Summary of the content on the page No. 1
RGB 203 Rxi • Setup Guide
These instructions provide a quick setup guide for the
Extron® RGB 203 Rxi interface. Installation and service must be
performed by authorized personnel only.
®
There are two RGB 203 Rxi models: one with EDID Minder and one with
™
ADSP . Unless otherwise stated, all instructions refer to both models.
Internal Configuration
Step 1: Configure sync settings — Turn off all equipment and disconnect the
power sources. Remove the cover from the interface and locate jumper
Summary of the content on the page No. 2
RGB 203 Rxi • Setup Guide (Continued) Step 8: Connect RS-232 Controller — Connect an RS-232 Pin RS-232 Contact ClosureFunction 1 Input #1 Input #1 controller to this DB9 connector ( ) for remote control. For g 2 Tx Transmit data (-) correct wiring, see the diagram and table at right. 3 Rx Receive data (+) 4 Input #2 Input #2 5 Gnd Gnd Signal ground 6 Input #3 Input #3 7,8,9 Not used Rear Panel DIP Switch Configuration Step 9: Set Rear Panel DIP Switches — Configure the rear panel DIP switches (
Summary of the content on the page No. 3
RGB 203 Rxi • Setup Guide (Continued) Configuring EDID (EDID Minder Model Only) The Extron EDID Minder ensures the resolution of the video source signals are compatible with the display devices. The RGB 203 Rxi provides 14 factory-installed EDID values that can be used. By default, the EDID value is set to a resolution of 1024x768, which will allow most source devices to boot up and provide a signal that can be displayed. Alternatively, you can record your own EDID information and use those
Summary of the content on the page No. 4
RGB 203 Rxi • Setup Guide (Continued) Local Monitor Pass-through EDID To use local monitor pass-through EDID: 1. If you have not already done so, connect the RGB 203 Rxi to the source device. Do not switch on the source device at this time. 2. Set the rotary switch to position F. 3. If you have not already done so, connect a monitor to the Local Monitor output and power on that monitor and interface. 4. Power on the remote display device. 5. Power on source device. Operation Level/boost ( ) —
