Summary of the content on the page No. 1
OPERATINGINSTRUCTIONS
DA S
AM/FM STEREO RECEIVER RX-765 DISCRETE AMPLIFIER STAGE
VOLUME
MEMORY T/P MODE TONE BALANCE
ST TUNED PRESET
REMOTE MEM
SENSOR
STANDBY
KHz
MHz
TUNING/PRESET
SLEEP
FM/AM CD TAPE TV/AUX VIDEO TONE DIRECT
ON/STANDBY
PHONES
AB SPEAKER
RX-765
AM/FM STEREO RECEIVER
Summary of the content on the page No. 2
SAFETY INSTRUCTIONS 1. Read Instructions - All the safety and operating instructions should connection to grounding electrodes, and requirements for the be read before the product is operated. grounding electrode. See Figure 1. 2. Retain instructions - The safety and operating instructions should Figure 1 be retained for future reference. Example of antenna grounding as per 3. Heed Warnings - All warnings on the product and in the operating National Electrical Code, ANSI/NFPA 70 ANTENNA LEAD IN
Summary of the content on the page No. 3
Introduction UNPACKING AND INSTALLATION Congratulations on Your Purchase! FOR U.S.A. Note to CATV System Installer: This reminder is Your new high fidelity receiver is designed to deliver provided to call the CATV system installer's attention maximum enjoyment and years of trouble free service. to Article 820-40 of the NEC that provides guidelines Please take a few moments to read this manual thoroughly. It will explain the features and operation of for proper grounding and, in particular, speci
Summary of the content on the page No. 4
READ THIS BEFORE OPERATING YOUR UNIT FOR U.S.A AND CANADA .................................. 120 V FOR OTHER COUNTRIES ........................ 115 V/230 V FOR YOUR SAFETY FOR YOUR SAFETY Units shipped to the U.S.A and Canada are designed Units shipped to countries other than the above for operation on 120 V AC only. countries are equipped with an AC voltage selector switch on the rear panel. Refer to the following Safety precaution with use of a polarized AC plug. paragraph for the proper setti
Summary of the content on the page No. 5
CONTENTS SAFETY INSTRUCTIONS ......................................................................................................................... 2 Introduction UNPACKING AND INSTALLATION....................................................................................................... 3 READ THIS BEFORE OPERATING YOUR UNIT................................................................................... 4 System Connections .............................................................
Summary of the content on the page No. 6
System Connections • Do not plug the AC input cord into the wall AC outlet until all connections are completed. • Be sure to connect the white RCA pin cords to the L(left) and the red RCA pin cords to the R(right) jacks when making audio connections. • Change the position of the FM indoor antenna until you get the best reception of your favorite FM stations. • A 75 Ω outdoor FM antenna may be used to further improve the reception. Disconnect the indoor antenna before replacing it with the outdoo
Summary of the content on the page No. 7
■ AC INPUT CORD Plug this cord into a wall AC outlet. ■ SWITCHED AC OUTLETS • These outlets are switched on(power-on AC INPUT 120V~60Hz 2.5A mode) and off(standby mode) according R MODEL NO. RX-765 AVIS : RISQUE DE CHOC ELECTRIQUE-NE PAS OUVRIR. LISTED WARNING : SHOCK HAZARD-DO NOT OPEN. E208974 7H86 AUDIO/VIDEO to power control as follows(Maximum SPEAKERS MADE IN CHINA THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. EQUIPMENT DESIGNED IN USA AM OPERATION IS SUBJECT TO THE FOLLOWING T
Summary of the content on the page No. 8
Front Panel & Remote Controls DA S - AM/FM STEREO RECEIVER RX 765 DISCRETE AMPLIFIER STAGE VOLUME MEMORY T/P MODE TONE BALANCE ST TUNED PRESET MEM REMOTE STANDBY SENSOR KHz MHz SLEEP FM/AM CD TAPE TV/AUX VIDEO TONE DIRECT ON/STANDBY PHONES AB SPEAKER DIGI LINK III System Remote Controls POWER ON STANDBY DIMMER DIMMER SLEEP SPEAKER POWER ON POWER ON STANDBY AB CD TAPE VIDEO TV/AUX • You can remotely control not only this receiver but DIMMER DIMMER SLEEP SLEEP SPEAKER S
Summary of the content on the page No. 9
POWER BUTTON TUNING/PRESET MODE BUTTON In the standby mode, press this button, then this unit is Press this button to select the tuning mode or the preset turned on to enter the operating mode. mode. STANDBY BUTTON NUMERIC BUTTONS(0 ~ 9) In the operating mode, press this button or the POWER Press these buttons to select or to store preset stations button on the front panel, then this unit is turned off to directly. enter the standby mode. TUNING/PRESET UP/DOWN( STANDBY INDICATOR BUTTONS Press th
Summary of the content on the page No. 10
30 TAPE DECK SECTION REMOTE SENSOR DECK SELECTOR A, B- for selecting deck A or B This receives the signals from the remote control unit. , - to begin reverse or forward side playback. FLUORESCENT DISPLAY , - to wind up the tape reversely or forwardly. - for recording. - to stop playback or recording. FLUORESCENT DISPLAY STEREO INDICATOR MEMORY INDICATOR TUNED INDICATOR ST TUNED PRESET MEM KHz MHz SLEEP PRESET NUMBER, SLEEP TIME DISPLAY INPUT, FREQUENCY, VOLUME LEVEL, OPERATING INFORMATION, etc.
