Peavey UA 35T II user manual

Summary of the content on the page No. 1

OPERATING INSTRUCTIONS
Intended to alert the user to the presence of uninsulated
"dangerous voltage" within the product's enclosure that may be
of sufficient magnitude to constitute a risk of electric shock to
persons.
Intended to alert the user to the presence of important operating
and maintenance (servicing) instructions in the literature
accompanying the product.
CAUTION: Risks of electrical shockÑDO NOT OPEN
CAUTION: To reduce the risk of electric shock, do not remove cover. No
user ser

Summary of the content on the page No. 2

WARNING! DESCRIPTION DO NOT ATTEMPT TO INSTALL THIS UNIT WHILE IT OR The UAª 35T II is a high quality utility amplifier ideally ANY CONNECTING UNITS ARE POWERED ON. RISK OF suited for varying installation requirements. It produces 35 watts ELECTRICAL SHOCK EXISTS IF ALL UNITS ARE NOT POWERED OFF DURING INSTALLATION. TO PREVENT into 4 ohms and 8 ohms direct connections plus a broad range ELECTRICAL SHOCK OR FIRE HAZARD, DO NOT EXPOSE of line amplification. Level controls are provided for mic/pag

Summary of the content on the page No. 3

connection is between the COM terminal and the 25 V or 70 V MIC/PAGE SWITCH (7) terminal. Selects between mic and page input. The page selection provides internal pad, converting this input to line level for page FUSE (10) applications. The fuse is located within the cap of the fuseholder. It the fuse should fail, IT MUST BE REPLACED WITH THE SAME TYPE INPUTS (8) AND VALUE IN ORDER TO AVOID DAMAGE TO Low Z mic/page inputs are provided via screw terminals. Screw THE EQUIPMENT AND TO PREVENT VOI

Summary of the content on the page No. 4

WIRING DIAGRAM OUTPUTS 35 W RMS GND 4W COM 8W 25V 70V (12V) (17V) 70V ÒConstant VoltageÓ Distribution System UA 35T Specifications OUTPUT POWER: INPUT SENSITIVITY: 35 watts RMS Aux Input: 100mV @ 10K ohms POWER BANDWIDTH: Mic Input: 1mV @ 1K ohms Page Input: 120mV @ 5K ohms Aux 50 Hz - 20 kHz .6% THD Mic 50 Hz - 20 kHz .8% THD OUTPUTS: Page 50 Hz - 20 kHz .6% THD 4 ohms, 8 ohms, 25 V, 70 V FREQUENECY RESPONSE: OUTPUT REGULATION: Aux 50 Hz - 20 kHz +0, -2 dB Less than 0.5 dB, no load

Summary of the content on the page No. 5

IMPORTANT SAFETY INSTRUCTIONS WARNING: When using electric products, basic cautions should always be followed. including the following. 1. Read all safety and operating instructions before using this product. 2. All safety and operating instructions should be retained for future reference. 3. Obey all cautions in the operating instructions and on the back of the unit. 4. All operating instructions should be followed. 5. This product should not be used near water, i.e., a bathtub, sink, swimmin

Summary of the content on the page No. 6

Features and specifications subject to change without notice. Peavey Electrontics Corporation / 711 A Street, MS 39301 / U.S.A. / (601) 483-5376 / Fax 486-1154 © 1997 Printed in U.S.A. 10/97 80304366