Summary of the content on the page No. 1
OPERATING INSTRUCTIONS
En (English)
CD Stereo System
XR-EC10
MANUAL DE INSTRUCCIONES
E (Español)
XR-EC12
U C
MODE D'EMPLOI
F (Français)
Owner’s record
For your convenience, record the model number and serial
number (you will find them on the rear of your set) in the space
provided below. Please refer to them when you contact your
Aiwa dealer in case of difficulty.
Model No. Serial No. (Lot No.)
For assistance and information
(United States and Puerto Rico)
8C-CL3-903-01
020301ASW-H-M
00_FCV_XREC
Summary of the content on the page No. 2
WARNING IMPORTANT SAFETY INSTRUCTIONS To reduce the risk of fire or electric shock, do not expose this appliance to rain or moisture. Read the Operating Instructions carefully and completely before Ventilation - The unit should be situated with adequate space operating the unit. Be sure to keep the Operating Instructions for around it so that proper heat ventilation is assured. Allow 10 cm future reference. All warnings and cautions in the Operating clearance from the rear and the top of the un
Summary of the content on the page No. 3
TABLE OF CONTENTS IMPORTANT SAFETY INSTRUCTIONS ......... 2 Outdoor Antenna Lightning PREPARATIONS ................................... 4 Power lines - An outside antenna system should not be located For added protection for this unit receiver during a lightning storm, PARTS AND CONTROLS ......................... 5 in the vicinity of overhead power lines or other electric light or power or when it is left unattended and unused for long periods of time, ADJUSTMENTS BEFORE OPERATION .......... 7 ci
Summary of the content on the page No. 4
PREPARATIONS Before starting connection, check that the protective 3 Connect the supplied antennas. Remote control tag has been taken off (see page 3). Connect the FM antenna to the FM 75 terminals and Detach the battery compartment lid at the rear of the remote the AM antenna to the AM LOOP jack. Connect the FM control and insert two R6 (size AA) batteries with correct antenna to the FM 75 terminals without the 2 mark, Connection polarity. as illustrated. Plug in the AC power cord to the AC o
Summary of the content on the page No. 5
PARTS AND CONTROLS 9 AM LOOP jack and FM 75 terminal Main unit Plug in the supplied AM and FM antennas. 0 LINE IN jacks 5 9 Accept analog sound signals from external equipment. 1 Connect external equipment using an optional connecting 0 cable with RCA phono plugs (red plug to R jack, white 2 6 ! $ plug to L jack). Refer also to the operating instructions @ En for your equipment. 7 # To switch function to external input, press AUX. 3 8 To change a source name in the display of the % AUX function
Summary of the content on the page No. 6
The numbered buttons take on these functions when pressed with 8 FUNCTION Remote control SHIFT held down: Switches the active function among TUNER, AUX and CD. CLOCK Selects clock mode. 9 PRESET +, - 1 8 TUNER MODE 0 DISC DIRECT PLAY 1, 2, 3 2 Switches between stereo or monaural FM reception. !f/r, t/g En 3 RANDOM/REPEAT @ VOLUME +, - Selects random or repeat CD playback mode. 3 9 # TIMER PROGRAM 4 0 Selects timer mode. Selects programmed CD playback mode. 5 ! SLEEP 4ECD @ 6 Selects sleep-timer
Summary of the content on the page No. 7
ADJUSTMENTS BEFORE OPERATION When operating while the power is on 1 Press ECO/DIMMER once and press SET. POWER 2 Within 6 seconds, press f or g to select the desired mode and press SET. POWER CD 6STANDBY/ON DISC DIRECT Standby power consumption CD,AUX f,g PLAY ECO ON: 0.6 W TUNER/BAND En ECO OFF: 16 W f,g SET DISC DIRECT PLAY Dimmer SET TUNER/ The display window brightness can be adjusted to the following BAND,AUX four levels: "DIM OFF", "DIMMER 1", "DIMMER 2", and "DIMMER 3". "DIM OFF" i
Summary of the content on the page No. 8
CD OPERATIONS Replacing disc during play While one disc is playing, the other discs can be replaced without interrupting play. 1Press one of zOPEN/CLOSE (CD1/CD2/CD3) corresponding to the disc which is not being played. 0–10, +10 s RANDOM/ 2 Remove the disc and replace with another one. E E REPEAT 3 Close the disc tray. f,g s En To stop play PROGRAM DISC DIRECT zOPEN/ Press s. PLAY CLOSE DISPLAY DISPLAY DISC DIRECT f,g To pause play PLAY SHIFT Press E. Press again to resume play. To skip
