Summary of the content on the page No. 7
T741 manual (GB) 22/10/01 3:56 pm Page 7 FIG. 3 REMOTE CONTROL 12 FIG. 4 3 4 6 5 FIG. 5 7 8 11 9 10 12 13 GB 14-18 20 19 FIG. 6 21 23 22 24 26 25 7
Summary of the content on the page No. 8
T741 manual (GB) 22/10/01 3:56 pm Page 8 REAR PANEL CONTROLS (FIGURE 1) 4. VIDEO 1 - VIDEO 4 (AUDIO & VIDEO) 1. FM & AM ANTENNA Apart from the audio signal, these inputs will also accept a video signal AM ANTENNA - An AM loop antenna is supplied with the T741 and is which will be routed to the Monitor Out sockets (No. 7) for a television required for AM reception. Open the clip terminal lever and insert the or video projector. The Video 1,2 and 3 inputs also have the option of a wire from the
Summary of the content on the page No. 9
T741 manual (GB) 22/10/01 3:56 pm Page 9 6. AUDIO PRE-OUTS / SUBWOOFER OUT NOTE AUDIO PRE-OUTS - The NAD T741 receiver has five power amplifiers This unit is designed to produce optimum sound quality when built-in to power all the speakers connected to it (Left, Right, Center, Left speakers with impedance within the set’s ranges are connected. Surround, Right Surround). It is also possible to use the T741 as a pre- Please check the following information and choose speakers with the amplifier
Summary of the content on the page No. 10
T741 manual (GB) 22/10/01 3:56 pm Page 10 FRONT PANEL CONTROLS (FIGURE 2) 10. NAD-LINK IN OUT The NAD-Link connector is used to pass commands from other units fitted 1. POWER with NAD-Link connectors. This allows centralized control of a complete Press the POWER button to switch the receiver to STANDBY mode. Press system, and also allows some of the basic functions of other NAD any input selector button on the front panel or the POWER button (No. 1) components (such as a CD player) also equi
Summary of the content on the page No. 11
T741 manual (GB) 22/10/01 3:56 pm Page 11 4. FM/AM 8. DOWN / UP AND The FM/AM button switches the tuner section from the AM band to the The function of these buttons depends on the tuning mode selected with FM band and vice-versa. The Display Panel shows the frequency of the the Preset/Tune button (No. 7). The Preset/Tune button toggles between tuned station and which band is selected. The FM tuning is in 0.05 MHz the two operation modes: increments, AM tuning is in 9 kHz or 10kHz increments
Summary of the content on the page No. 12
T741 manual (GB) 22/10/01 3:56 pm Page 12 The control is also used to adjust various set-up settings and levels for the VIDEO 3 & VIDEO 4 - Video 3 & 4 select the signal from a T741. In conjunction with the SETUP button (No. 17) the speakers size TV/Satellite/Cable receiver, DVD player or VCR connected to VIDEO 3 or and delay can be adjusted; in conjunction with the Tone Control button VIDEO 4 as the active input. “VIDEO-3” or “VIDEO-4” is shown in the (No. 18) the Bass and Treble levels can
Summary of the content on the page No. 13
T741 manual (GB) 22/10/01 3:56 pm Page 13 16. SURROUND MODE 17. SET UP With the Surround Mode buttons the available surround sound modes This button is used to configure the T741 to match with the specific can be selected. The selected Surround mode is permanently indicated in speakers in your system. This setup procedure should be done when you the display Area. The Surround Mode buttons scroll through the available first install your system, and subsequently when new or different surround
Summary of the content on the page No. 14
T741 manual (GB) 22/10/01 3:56 pm Page 14 STORING AND RECALLING PRESETS DELETING A STORED PRESET TO STORE A PRESET You can empty a Preset by deleting the stored information: •Tune to the radio station you wish to enter into a Preset (refer to •Press MEMORY button (No. 6). chapter “Front Panel Controls”; section 8). If the station is •Press DOWN/UP buttons (No. 8) to select the preset number to be transmitting RDS information, the RDS indicator will light up and deleted. station initials will
Summary of the content on the page No. 15
T741 manual (GB) 22/10/01 3:56 pm Page 15 4. NUMERIC KEYPAD TITLE functions when in the DVD mode to display the title screen RCVR mode - The numeric keypad can be used to directly access FM and included on DVD video discs. Refer to the NAD DVD player Owner’s AM Station Presets by pressing the number of the desired preset. Manual for more detailed information on this function. DVD mode - These keys can also be used to select CD tracks and enter chapter numbers in the DVD mode (consult the DVD
