Summary of the content on the page No. 1
UCA
RX-V395
NATURAL SOUND AV RECEIVER
AMPLI-TUNER AUDIO-VIDEO
OWNER’S MANUAL
MODE D’EMPLOI
Summary of the content on the page No. 2
SAFETY INSTRUCTIONS 8. Ventilation – The unit should be situated so that its location CAUTION or position does not interfere with its proper ventilation. RISK OF ELECTRIC SHOCK For example, the unit should not be situated on a bed, DO NOT OPEN sofa, rug, or similar surface, that may block the ventilation openings; or placed in a built-in installation, such as a bookcase or cabinet that may impede the flow of air CAUTION: TO REDUCE THE RISK OF through the ventilation openings. ELECTRIC SHOCK, DO
Summary of the content on the page No. 3
English EXAMPLE OF ANTENNA GROUNDING 19. For US customers only: Outdoor Antenna Grounding – If an outside antenna is connected to this unit, be sure the antenna system is grounded so as to provide some protection against voltage MAST ANTENNA surges and built-up static charges. Article 810 of the LEAD IN WIRE National Electrical Code, ANSI/NFPA 70, provides information with regard to proper grounding of the mast GROUND CLAMP and supporting structure, grounding of the lead-in wire to an antenna d
Summary of the content on the page No. 4
SUPPLIED ACCESSORIES l After unpacking, check that the following parts are included. ACCESSORIES FOURNIS l Après le déballage, vérifier que les pièces suivantes sont incluses. l Indoor FM Antenna l Remote Control Transmitter l Antenne FM intérieure l Emetteur de télécommande 6CH 2CH l AM Loop Antenna l Cadre-antenne AM l Antenna adapter (U.S.A. and Canada models only) l Adaptateur d’antenne (Modèles pour les États-Unis et le Canada seulement) l Batteries (size AAA, R03, UM-4) (4) l Piles (taille
Summary of the content on the page No. 5
English Thank you for selecting this YAMAHA AV receiver. FEATURES l 5 Speaker Configuration l 3 Center Channel Modes (Power Amp. Section) (NORMAL/WIDE/PHANTOM)V395RDS o Main: 60W + 60W (8Ω) RMS Output l 40-Station Random Access Preset Tuning Power, 0.04% THD, 20–20,000 Hz l Automatic Preset Tuning Center: 60W (8Ω) RMS Output Power, l Preset Station Shifting Capability (Preset 0.04% THD, 20–20,000 Hz Editing) Rear: 60W + 60W (8Ω) RMS Output Power, 0.04% THD, 20–20,000 Hz l IF Count Direct PLL Syn
Summary of the content on the page No. 6
CAUTION : READ THIS BEFORE OPERATING YOUR UNIT. 1. To assure the finest performance, please read this manual IMPORTANT carefully. Keep it in a safe place for future reference. Please record the serial number of this unit in the space below. 2. Install this unit in a cool, dry, clean place – away from windows, heat sources, sources of excessive vibration, Model: dust, moisture and cold. Avoid sources of humming (transformers, motors). To prevent fire or electrical shock, Serial No.: do not expose
Summary of the content on the page No. 7
English For U.K. customers Special Instructions for U.K. Model If the socket outlets in the home are not suitable for the plug IMPORTANT supplied with this appliance, it should be cut off and an THE WIRES IN MAINS LEAD ARE COLOURED IN appropriate 3 pin plug fitted. For details, refer to the ACCORDANCE WITH THE FOLLOWING CODE: instructions described on the right. Blue: NEUTRAL Note: The plug severed from the mains lead must be Brown: LIVE destroyed, as a plug with bared flexible cord is hazardous
Summary of the content on the page No. 8
PROFILE OF THIS UNIT You are the proud owner of a Yamaha stereo receiver – an extremely sophisticated audio component. The Digital Sound Field Processor (DSP) built into this unit takes advantage of Yamaha’s undisputed leadership in the field of digital audio processing to bring you a whole new world of listening experiences. Follow the instructions in this manual carefully when setting up your system, and this unit will sonically transform your room into a wide range of listening environments –
Summary of the content on the page No. 9
English SPEAKER SETUP SPEAKERS TO BE USED This unit is designed to provide the best sound-field quality with a 5 speaker configuration. The most effective speakers to use with this unit are main speakers, rear speakers and a center speaker. You may omit the center speaker. (Refer to the “4-Speaker Configuration” shown below.) The main speakers are used for the majority of the sound output as well as effect sounds. The rear speakers are used for the effect and surround sounds, and the center spea
Summary of the content on the page No. 10
CONNECTIONS CONNECTIONS WITH OTHER COMPONENTS Never plug in this unit and other components until all connections are completed. When making connections between this unit and other components, be sure all connections are made correctly; that is to say L (left) to L, R (right) to R, “+” to “+” and “–” to “–”. Also, refer to the owner’s manual for each component to be connected to this unit. * If you have YAMAHA components numbered as 1, 3, 4, etc. on the rear panel, connections can be made easily
Summary of the content on the page No. 11
