Summary of the content on the page No. 1
AUDIO/VIDEO CONTROL RECEIVER
RX-D701S / RX-D702B
INSTRUCTIONS
LVT1437-001A
[B]
cover_RX-D701S[B]_f.p65 3 05.11.7, 2:54 PM
Summary of the content on the page No. 2
Warnings, Cautions and Others IMPORTANT for the U.K. Caution–– STANDBY/ON button! Disconnect the mains plug to shut the power off completely. DO NOT cut off the mains plug from this equipment. If the The STANDBY/ON button in any position does not plug fitted is not suitable for the power points in your home or disconnect the mains line. The power can be remote the cable is too short to reach a power point, then obtain an controlled. appropriate safety approved extension lead or consult your de
Summary of the content on the page No. 3
Regulatory information CE Marking INCLUDE R&TTE NOTIFIED EQUIPMENT USB wireless transmitter [2.4 GHz] Countries where this equipment is intended to be used This equipment with USB wireless BE FR DE LU IT transmitter is intended to be used in NL DK IE GR PT countries on the right table. ES AT FI SE CH NO LI GB CZ HU PL SI SK EE LV LT CY MT National restrictions WARNING for country restriction of use USB wireless transmitter Italy: If used outside of own premises, general authorization is required
Summary of the content on the page No. 4
SAFETY INSTRUCTIONS “SOME DOS AND DON’TS ON THE SAFE USE OF EQUIPMENT” This equipment has been designed and manufactured to meet international safety standards but, like any electrical equipment, care must be taken if you are to obtain the best results and safety is to be assured. Do read the operating instructions before you attempt to use the equipment. Do ensure that all electrical connections (including the mains plug, extension leads and interconnections between pieces of equipment) are pro
Summary of the content on the page No. 5
Introduction We would like to thank you for purchasing one of our JVC products. Before operating this unit, read this manual carefully and thoroughly to obtain the best possible performance from your unit, and retain this manual for future reference. Features Precautions Power sources Hybrid Feedback Digital Amplifier • When unplugging the receiver from the wall outlet, always pull RX-D701S/RX-D702B features the JVC-exclusive Hybrid the plug, not the AC power cord. Feedback Digital Amplifier. Pr
Summary of the content on the page No. 6
Table of Contents Parts identification ................................................ 3 Getting started ...................................................... 6 Before Installation .................................................................. 6 Checking the supplied accessories ....................................... 6 Putting batteries in the remote control ................................... 6 Connecting the FM and AM (MW) antennas ......................... 7 Connecting the speakers ...
Summary of the content on the page No. 7
Remote control See pages in parentheses for details. Parts identification 1 TV/VIDEO button (51, 53) 2 Standby/on buttons (19, 51 – 55) AUDIO, TV , STB , VCR , DVR/DVD 3 • Source selecting buttons (19, 40, 51 – 55) TV, VCR, DVR/DVD, FM/AM, USB, AUX, VIDEO • STB CONT button (55) 4 TV VOL (volume) +/– button (51, 53) 5 CHANNEL +/– button* (51 – 55) 6 • Operating buttons for video components* (51, 52, 54, 55) , 3, REW, 4, 7, 8, FF, ¢ • Operating buttons for tuner (40) ( TUNING, TUNING 9 A/V CONTR
Summary of the content on the page No. 8
See pages in parentheses for details. Front panel 1 2 3 45 6789p SOURCE MASTER SELECTOR VOLUME AUDIO/VIDEO CONTROL RECEIVER / MULTI JOG HDMI DVR / DVD VCR VIDEO TV USB FM/AM AUX STANDBY/ON CC CONVERTER SETTING ADJUST SURROUND SET / TUNER PRESET PUSH-OPEN r t How to open the front door S-VIDEO PHONES USB DIGITAL VIDEO L – AUDIO – R AUX qe w Inside the front door Press down on PUSH-OPEN. 9 • SOURCE SELECTOR (19, 41) 1 STANDBY/ON button and standby lamp (19) 2 CC CONVERTER button (22) • MULT
Summary of the content on the page No. 9
Display window 1 2 34658 7 9 0- =~ ANALOG DUAL MONO AUTO SURR RDS TA NEWS INFO TUNED STEREO AUTO MUTING ONE TOUCH OPERATION SLEEP DIGITAL AUTO L CR HEADPHONE CC CONVERTER 1 2 AUTO MODE DIGITAL EQ C.TONE B.BOOST MIDNIGHT INPUT ATT LINEAR PCM PL x S.WFR LFE DIGITAL NEO : 6 DSP LS S RS 3D-PHONIC MHz 96 / 24 SB SB SB VIRTUAL SB kHz !@ #$ % ^ &* () _+ ¡ 1 ANALOG indicator (20) ! Digital signal format indicators (20, 21, 46, 47) 2 DIGITAL and DIGITAL AUTO indicator (20, 21) LINEAR PCM, , , 96/24 3 DUA
Summary of the content on the page No. 10
Putting batteries in the remote control Getting started Before using the remote control, put two supplied batteries first. 12 3 1 Press and slide the battery cover on the back Before Installation of the remote control. 2 Insert batteries. General precautions Make sure to match the polarity: (+) to (+) and (–) to (–). • Be sure your hands are dry. •Turn the power off to all components. 3 Replace the cover. • Read the manuals supplied with the components you are going to connect. If the range or e
Summary of the content on the page No. 11