Summary of the content on the page No. 11
Operations LISTENING TO A PROGRAM SOURCE Turn the power on. 1 • Then this unit is turned on to enter the operating mode. STANDBY • In the operating mode, when the POWER POWER ON POWER ON STANDBY STANDBY POWER ON STNADBY button on the front panel or the SPEAKER SPEAKER DIMMER DIMMER SLEEP SLEEP STANDBY button on the remote control is A B CD CD TAPE TAPE VIDEO VIDEO TV/AUX TV/AUX pressed, the unit is turned off to enter the or REPEAT REPEAT TUNER TUNER standby mode. A/B A/B CD INTRO INTRO • In t
Summary of the content on the page No. 12
POWER ON STANDBY DIMMER SLEEP SPEAKER AB CD TAPE VIDEO TV/AUX REPEAT TUNER A/B INTRO To mute the sound. To listen with the headphones. A DECK SEL. TAPE PHONES 6 B 7 TREBLE BASS + + T/P MUTE MUTE VOL. TUNE TUNE MEMO + FM MODE P.SCAN VOL. “MUTE” lights up and flickers. To resume the previous sound level, press this button Be sure to switch off both A and B speakers. POWER ON STANDBY again. SPEAKER DIMMER SLEEP AB 12 3 4 5 CD TAPE VIDEO TV/AUX REPEAT 67 8 9 0 TUNER A/B Adjusting the tone(bass and t
Summary of the content on the page No. 13
LISTENING TO RADIO BROADCASTS Auto tuning Select the tuner and then the desired band. POWER ON POWER ON STANDBY 1 DIMMER DIMMER SLEEP SLEEP SPEAKER SPEAKER MHz A B FM/AM CD CD TAPE TAPE VIDEO VIDEO TV/AUX TV/AUX REPEAT REPEAT TUNER TUNER TUNER A/B A/B BAND FREQUENCY CD INTRO INTRO or A • Each time this button is pressed, the band is changed DECK SEL. DECK SEL. TAPE POWER ON STANDBY B to FM or AM. SPEAKER DIMMER SLEEP POWER ON STANDBY TREBLE BASS AB CD TAPE VIDEO TV/AUX T/P MUTE SPEAKER DIMMER SL
Summary of the content on the page No. 14
Select the desired preset number (1~30) Repeat the above steps 1 to 3 to memorize and press the MEMORY button. other stations. 3 4 T/P T/P TUNE TUNE TUNE TUNE MEMO + MEMORY TREBLE TREBLE + BASS BASS + or MUTE MUTE VOL. VOL. TUNE TUNE TUNE TUNE MEMO MEMO + FM MODE FM MODE P.SCAN P.SCAN VOL. VOL. MEMORY BACKUP FUNCTION • When using the NUMERIC buttons on the remote control. The following items, set before the receiver is turned 3 Examples) For “3” : off, are memorized. within 2 seconds • I
Summary of the content on the page No. 15
POWER ON STANDBY DIMMER SLEEP SPEAKER AB CD TAPE VIDEO TV/AUX REPEAT TUNER A/B INTRO A DECK SEL. B TREBLE BASS T/P MUTE VOL. TUNE TUNE MEMO FM MODE P.SCAN VOL. RECORDING 12 3 4 5 67 8 9 0 The volume, tone(bass, treble) and balance settings have no effect on the recording signals. REMOTE CONTROL RM-110 When you select tuner, CD or TV/AUX as a recording source, recording may be made on TAPE or VIDEO, or both simultaneously. Recording with TAPE Recording with VIDEO Select the desired input as a rec
Summary of the content on the page No. 16
Troubleshooting Guide If a fault occurs, run through the table below before taking your receiver for repair. If the fault persists, attempt to solve it by switching the receiver off and on again. If this fails to resolve the situation, consult with your dealer. Under no circumstances should you repair the receiver yourself as this could invalidate the warranty. PROBLEM POSSIBLE CAUSE REMEDY No power • The AC input cord is disconnected. • Connect the cord securely. • Check the outlet using a lam
Summary of the content on the page No. 17
Specifications AMPLIFIER SECTION Power output, stereo mode, 8 Ω, THD 0.08 %, 20 Hz~20 kHz ................................................................................ 2X100 W Total harmonic distortion, 8 Ω, 100 W, 20 Hz~20 kHz ................................................................................................ 0.04 % Intermodulation distortion 60 Hz : 7 kHz= 4 : 1 SMPTE, 8 Ω, 100 W ...................................................................................................
Summary of the content on the page No. 18
OPERATINGINSTRUCTIONS RX-765 AM/FM STEREO RECEIVER 5707-04740-002-0
