Summary of the content on the page No. 1
R
Installation
and Operations
Manual
M9800 AM/FM/WB Stereo Receiver
© Copyright 1998
Magnadyne Corporation
Summary of the content on the page No. 2
Introduction Your new AM/FM unit incorporates Also at this time, it would be a good a microcomputer managed electron- idea to write down the serial number ic AM/FM stereo tuning system and of the unit in the space provided. In FM Optimizer. The two as a combina- the unlikely event that the radio will tion will provide the user with the need warranty service, you will need finest crystal clear AM/FM stereo this number to obtain the service. radio broadcast reproduction. To insure trouble free lo
Summary of the content on the page No. 3
Installation Procedure Removing the Unit: Red Wire: In the event that the unit requires Connect the red wire to a source of removal from it’s mounting location, 12 volts that is controlled by the igni- repeat the following procedures. tion key. Use a test light or volt meter to locate a connection point at the A. Release the rear support strap. fuse block. B. Insert the keys provided into the slot on both sides of the chassis Black Wire: until locked. (snapped into place) Connect the black wire
Summary of the content on the page No. 4
AM / FM / WB STEREO VOL TONE BAL FAD TUNE SCAN BAND R.FREQ WEATHER 1 2 3 4 5 PWR Installation Procedure Figure 1 Sheet Metal Screw Nut Washer Metal Strap Dashboard Mounting Sleeve Removing the Unit Removal Keys 4
Summary of the content on the page No. 5
Installation Procedure Speaker Connections: Wiring Two Speakers: Note: Every speaker has a positive (+) Green Wire: and a negative (-) connection termi- Connect the Green wire to the Left nal, therefore every speaker must speaker “Positive” wire. have two wires connected to it. To Black/Green Wire: properly connect the speaker system Connect the Black/Green wire to to your new Magnadyne radio, you the Left speaker “Negative” wire. must have a + and - wire coming from Gray Wire: every speaker t
Summary of the content on the page No. 6
Installation Procedure Four Speaker Wiring Right Front Right Rear Speaker Speaker Black Wire 12 VDC Ground + - 12 Black/Gray Wire 11 Gray/Red Wire 10 Black/Green Wire 9 Green/Red Wire 8 Gray/Black Wire 7 Gray Wire 6 Green/Black Wire 5 Green Wire 4 3 Red Wire 12 VDC Ign./Acc. Lead 2 Orange Wire 12 VDC Constant 1 + - 3A Left Front Left Rear Speaker Speaker Two Speaker Wiring Right Front Speaker Black Wire 12 VDC Ground + - 12 Black/Gray Wire 11 Gray/Red Wire Tape 10 Ends Black/Gre
Summary of the content on the page No. 7
Control Button Identification Figure 2 2 16 3 478 5 10 9 1. On/Off Power Switch, Control 6. Radio Station Scan Button. and Volume Level Adjuster. 7. Frequency Selector Button. 2. Fader Control. 8. Weatherband Radio Selector Switch. 3. Balance and Tone Controls. 9. Display. 4. Radio Band Selector Button. 10. Preset Stations. 5. Manual Tuning Control Buttons. Display Figure 3 9a 9 9c 9d 9b Figure 4 7
Summary of the content on the page No. 8
< < Using the Radio Listening to the Radio: Display Priority Note: 1. Turn the vehicle’s ignition key to The priority of the display area (9) is the “ON” or “ACC” position to pro- for the clock. 5 seconds after the last vide power to the radio. tuning control command, the display will change and display the clock. To 2. Rotate knob (1) clockwise to turn recall the radio frequency, press and the radio on. Adjust the volume release the “R.Freq” button (7). The knob (1) to a low listening level.
Summary of the content on the page No. 9
< < < Clock Setting Programming Setting the Clock with the Radio OFF Programming the Radio Station Recall Buttons 1. Turn the vehicles ignition key to the “ON” or “ACC” position to pro- 1. Rotate knob (1) clockwise to turn vide power to the radio. You will on the unit. Adjust the volume know that radio has sufficient knob (1) to a normal listening power as the clock will be displayed level. in the LCD display window (9). 2. Use the band button (4) to select the AM or FM rad
Summary of the content on the page No. 10
Audio Adjustments Volume Level 1. Rotate the volume control knob (1) clockwise to increase the volume. 2. Rotate the volume control knob (1) counter clockwise to decrease the volume. Left to Right Balance 2. Rotating the “BAL “ knob (3) to the left will balance the speakers to the left. 3. Rotating the “BAL” knob (3) to the right will balance the speakers to the right. Front to Rear Speaker Balance (Fader Control) Rotate the fader control (2) clockwise or counter clo
Summary of the content on the page No. 11
Specifications AM/FM Tuner: FM Frequency Range . . 87.5 - 107.9MHz AM Frequency Range . . 520 - 1720 KHz IF Rejection . . . . . . . . . . . . . . . AM 45dB . . . . . . . . . . . . . . . . . . . . . . . . . . FM 70dB Image Rejection . . . . . . . . . . . . AM 55dB . . . . . . . . . . . . . . . . . . . . . . . . . . FM 55dB Selectivity . . . . . . . . . . . . . . . . . AM 30dB . . . . . . . . . . . . . . . . . . . . . . . . . . FM 60dB S/N ratio (Signal to Noise) . . AM 48dB . . . . . . . . .
Summary of the content on the page No. 12
Warranty ONE (1) YEAR LIMITED WARRANTY Magnadyne Corporation or its authorized agents will within 1 year from the date of sale to you, repair, replace or refund the retail sales price of said product or any part thereof, at the option of the Magnadyne Corporation or its authorized agents, if said product or part is found defective in materials or workmanship, when properly con- nected and operating on the correct power requirements designated for the specif- ic product. This warranty and Magnady