Connecting the FM and AM (MW) antennas Do not connect the AC power plug to the wall outlet until all connections are completed. AM (MW) loop antenna (supplied) If FM reception is poor, connect an outdoor FM antenna (not supplied). Snap the tabs on the loop into the slots of the base to assemble the AM (MW) loop antenna. AM LOOP ANTENNA FM 75 If AM (MW) reception is poor, AM EXT COAXIAL connect an outdoor single vinyl- FM antenna (supplied) covered wire (not supplied). NOTES AM (MW) antenna con
Summary of the content on the page No. 12
Connecting the speakers Do not connect the AC power plug to the wall outlet until all connections are completed. Speaker Layout Diagram SW Center SUBWOOFER FL C FR OUT speaker (C) Right surround CAUTION:SPEAKER IMPEDANCE 6 -16 back speaker (SBR) SR SL *Left surround back speaker RIGHT LEFT RIGHT LEFT RIGHT LEFT CENTER (SBL) SURROUND BACK SPEAKERS SURROUND SPEAKERS SPEAKER FRONT SPEAKERS Powered SBR SBL (*SB) subwoofer Right surround (SW) speaker (SR) Left front Right front Left surround speake
Summary of the content on the page No. 13
Connecting video components Do not connect the AC power plug to the wall outlet until all connections are completed. Video conversion function This receiver can convert the video signals output from video components. The chart below shows which video signals can be converted into which signals by video conversion. To use the video conversion function, you need to make the two Video Input Converted Video Output settings below when you finish connecting your T
Summary of the content on the page No. 14
Do not connect the AC power plug to the wall outlet until all connections are completed. 7 Connecting a TV: Turn off all components before making connections. COMPONENT VIDEO Y Green PB Component video cable (not supplied) Blue PR Red VIDEO(VCR) IN DVR/DVD IN MONITOR OUT Å TV AV IN/OUT TV MONITOR OUT ıÇ HDMI cable (not supplied) SCART cable (not supplied) : signal current Å To component video input Select the appropriate VIDEO OUTPUT (see page 33) • Connect Y, PB, and PR correctly. according to
Summary of the content on the page No. 15
Do not connect the AC power plug to the wall outlet until all connections are completed. 7 Connecting a DVD recorder or DVD player: Turn off all components before making connections. Component video cable (not supplied) HDMI cable (not supplied) COMPONENT VIDEO Green Y Blue PB ) IN DVR/DVD IN Red PR HDMI VIDEO(VCR) IN DVR/DVD IN MONITOR OUT DVD recorder or Å ı DVD player Ç Î AUDIO VIDEO IN DVR/DVD IN FRONT DVR/DVD White L Red R Stereo audio cable (not supplied) SCART cable (not supplied) : signa
Summary of the content on the page No. 16
Do not connect the AC power plug to the wall outlet until all connections are completed. When you connect a DVD recorder or DVD player with its analogue discrete output jacks (DVD MULTI IN): If your DVD recorder or DVD player has analogue 5.1 channel output jacks, use the connection below. When a DVD Audio disc is played back, the original high-quality sounds can be reproduced by using this connection. For video connection, see page 11. Turn off all components before making connections. Stereo a
Summary of the content on the page No. 17
Do not connect the AC power plug to the wall outlet until all connections are completed. 7 Connecting a VCR: Turn off all components before making connections. Component video cable (not supplied) HDMI cable (not supplied) COMPONENT VIDEO Green Y Blue PB VIDEO(VCR) IN Red PR VIDEO(VCR) IN DVR/DVD IN MONITOR OUT HDMI Å ı VCR Ç VCR SCART cable (not supplied) : signal current Å To HDMI output Select the appropriate VIDEO INPUT (see page 20) according to the ı To component video output connection yo
Summary of the content on the page No. 18
Do not connect the AC power plug to the wall outlet until all connections are completed. 7 Connecting another video component to the VIDEO IN jacks: Turn off all components before making connections. Component video cable (not supplied) HDMI cable (not supplied) COMPONENT VIDEO Green Y Blue PB VIDEO(VCR) IN Red PR HDMI VIDEO(VCR) IN DVR/DVD IN MONITOR OUT DBS tuner, etc. Å ı Ç Î ‰ VIDEO AUDIO VIDEO IN DVR/DVD IN VIDEO IN FRONT White VIDEO L Red S-VIDEO R Stereo audio cable (not supplied) Composi
Summary of the content on the page No. 19
Do not connect the AC power plug to the wall outlet until all connections are completed. 7 Connecting a video component to the AUX input jacks: The AUX input jacks on the front panel (inside the front door) are convenient when connecting and disconnecting the component frequently. Before making connections, press PUSH-OPEN to show the jacks. To enjoy the playback from the component connected to these jacks, select “AUX” as the source (see page 19). How to open the front door Turn off all compone
Summary of the content on the page No. 20
7 Digital output terminal Digital audio connection You can connect any digital components which have an optical This receiver is equipped with three DIGITAL IN terminals—one digital input terminal. digital coaxial terminal and two digital optical terminals—and one DIGITAL OUT terminal on the rear of the receiver. To reproduce the digital sound, use the digital audio connection in addition to the analogue audio connection methods described on pages 10 to 15. Digital coaxial cable (not supplied) D
