Extron electronic Fiber Optic Transmitters-Receivers FOX 2G Tx AV user manual

Summary of the content on the page No. 1

Specifications — FOX 2G AV Series
N The FOX 2G AV consists of a transmitter (FOX 2G Tx AV) and a receiver (FOX 2G Rx AV) with
one or two fiber optic cables linking the two units.
The analog video input signal is digitized pixel for pixel in the transmitter, sent digitally through
N
the fiber cable, and converted back to analog video in the receiver.
The analog audio signal(s) is (are) digitized in the transmitter, sent through the fiber cable, and
N
converted back to analog audio in the rec

Summary of the content on the page No. 2

Specifications — FOX 2G AV Series, cont’d Impedance �������������������������������������� 75 ohms Return loss �������������������������������������� -30 dB for Y/VID, B-Y/C, R-Y @ 5 MHz Input coupling ������������������������������� AC Video output — receivers Number/signal type ��������������������� 1 component (Y, R-Y, B-Y) video, S-video, composite video Connectors ������������������������������������� 1 x 3 female BNC or 1 female 4-pin mini DIN for S-video Nominal level ������������������

Summary of the content on the page No. 3

Baud rate and protocol Control �������������������������������� 9600 baud, 8 data bits, 1 stop bit, no parity Pass-through ���������������������� 9600 to 115200 baud Serial control pin configurations Pass-through ���������������������� Captive screw connector: 1 = Tx, 2 = Rx, 3 = GND Control �������������������������������� Captive screw connector: 3 = GND, 4 = Tx, 5 = Rx Mini stereo jack: tip = Tx, ring = Rx, sleeve = GND ® Program control ����������������������������� Extron's control/confi