Summary of the content on the page No. 16
T741 manual (GB) 22/10/01 3:56 pm Page 16 13. TUNE MODE / RETURN 27. DVD1 / DVD2 SWITCH The TUNE MODE button functions the same as the button of the front This switch is located inside the battery compartment of the AVR-1, and panel of the T741, switching between the Tune Mode and the Preset changes the DVD functions between DVD1 (codes for T550 and L55 Mode. See complete description in the FRONT PANEL CONTROLS section DVD Players) and DVD2 (codes for T531 and T571 DVD Players). above. SETTI
Summary of the content on the page No. 17
T741 manual (GB) 22/10/01 3:56 pm Page 17 Now rotate the VOLUME/SETUP knob until REAR LAR (current setting for Many film soundtracks rely heavily on very low frequency sound effects the SURROUND speakers) appears in the display window. Press the SET which are difficult for normal or smaller hi-fi speakers to reproduce. To UP button again to change the size. Each press of the SET UP button will faithfully reproduce these low frequencies you can use a specially change the setting for that sp
Summary of the content on the page No. 18
T741 manual (GB) 22/10/01 3:56 pm Page 18 TIPS FOR SETTING DELAY The Channel Balance for each speaker can be adjusted in 1dB Measure the distance from the listening position to the center speaker increments. Continue to calibrate the level for each speaker until equal (dC) and to one of the front speakers (dFL or dFR). Subtract the center loudness is achieved at your listening position. A more accurate channel distance from the front L or R channel distance. For example, if adjustment can be
Summary of the content on the page No. 19
T741 manual (GB) 22/10/01 3:56 pm Page 19 PROBLEM CAUSE SOLUTION NO SOUND • Power AC lead unplugged or power not • Check if AC lead is plugged in and power switched on switched on •Tape Monitor selected • De-select Tape Monitor mode • Mute on • Switch off Mute NO SOUND ON ONE CHANNEL • Speaker not properly connected or damaged. • Check connections and speakers • Input lead disconnected or damaged • Check leads and connections • In Setup “OFF” for surround speaker selected • Select appropriat
Summary of the content on the page No. 20
T741 manual (GB) 22/10/01 3:56 pm Page 20 www.NADelectronics.com ©2001 NAD ELECTRONICS INTERNATIONAL All rights reserved. No part of this publication may be reproduced, stored or transmitted in any form without the written permission of NAD Electronics International T741 Manual 10/01 Printed in Malaysia
Summary of the content on the page No. 1
T741 manual (GB) 22/10/01 3:56 pm Page 1
T741
AV Surround Sound Receiver
Owner’s Manual
GB
Summary of the content on the page No. 2
T741 manual (GB) 22/10/01 3:56 pm Page 2 GB 2
Summary of the content on the page No. 3
T741 manual (GB) 22/10/01 3:56 pm Page 3 NOTES ON INSTALLATION. Your NAD T741 should be placed on a firm, level surface. Avoid placing the unit in direct sunlight or near sources of heat and damp. Allow adequate ventilation. Do not place the unit on a soft surface like a carpet. Do not place it in an enclosed position such a bookcase or cabinet that may impede the air-flow through the ventilation slots. Make sure the unit is switched off before making any connections. The RCA sockets on your
Summary of the content on the page No. 4
T741 manual (GB) 22/10/01 3:56 pm Page 4 EXPLANATION OF GRAPHICAL SYMBOLS The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servici
Summary of the content on the page No. 5
T741 manual (GB) 22/10/01 3:56 pm Page 5 ELECTRIC POWER 1 Power Sources - Connect this unit only to power sources specified in the Operating Instructions, and as marked on the unit. 2 Polarization - As a safety feature, some units are equipped with polarized AC power plugs which can only be inserted one way into a power outlet. If it is difficult or impossible to insert the AC power plug into an outlet, turn the plug over and try again. If it still does not easily insert into the outlet, plea
Summary of the content on the page No. 6
T741 manual (GB) 22/10/01 3:56 pm Page 6 FIG. 1 REAR PANEL CONNECTIONS 679 8 11 +12V TRIGGER OUT 2 3 4 5 10 12 FIG. 2 FRONT PANEL CONTROLS 48 379 10 GB 11 12 13 14 15 16 17 18 6
