Extron electronic s100 user manual

Summary of the content on the page No. 1

UTS 100 Series • Setup Guide
The Extron UTS 100 and UTS 150 under-table shelf system accommodates half-rack,
quarter-rack, and eighth-rack products in a half-rack width installation. The shelves can
accommodate a single device or combinations of smaller devices.
Included Parts
UTS 100 (70-1028-01) UTS 150 (70-1028-02)
(8) #4-40 x 3/16 inch product mounting screw (8) #4-40 x 3/16 inch product mounting screw
(4) #8 x 1/2 inch shelf mounting screw (2) #8-32 Thumbnut
Step 1 — Mount Devices on the

Summary of the content on the page No. 2

2. Drill four pilot holes, each 3/32 inch (2.38 mm) in diameter, at the marked locations. ATTENTION: Be careful not to drill through the table. If the table is too thin or of a different material for the supplied screws, use an appropriate type and length. 3. Secure the shelf, using the four provided #8 x 1/2 inch mounting screws (see image at right). Step 3 — Install the UTS 150 (Secondary Shelf) 1. Insert the hooks of the UTS 150 into the front posts and rear studs of the top adjacent s