Magnadyne PPC-200 user manual

Summary of the content on the page No. 1

Owner's Manual
VOLUME TONE FADER TIME
ON/OFF
M H
12 3
ME
ST
FM
CH
LOC
45 6
RCL
FM/ LO/
TUNING SEEK SCAN
AM DX
PUSH BALANCE
AM/FM Stereo Receiver with Digital Clock,
Seek / Scan / Manual Tuning
Model PPC-200

Summary of the content on the page No. 2

M CONTROLS AND OPERATIONS 12 8 10 5 VOLUME TONE FADER TIME ON/OFF M 12 3 ME ST FM CH LOC 45 6 RCL FM/ LO/ TUNING SEEK SCAN AM DX BALANCE PUSH 1 2 7 9 11 6 3 4 On / Off / Volume / Balance / Control Knob (1) Fader Control Knob (3) To turn the unit on, rotate the the volume control knob to the Rotating the fader control knob from left to right will change the right. To adjust the the volume level, continue rotating the knob relative output level of the front or rear speakers. Adjust the to the righ

Summary of the content on the page No. 3

CONTROLS AND OPERATIONS Seek/ Scan Button (6) Local Distant Button (11) Pressing the seek button will cause the tuner to search out the Switch the LO/DX button to the LO position to prevent strong next strongest station up the tuning scale. To continue seeking, local stations from overlapping weaker stations. For normal you must repeatedly press the seek button each time the tuner operation and maximum sensitivity, switch to the DX position. stops on a station. Note: When in the LO mode, “LOC”

Summary of the content on the page No. 4

CONTROLS AND OPERATIONS How to Preset Radio Stations: Repeat the following procedures to memorize radio stations: 1. Turn on the unit by rotating the volume control knob to the right. 2. Select the radio band (FM1, FM2, AM1) you want to memorize radio stations in by pressing the FM/AM button. 3. Use the manual tuning button to select a radio station you want to set into memory. 4. Press the memory button (ME) and release it. A "CH" indicator will begin to flash in the display area. 5. Press the

Summary of the content on the page No. 5

INSTALLING THE RADIO 5 1 4 2 3 5 2 6 2 1. Anchoring Board 2. Flat Washer 2 3. Machine Screw 4. Mounting Strap 5. Hex Nut 7 6. Shaft Nut 7. Dashboard 8. Trim Plate 8 6 4. Support the rear of the chassis using the Installing the Radio perforated back strap and nuts supplied. 1. Locate the factory supplied opening for the radio or choose a location within reach of Attach the back strap to the rear chassis of the primary operator of the vehicle. the radio and find a secure, solid location 2. Cut an

Summary of the content on the page No. 6

ELECTRICAL CONNECTIONS LEFT FRONT RIGHT WHITE (-)* ORANGE (-)* GRAY (+) BROWN (+) Noise Filter RED (+) To 12 Volt DC Power ORANGE Memory to Battery BLACK (-) To Ground YELLOW Power Antenna BLUE (+) GREEN (+) WHITE (-)* ORANGE (-)* LEFT REAR RIGHT 6

Summary of the content on the page No. 7

ELECTRICAL CONNECTIONS Red Wire: (with fuse holder and noise filter) Gray Wire: Connect the red wire to a +12 volt power source that is Connect the gray wire to the positive terminal of the right front “switched on and off by the ignition key. Most power sources speaker. can be located at the vehicles fuse block. Use a test light or volt meter to select the correct connection point. Green Wire: Connect the green wire to the positive terminal of the left rear Orange Wire: (with fuse holder) speak

Summary of the content on the page No. 8

SPECIFICATIONS WARRANTY FM Tuner ONE (1) YEAR LIMITED WARRANTY Range . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 87.5 - 107.9MHz Magnadyne Corporation or its authorized agents will within 1 year from the date of sale to you, repair, replace or refund the retail sales price of said product or any part Usable Sensitivity . . . . . . . . . . . . . . . . . . . . . . . . . . . 17dBf (2uV) thereof, at the option of the Magnadyne Corporation or its authorized agents, if said 50d