English Connecting an external decoder for Dolby Digital, DTS and other future formats or a DVD player, etc. If you have a separate Dolby Digital, DTS or other format decoder, or if you have a DVD player or other component which incorporates a Dolby Digital, DTS, or other format decoder, its 6 channel discrete outputs can be connected to the 6CH DISCRETE INPUT terminals of this unit. (Example) 6CH DISCRETE OUTPUT MAIN CENTER SURROUND Dolby Digital decoder SUB DIGITAL WOOFER IN 6CH DISCRETE INPUT
Summary of the content on the page No. 12
CONNECTING SPEAKERS Main speakers A Main speakers B Right Left Left Right SPEAKERS MAIN A IMPEDANCE SELECTOR SET BEFORE POWER ON B MAIN A OR B: 4ΩMIN. /SPEAKER A B: 8ΩMIN. /SPEAKER Subwoofer system CENTER : 6ΩMIN. /SPEAKER REAR : 6ΩMIN. /SPEAKER REAR R CENTER (SURROUND) MAIN A OR B: 8ΩMIN. /SPEAKER A B:16ΩMIN. /SPEAKER CENTER : 8ΩMIN. /SPEAKER OUTPUT REAR : 8ΩMIN. /SPEAKER SUB WOOFER CAUTION SEE INSTRUCTION MANUAL FOR CORRECT SETTING. Right Left Center speaker Rear speakers
Summary of the content on the page No. 13
English How to Connect: Connect the SPEAKERS terminals to your speakers with wire of the proper gauge, cut as short as possible. If the connections are faulty, no sound will be heard from the speakers. Make sure that the polarity of the speaker wires is correct, that is the + and – markings are observed. If these wires are reversed, the sound will be unnatural and lack bass. Caution Do not let the bare speaker wires touch each other or any metal part of this unit. This could damage this unit
Summary of the content on the page No. 14
SUBWOOFER OUTPUT terminal OUTPUT SUB WOOFER This terminal is for connecting to the input terminal of an amplifier driving a subwoofer. This terminal outputs low frequencies from the main and center channels. (The cut-off frequency of signals output from this terminal is 150 Hz.) When 6 channel discrete signals are input to this unit and are selected as the input source, this terminal outputs signals from the subwoofer channel. IMPEDANCE SELECTOR switch Be sure to switch this only when the power
Summary of the content on the page No. 15
English ANTENNA CONNECTIONS l Each antenna should be connected to the designated terminals correctly, referring to the following diagram. l Both AM and FM indoor antennas are included with this unit. In general, these antennas will probably provide sufficient signal strength. Nevertheless, a properly installed outdoor antenna will give clearer reception than an indoor one. If you experience poor reception quality, an outdoor antenna may result in improvement. Outdoor FM antenna Outdoor AM antenn
Summary of the content on the page No. 16
CONTROLS AND THEIR FUNCTIONS FRONT PANEL ~ Ù
! Ú
@Û
# Ü
$ NATURAL SOUND AV RECEIVER VOLUME l6 20 l2 28 8 TV/DBS DVD/LD VCR 2CH/6CH 2CH/6CH STANDBY/ON 40 4 TAPE/MD TUNER PHONO CD MONITOR 60 2 0 –dB TUNING DELAY/CENTER/ A/B/C/D/E 1 2 3 4 56 7 8 MEMORY EDIT MODE FM/AM DOWN TUNING UP REAR/SWFR TIME/LEVEL MAN'L/AUTO FM AUTO/MAN'L MONO BASS TREBLE BALANCE CONCERT PHONES SPEAKERS PRO LOGIC ENHANCED VIDEO MONO MOVIE CENTER MODE 0 0 0 l l l l l l A B 2 2 2 2 2 2 ROCK CONCERT 3 3 3 3 3 3 TV SPORTS
Summary of the content on the page No. 17
English Ý PHONES jack & BALANCE control To listen with headphones, connect the headphones to the This control is effective only for the sound from the main PHONES jack. The sound output from the PHONES jack is the speakers. same as that from the main speakers. Adjusts the balance of the output volume to the left and right When listening with headphones privately, set both the speakers to compensate for sound imbalance caused by SPEAKERS A and B switches to the OFF position and switch speaker loc
Summary of the content on the page No. 18
REMOTE CONTROL TRANSMITTER The remote control transmitter provided with this unit is designed to control all the most commonly used functions of this unit as well as the components connected to it. The remote control transmitter is factory set to control this unit and most Yamaha components. To set up the remote control transmitter to control the components of other manufacturers, refer to “SETUP CODES” on page 41. 6CH 2CH 16
Summary of the content on the page No. 19
English 1) 2) 3) ~ Component selector Ý EFFECT / CLEAR / +100 Press the button for the component you want to control with the 1) This button is used to switch the DSP program on or off. remote control transmitter. (The proper code must be set for * Functions only when AMP, TAPE/MD, CD, your component. See “SETUP CODES” on page 41.) DVD/LD, VCR or TV on the component selector has been When the component selector has been pressed, the remote pressed. control transmitter is set to operate t
Summary of the content on the page No. 20
DISPLAY PANEL ~Ù
! Ú
@Û
PRESET SLEEP STEREO NORM ms dB WIDE kHz PHANTOM MHz 0 20 l00 EFFECT OFF PRO LOGIC CONCERT MONO DISCO ROCK CONCERT MEMORY AUTO TV SPORTS TAPE MON ENHANCED VIDEO MOVIE CONCERT HALL # Ü
$ Ý
~ Multi-information display # MEMORY indicator Displays various information, for example station frequency, When the MEMORY button is pressed, this indicator flashes for preset station number and name of selected input source. about 5 seconds. During this period, the displayed statio
