Summary of the content on the page No. 1
E
M
M5100CDUMFinal 2/1/05 4:58 PM Page 1
Installation and
Operation Manual
POWER EJECT
DIM ELAPSE
LOUD PULL OPEN 4 X 50W AS/PS
MARINE CD RECEIVER
SHIFT
MODE SCAN
U
PGM
EQ
SHIFT
CH
TRK TRK
BAND DISP
SEL MUTE
TUNE TUNE
MONO
1 MEM 2 PGM 3 RPT 4 RDM 5 INT
M5100CD
Waterproof
AM/FM/WB and CD Stereo Receiver
A Registered Trademark of Magnadyne Corporation
US Patent Number D 500,303 S
L
O
V
Summary of the content on the page No. 2
E M M5100CDUMFinal 2/1/05 4:58 PM Page 2 Introduction Your new M5100CD entertainment system has been designed to give you many years of listening pleasure. Take a moment to read through this manual and become familiar with the operations and features of this outstanding product. It is advisable to keep this manual in your vehicle so it is readily available for reference. Be sure to fill out and send in your warranty card to ensure that you receive the full benefits of warranty repair in the u
Summary of the content on the page No. 3
M5100CDUMFinal 2/1/05 4:58 PM Page 3 Location and Function of Controls at a Glance 8. Multi-Function Button 3/RPT: Radio: Recalls a memorized radio station, and programs a radio station into memory (See Radio Operation for more information). CD: Continuously repeats the same track (See CD Operation for more information). 9. Multi-Function Button 4/RDM: Radio: Recalls a memorized radio station, and programs a radio station into memory (See Radio Operation for more information). CD: Plays a
Summary of the content on the page No. 4
M5100CDUMFinal 2/1/05 4:58 PM Page 4 Radio Operation Listening to the Radio Programming the Radio You can program up to 15 FM radio stations and 5 AM 1. Push the “POWER” button (1) once to turn the unit on. radio stations. 2. Press the “BAND” button (11) to select a radio Manual Station Recall Programming band: FM1, FM2, FM3, AM or WX (weather band). 1. Press the “BAND” button (11) to select a radio 3. AM or FM Station Selection band: FM1, FM2, FM3 or AM. Automatic Seek Station Selection: Pre
Summary of the content on the page No. 5
M5100CDUMFinal 2/1/05 4:58 PM Page 5 General Operations Setting the Clock Selecting a Mode 1. Press DISP button (13) for more than 3 seconds Press the MODE button (3) to step sequentially until the clock shown in the display area is flashing. through the following sources: Radio Mode to 2. Press the TRK/TUNE DN button to adjust the Radio Tuner > CD > CD Changer (optional) > hours Auxiliary > Radio Tuner. 3. Press the TRK/TUNE UP button to adjust the minutes. Illumination Dimmer Press LOUD/DIM
Summary of the content on the page No. 6
M5100CDUMFinal 2/1/05 4:58 PM Page 6 CD Player Operation Inserting and Ejecting a Disc Repeat these steps to program tracks in the 2 PGM Pull the tab at the top of the CD Door, and the desired order. Then press the button to door will open. Push a disc into the CD Slot (19), play the CD in programmed order. When you label side up, and the disc will begin to play. have programmed 32 tracks, “FULL” will appear The disc will eject automatically when the CD in the display. Door is op
Summary of the content on the page No. 7
M5100CDUMFinal 2/1/05 4:58 PM Page 7 Waterproof Wired Remote General Operations (Optional) 8 7 6 MODE VOLUME TRK TRK 5 MUTE TUNE TUNE STEREO COMMANDER VOLUME POWER BAND SHIFT/SCAN 12 3 4 1. Power Button: Press and release the POWER 5. Volume Buttons: Press the button to in- VOLUME VOLUME button (1) to turn on/off the unit. crease or the button decrease the volume To program the initial volume level, adjust the level. volume to the desired level, then press the POWER button f
Summary of the content on the page No. 8