Summary of the content on the page No. 9
To check the program Random/Repeat play Programmed play Press f or g repeatedly in stop mode. The track In random play mode the unit plays all the tracks in random Up to 30 tracks can be programmed from any of the loaded number and program number are displayed in succession. order. In repeat play mode it plays repeatedly all the discs or discs. To clear the program the track being played. You can select random and repeat all 1 Press PROGRAM on the remote control in stop play at the same time. P
Summary of the content on the page No. 10
RADIO OPERATIONS Tuning in preset stations TUNER MODE 1 Select the band. 2 Press PRESET (PRESET +,- on the remote control) repeatedly. 0–10, +10 POWER s With each press, the station with the succeeding (or preceding) preset number is tuned in. s PRESET +,- f,g En You can tune in the desired preset station directly by TUNER/BAND PRESET pressing the numbered buttons on the remote control. SET f,g -To select preset number 11, press +10 and 1. SHIFT -To select preset number 15, press +10 and 5. SET
Summary of the content on the page No. 11
SOUND ADJUSTMENTS Adjustments BASS, To switch to monaural FM reception TREBLE Hold down SHIFT and press TUNER MODE on the remote control so that "MONO" is displayed. VOLUME To cancel, repeat the above so that “STEREO” is displayed. Tip: En When FM stereo reception is poor, switching to monaural TONE reduces noise. f,g VOLUME +,- To switch the AM tuning interval The default setting of the AM tuning interval is 10 kHz/step. If you use this unit in an area where the frequency allocation system is
Summary of the content on the page No. 12
TIMER OPERATIONS Sleep timer POWER Turns off the unit automatically after a specified time. VOLUME 1 Press SLEEP on the remote control. CLOCK "SLEEP" is displayed. POWER s TUNER/BAND, 6STANDBY/ON 2 Within 6 seconds, press f or g repeatedly ECD AUX, ECD, to set the sleep timer duration. DISC DIRECT En s PLAY With each press, the timer duration changes in 5-minute f,g f,g SET steps between 5 to 240 minutes. If there is no button input DISC DIRECT TIMER VOLUME+/- for 6 seconds, the current
Summary of the content on the page No. 13
7 Prepare the source. To check the timer setting Timer playback To play CD, load a disc. The currently selected disc is Press TIMER on the remote control so that "5 PLAY" Turns on the unit at a specified time for the specified duration. played. If you want to play a CD on another tray, play the appears on the display. Make sure the clock is set correctly. desired CD, and then stop play. After 6 seconds, the timer-on time, the source and the timer- To play the radio, select the band and tune in t
Summary of the content on the page No. 14
REFERENCE Erroneous display When transporting the unit with packing materials Care and maintenance •Reset the unit. (See "Resetting the unit".) When transporting the unit using the packing materials, for Occasional care and maintenance of the unit and the software example, when asking for repair, be sure to re-attach the Poor radio reception are needed to optimize the performance of your unit. protective tag, which was attached when you purchased the •Check antenna connection. Adjust the antenna
Summary of the content on the page No. 15
GENERAL COPYRIGHT Specifications Power requirements 120 V AC, 60 Hz Check copyright laws relevant to recordings from discs or radio MAIN UNIT CX-LEC10, CX-LEC12 Power consumption 50 W for the country where the unit is to be used. TUNER Power consumption in standby mode FM tuning range 87.5 MHz to 108 MHz With ECO mode on: 0.6 W With ECO mode off: 16 W FM usable sensitivity (IHF) 13.2 dBf Dimensions (W × H × D) 218.5 × 169 × 318 mm FM antenna terminal 75 ohms (unbalanced) 5 3 5 AM tuning range 53
Summary of the content on the page No. 16
NOTE REMARQUE CAUTION This equipment has been tested and found to comply with the Cet appareil a été testé et jugé conforme aux limites des TO PREVENT ELECTRIC SHOCK DO NOT USE THIS (POLARIZED) PLUG WITH AN EXTENSION CORD, limits for a Class B digital device, pursuant to Part 15 of the appareils numériques de Classe B, conformément à la Partie RECEPTACLE OR OTHER OUTLET UNLESS THE BLADES CAN FCC Rules. These limits are designed to provide reasonable 15 des Règles FCC. Ces limites sont conçues po
