Summary of the content on the page No. 1
AUDIO/VIDEO CONTROL RECEIVER
AUDIO/VIDEO-RECEIVER MIT STEUEREINHEIT
AMPLI/TUNER DE COMMANDE AUDIO/VIDEO
GEINTEGREERDE AUDIO/VIDEO-VERSTERKER
RECEPTOR DE CONTROL DE AUDIO/VÍDEO
RICEVITORE DI CONTROLLO AUDIO/VIDEO
RX-730RBK
SEND/LEARN ERROR
TV VCR AUDIO
SEQUENTIAL PROGRAM KEY
SLEEP
AB C
ONE TOUCH
OPERATION
SOURCE SELECT
VIDEO 1 VIDEO 2 VCR
SURROUND TV SOUND FM AM
MODE
SEA TAPE CD PHONO MASTER VOLUME
MODE
RX-730R AUDIO/VIDEO CONTROL RECEIVER
VIDEO1 VIDEO2 VCR TV SOUND FM AM CD PHONO TAPE
MENU
O
Summary of the content on the page No. 2
Warnings, Cautions and Others/Warnung, Achtung und sonstige Hinweise/ Mises en garde, précautions et indications diverses/Waarschuwingen, voorzorgen en andere mededelingen/Avisos, precauciones y otras notas/ Avvertenze e precauzioni da osservare IMPORTANT for the U.K. DO NOT cut off the mains plug from this equipment. If the plug fitted is not suitable for the power points in your home or the cable is too short to reach a power point, then obtain an appropriate safety approved extension lead or
Summary of the content on the page No. 3
CAUTION VOORZICHTIG To reduce the risk of electrical shocks, fire, etc.: Ter vermindering van gevaar voor brand, elektrische schokken, enz.: 1. Do not remove screws, covers or cabinet. 1. Verwijder geen schroeven, panelen of de behuizing. 2. Do not expose this appliance to rain or moisture. 2. Stel dit toestel niet bloot aan regen of vocht. ACHTUNG PRECAUCIÓN Zur Verhinderung von elektrischen Schlägen, Brandgefahr, usw: Para reducir riesgos de choques eléctricos, incendio, etc.: 1. Keine Schraub
Summary of the content on the page No. 4
Caution –– POWER switch and STANDBY/ON button! Voorzichtig –– POWER en STANDBY/ON schakelaars! Dit apparaat is voorzien van een POWER hoofdschakelaar om het This apparatus is provided with a POWER switch to be able to apparaat gebruiksklaar te zetten, maar te zorgen dat het stroomverbruik minimize power consumption for safe use. Therefore, minimaal blijft. Neem in verband hiermee het volgende in acht: 1. When doing initial setting, complete all the connections required, 1. Bij de eerste ingebrui
Summary of the content on the page No. 5
Caution: Proper Ventilation Voorzichtig: Zorg Voor Goede Ventilatie To avoide risk of electric shock and fire and to protect from damage. Om gevaar voor brand of een elektrische schok te voorkomen, dient u Locate the apparatus as follows: bij opstelling van het apparaat op de volgende punten te letten: Front: No obstructions open spacing. Voorkant: Voldoende ruimte vrij houden. Sides: No obstructions in 10 cm from the sides. Zijkanten: Minstens 10 cm aan weerszijden vrij houden. Top: No obstruct
Summary of the content on the page No. 6
Table of Contents Getting Started........................................................................................................................... 2 Before Installation .................................................................................................................... 2 Checking the Supplied Accessories ......................................................................................... 2 Switches, Buttons and Controls .............................................
Summary of the content on the page No. 7
Getting Started This section explains how to connect audio/video components and speakers to the receiver, and how to connect the power supply. Before Installation General • Be sure your hands are dry. • Turn the power off to all components. • Read the manuals supplied with the components you are going to connect. Locations • Install the receiver in a location that is level and protected from moisture. • The temperature around the receiver must be between –5˚ and 35˚ C (23˚ and 95˚ F). • Make sur
Summary of the content on the page No. 8
Switches, Buttons and Controls Become familiar with the main switches and controls on your receiver before use. Front Panel 15 23 4 6 78 MASTER VOLUME RX-730R AUDIO/VIDEO CONTROL RECEIVER VIDEO1 VIDEO2 VCR TV SOUND FM AM CD PHONO TAPE ONE TOUCH OPERATION –+ SOURCE SURROUND MODE SEA MODE SURROUND SEA MEMORY ADJUST ADJUST SETTING TUNER MEMORY STANDBY VIDEO 2 SPEAKERS PHONES POWER DISPLAY MODE TA/NEWS/INFO EON PTY SEARCH VIDEO LR AUDIO 12 _ON ÑOFF STANDBY/ON _ON ÑOFF 9p qw e r uo;asd ty i
Summary of the content on the page No. 9
RM-SR992U REMOTE CONTROL SEND/LEARN ERROR 1 2 3 4 5 6 7/P 8 9 10 0 +10 L BALANCE R VOLUME Remote Control Inside panel Outside panel f z SEND/LEARN ERROR SEND/LEARN ERROR m LEARN CANCEL EXT.1 TUNER TV VCR AUDIO x SEQUENTIAL PROGRAM KEY SLEEP TV VCR EXT.2 CD DISC g c AB C ONE TOUCH SOUND OPERATION CD TAPE CONTROL , h SOURCE SELECT CONTROL VIDEO1 VIDEO2 VCR DELAY – CENTER + 1 2 3 4 SURROUND TV SOUND FM AM + TEST – REAR MODE v 5 6 7/P 8 j . FM SEA TAPE CD PHONO MODE/MUTE MODE k 9 10 0 +10 PRESET TV
Summary of the content on the page No. 10
Connecting the FM and AM (MW/LW) Antennas FM Antenna Connections A Using the Supplied FM Antenna A B The FM antenna provided can be connected to the FM 75-ohm COAXIAL terminal as temporary measure. B Using the Standard Type Connector (Not Supplied) A standard type connector (IEC or DIN45325) should be connected to the FM 75-ohm COAXIAL terminal. Note: Make sure the antenna conductors do not touch any other terminals, connecting cords or power cord. This could cause poor reception. Extend the FM
