (13) 1 (timer) indicator 2 PHONES jack (9) 2 ON/OFF (timer on-time/off-time) indicators 3 TIMER ON/OFF button (20) 3 SLEEP indicator 4 SOUND/BASS button (9) 4 FM mode indicators 50 OPEN (disc cover open) (13, 14) • ST (stereo), MONO 6 Source buttons 5 SOUND indicator
Summary of the content on the page No. 8
Remote Control See pages in parentheses for details. 1 TIMER SET button (19, 20) 2 INTRO/RDS SEARCH button (12, 15) 3 RANDOM button (15) 4 REMAIN/RDS MODE button (12, 15) 5 BEAT CUT button (10, 17) 6 DISPLAY/CLOCK SET button (8) TIMER TIMER SET ON/OFF STANDBY/ON 7 MUTING button (9) 9 1 8 SOUND/BASS button (9) INTRO p 9 STANDBY/ON button (8, 20) /RDS SEARCH RANDOM SLEEP 2 q p TIMER ON/OFF button (20) 3 w REMAIN REPEAT q SLEEP button (20) /RDS MODE PROGRAM ST/MONO w PROGRAM button (8, 11, 14, 19,
Summary of the content on the page No. 9
Getting Started Continued Connections Unpacking After unpacking, check to be sure that you have all the To connect speakers following items. You can connect the speakers using the speaker cords. The number in parentheses indicates the quantity of each piece supplied. • AM (MW) loop antenna (1) 1 2,3 • Remote control (1) • Batteries (2) If any item is missing, consult your dealer immediately. Putting the Batteries into the Remote Control SPEAKER IMPEDANCE 4-16Ω Insert the batteries—R03(UM-4)/A
Summary of the content on the page No. 10
FM ANTENNA AM LOOP To connect AM (MW) and FM antennas NOW you are ready to plug in the unit. IMPORTANT: 2 Be sure to check that all connections have been made FM antenna before plugging in the power cord. 1 AM (MW) loop antenna (supplied) 1 Connect the supplied AM (MW) loop antenna to the AM LOOP terminal. Place the antenna away from the unit and adjust its position for the best reception. 2 Adjust the position for the FM antenna for the best reception. For better reception of both FM and AM (M
Summary of the content on the page No. 11
Basic and Common Operations Continued To show the clock when the unit is turned on Setting the Clock On the remote control ONLY: Before operating the unit any further, first set the unit’s clock. DISPLAY When you plug in the power cord, “0:00” starts flashing on Press DISPLAY/CLOCK SET. /CLOCK SET the display. • Each time you press the button, the display You can set the clock when the unit is either turned on or in changes the clock indication and the normal standby mode. indication alternatel
Summary of the content on the page No. 12
Adjusting the Volume Selecting the Sound Modes You can adjust the volume level only while the unit is turned You can select one of the 4 sound modes. on. The volume level can be adjusted between “VOL MIN,” • This function also affects the sound from headphones. “VOL 1” – “VOL 39,” and “VOL MAX.” • This function only affects the playback sound, and does not • The volume level has no effect on recording. affect your recording. SOUND To increase the volume, press VOLUME +. To select the sound modes
Summary of the content on the page No. 13
Listening to FM and AM (MW) Broadcasts To change the FM reception mode Tuning in to a Station On the remote control ONLY: REPEAT TUNER When an FM stereo broadcast is hard to receive 1 Press TUNER/BAND to select either ST/MONO /BAND or noisy, press REPEAT ST/MONO so that the “FM” or “AM.” MONO indicator lights up on the display. The unit automatically turns on and tunes in to Reception will improve. the previously received station—either FM or AM (MW). To restore the stereo effect, press REPEAT S
Summary of the content on the page No. 14
Presetting Stations Tuning in to a Preset Station You can preset 20 FM and 20 AM (MW) stations manually. On the remote control ONLY: In some cases, test frequencies have been already stored TUNER 1 Press TUNER/BAND to select either /BAND for the tuner since the factory examined the tuner preset “FM” or “AM.” function before shipment. This is not a malfunction. You The unit automatically turns on and tunes in to can preset the stations you want into memory by following the previously received sta
Summary of the content on the page No. 15
Receiving FM Stations with RDS RDS (Radio Data System) allows FM stations to send an On the remote control ONLY: additional signal along with their regular program signals. INTRO For example, the stations send their station names, as well as 1 Press INTRO/RDS SEARCH until /RDS SEARCH information about what type of program they broadcast, such the PTY code you want appears on as sports or music, etc. the display. When tuned in to an FM station which provides the RDS • Each time you press the butt
Summary of the content on the page No. 16
Playing Back Discs This unit has been designed to play back the following 4 Press CD. CD discs—CD, CD-R, and CD-RW. The unit automatically turns on and the source changes to the CD player. When playing a CD-R or CD-RW After loading the disc, total track number and User-edited CD-Rs (CD-Recordable) and CD-RWs (CD- total playing time appear on the display. ReWritable) can be played only if they are already “finalized.” Total track number Total playing time • Usually you can play back your original
Summary of the content on the page No. 17
Continued Basic Disc Operations 3 Press ¢ or 4 to select the track number, then While playing a disc, you can do the following operations. press PROGRAM. To stop playing for a moment Track number Program step number CD During play, press CD 3/8. While pausing, the elapsed playing time flashes on PROGRAM the display. To resume playing, press CD 3/8 again. 4 Repeat step 3 to program other tracks you To go to another track want. Before or during play, press ¢ or 4 repeatedly. CD 5 Press CD 3/8. •¢
Summary of the content on the page No. 18
Playing at Random—Random Play Playing only Introductions—Intro Play You can play the tracks at random. You can play only the introductions of the tracks. On the remote control ONLY: On the remote control ONLY: RANDOM INTRO Press RANDOM before or during Press INTRO/RDS SEARCH. /RDS SEARCH The INTRO indicator lights up and the first 10- playing. second portion of each track is played back in The RANDOM indicator lights up on the display. order. RANDOM To exit from Random Play, press RANDOM again.
Summary of the content on the page No. 19
Playing Back Tapes For Tape operations, use buttons inside the front cover on the 4 Close the cassette holder gently. unit. Playing Back a Tape You can play back type I tapes only. On the unit ONLY: 1 Open the front cover. 5 Press TAPE. TAPE The unit automatically turns on and the source changes to the tape deck. • You can select to the tape by pressing TAPE on the remote control. 6 Press # (play). The tape starts playing. • When the end of the tape is reached, playing 2 Press &/) (stop/cassette
Summary of the content on the page No. 20
Recording IMPORTANT: Recording from the Radio • It should be noted that it may be unlawful to re-record pre-recorded tapes, records, or discs without the consent of the owner of copyright in the sound or video On the unit ONLY: recording, broadcast or cable program and in any literary, dramatic, musical, or artistic embodied 1 Put a recordable cassette in with the exposed therein. part of the tape down. • The recording level is automatically set correctly, so it is • See also page 16. not affect