M5100CDUMFinal 2/1/05 4:58 PM Page 8 Waterproof Wired Remote Introduction This unit is a wired remote control made using a modified controller or similar layout. It is capable of operating the specified functions on the M5100CD receiver. The body, buttons, controls and display are UV and water-resistant. It includes a LCD and an illumination circuit. Take a moment to read through this section and become familiar with the operations and features of this outstanding product. It is advisable to
Summary of the content on the page No. 9
M5100CDUMFinal 2/1/05 4:58 PM Page 9 Wiring Note: This unit is designed to connect to (4) four Step 1: The radio chassis is designed to be “Panel speakers. If the installation only requires (2) two Mounted” through a opening in the mounting panel. speakers, use the White and Gray wire sets to con- See the installation part of this manual for panel nect the speakers. mounting. Step 2: Bring all wiring for the connection of the unit (including the antenna) through the mounting hole. Connect t
Summary of the content on the page No. 10
M5100CDUMFinal 2/1/05 4:58 PM Page 10 Wiring Diagram M5100CD Antenna Socket Red Right Channel RCA Connectors Set 1 Ignition Red Wire Connect to Line Input Switch (+12v in ) of Optional Amplifier White Left Channel Battery Yellow Wire (+12v in) Red Black Wire Ground (B-) Right Channel RCA Connectors Set 2 Power Antenna Blue Wire (Switched Connect to Line Input +12v out) of Optional Amplifier White Left Channel Left Right Gray Wire White Wire Front Front Speaker Speaker Gray Wire with Black S
Summary of the content on the page No. 11
M5100CDUMFinal 2/1/05 4:58 PM Page 11 CD Changer Connection M5100CD CD Changer (Optional) Male to Male 8-Pin Din Cable 8-Pin Din Connector (Supplied with CD changer) Auxiliary Connection VCR Audio Out From M5100CD or VCR / TV / Video Game TV Red RCA (Right) Auxiliary Audio Input RCA with Yellow Cables or White RCA (Left) Video Game Wired Remote Connection Wired Remote (Optional) M5100CD Female 8-Pin Male 8-Pin Mini Din Connector Mini Din Connector 11
Summary of the content on the page No. 12
M5100CDUMFinal 2/1/05 4:58 PM Page 12 Installation Remove Transportation Screws Mounting Surface Before installing the unit, remove the two screws shown in the illustration below. Mounting Location Remove screws before installation Mounting Holes 3. Use the glue paper to stick the two mounting brackets to the back of the mounting surface. The screw holes of the brackets must respec- tively aim at the mounting holes in order to fix the unit to the mounting surface. Note: If this unit is to be
Summary of the content on the page No. 13
M5100CDUMFinal 2/1/05 4:58 PM Page 13 Installation Sheet Metal Screw Nut Washer Metal Strap Mounting Surface Trouble Shooting Before going through the trouble shooting table below, check the wiring connection. If the problem persist, consult your nearest service dealer. SYMPTOM CAUSE SOLUTION No power The ACC Power Supply is not Both the red and yellow connected. wires require power from the power source. The fuse is blown. Replace the fuse. Disc cannot be loaded, Presence of disc inside th
Summary of the content on the page No. 14
M5100CDUMFinal 2/1/05 4:58 PM Page 14 Specifications GENERAL CD PLAYER AM RADIO Power Supply Signal to Noise Ratio: Frequency Coverage: Requirements: > 55 dB 530 to 1720 kHz DC 12 Volts, Negative Channel Separation: Sensitivity (S/N=20dB): Ground > 50 dB 32 dBu Chassis Dimensions: Frequency Response: 178 mm (W) x 165 (D) x 40Hz – 18 kHz 50 (H) Tone Controls: FM RADIO Bass: 100 Hz ±10 dB Frequency Coverage: Treble: 10 kHz ±10 dB 87.5 to 107.9 MHz Maximum Output Power: Sensitivity (S/N=30dB): 4
Summary of the content on the page No. 15
M5100CDUMFinal 2/1/05 4:58 PM Page 16 A Registered Trademark of Magnadyne Corporation © Copyright 2003 Magnadyne Corporation M5100CDUM Rev. B 2-05