Summary of the content on the page No. 11
RIGHT 1 RIGHT 1 RIGHT 1 Connecting the Speakers You can connect the following speakers: • Two pairs of front speakers to produce normal stereo sound. • One pair of rear speakers to enjoy the surround effect. • One center speaker to produce more effective surround effect (to emphasize human voices). • One subwoofer to enhance the bass. For each speaker (except for subwoofer), connect the black (–) and red (+) terminals on the rear panel to the black (–) and red (+) terminals marked on the speake
Summary of the content on the page No. 12
Connecting the rear and center speakers Cut, twist and remove the insulation at the end of each speaker signal cable first, and then, connect rear speakers to the REAR SPEAKERS terminals and a center speaker to the CENTER SPEAKER terminals by using the cables. 1 Open the terminal and then insert the speaker signal cable. CENTER REAR SPEAKER SPEAKERS RIGHT LEFT Center Speaker 2 Close the terminal. Right Rear Speaker Left Rear Speaker Notes: • You can register the center speaker size after you fin
Summary of the content on the page No. 13
About the speaker impedance of the speakers CAUTION: When connecting speakers, use speakers with the SPEAKER IMPEDANCE indicated by the speaker terminals. Notes: • The required speaker impedance of the front speakers does not differ depending on whether both the FRONT SPEAKERS 1 and FRONT SPEAKERS 2 terminals are used or only one of them is used. • The required speaker impedance of the front speakers differs depending on whether or not a center and/ or rear speakers are connected at the same tim
Summary of the content on the page No. 14
Connecting Audio/Video Components You can connect the following audio/video components to this receiver using cables with RCA pin plugs (not supplied). Refer also to the manuals supplied with your components. If you want to connect a component not listed in the table below, refer to the manual supplied with it. Audio Components Video Components • Turntable • TV • CD player • VCR(s) • Cassette deck • Video disc player • Video camera Notes: • If you connect a sound-enhancing device such as a graph
Summary of the content on the page No. 15
Video component connections AUDIO GND RIGHT LEFT PHONO To video input CD VIDEO To audio input VHS OUT OUT (REC) (REC) To audio output VCR VCR VCR IN IN (PLAY) (PLAY) To video output VIDEO 1 To audio output VIDEO 1 To video input To video output TV MONITOR TV SOUND OUT To audio output Video disc player OUT (REC) TAPE IN (PLAY) You can use the VIDEO 2 input jacks on the front panel. These jacks are convenient for connecting and disconnecting the component frequently. VIDEO 2 Video camera VIDEOLR
Summary of the content on the page No. 16
Connecting the Power Cord Before plugging the receiver into an AC outlet, make sure that all connections have been made. 1. Plug the power cord into an AC outlet. POWER 2. Press POWER to set it in the ___ON position. __ The STANDBY lamp lights up. A small amount of power is always consumed. _ON ÑOFF To shut off the power completely: Press POWER to set it in the ÑOFF position. Keep the power cord away from the connecting cables for the TV, VCR, and antenna. The power cord may cause noise or scr
Summary of the content on the page No. 17
Basic Operations The following operations are commonly used when you play any sound source. Turning the Power On and Off On the front panel: STANDBY To turn on the power, press STANDBY/ON . The STANDBY lamp goes off. The name of the current source (or station frequency) appears on the display. STANDBY/ON Current source name appears Volume level is also shown here 100 1k 10k VOLUME whenever the power STANDBY is on. To turn off the power (into standby mode), press STANDBY/ON again. STANDBY/ON The
Summary of the content on the page No. 18
From the remote control: Press one of the buttons on the SOURCE SELECT section. VIDEO1 Play back a video source on the video component connected to the VIDEO1 jacks. SOURCE SELECT VIDEO2 Play back a video source on the video component connected to the VIDEO2 jacks. VIDEO 1 VIDEO 2 VCR VCR Play back a video source on the video component connected to the VCR jacks. TV SOUND FM AM TV SOUND Listen to TV sounds. FM* Listen to FM broadcasts. TAPE CD PHONO AM* Listen to AM (MW/LW) broadcasts. TAPE* Lis
Summary of the content on the page No. 19
Listening with Headphones A standard pair of headphones can be connected to the PHONES jack on the front panel. To listen with only headphones, press both SPEAKERS 1 and 2 to set them in the ÑOFF position. No sound comes out of the front speakers. CAUTION: Be sure to turn down the volume before connecting or putting on headphones, as high volume can damage both the headphones and your hearing. Muting the Sound From the remote control only: MUTE To mute the sound through all the speakers and head
Summary of the content on the page No. 20
Basic Settings Some of the following settings are required after connecting and positioning your speakers in your listening room, while others will make operations easier. See also page 37. MENU Adjusting the Front Speaker Output Balance If the sounds you hear from the front right and left speakers are unequal, you can adjust the speaker output balance. On the front panel: SETTING 1. Press SETTING so that the Control %%% / ÞÞÞ / @@@ / ### buttons work for adjusting the balance. %% ÞÞ @@ ## The l
