Marshall Amplification DBS 7200 user manual

Summary of the content on the page No. 1

7200 Head,
72115 & 72410 Combos
SYSTEM
DYNAMIC

Summary of the content on the page No. 2

From Jim Marshall I would like to thank you personally for selecting one of our Dynamic Bass Systems. My company has always been totally committed to the design and manufacture of the worlds finest amplification. We are well aware that catering for the constantly changing demands of musicians requires heavy investment into the research and development of new product ranges capable of meeting those demands. The new Marshall Dynamic Bass System comes as a direct result of that investment. The inno

Summary of the content on the page No. 3

WARNING! PLEASE READ THE FOLLOWING LIST CAREFULLY. A. ALWAYS Ensure that a good quality mains plug conforming to the latest BSI standards is fitted-(UK only). B. ALWAYS wire the plug in accordance with the colour code attached to the mains lead (UK only). C. DO NOT attempt to remove the amplifier chassis. There are no user serviceable parts inside. D. ALWAYS have this equipment serviced or repaired by competent, qualified personnel. E. NEVER under any circumstances, operate the amplifier without

Summary of the content on the page No. 4

Generally speaking the Low-Sensitivity input (2) suits bass guitars of high output levels e.g. active basses and the High Sensitivity input (1) suits lower output instruments (passive basses). As there are so many different output levels from the many types of instrument available to you, you should try both before making the decision. Set the Primary EQ to flat and make sure that the Deep (5), Bright (7), Compression (13) and Graphic EQ switches (10) and the Master Volume control (14) are al

Summary of the content on the page No. 5

13. Compression On/Off Push Switch 19.Tuner Output Jack Push switch which activates the compression Instrument level buffered output for direct circuit. connection to an electronic tuner. 14. Volume Control 20. Effects Send Jack Rotary control to set the overall output level of Jack socket to connect to the input of an external the amplifier. effects processor. 15. D.I. Pre or Post EQ Selection 21. Effects Return Jack Jack socket to accept the output from an external Switch effects processor. No

Summary of the content on the page No. 6

Front Panel. 1. 2. 3. 5. 7. 10. 14. 16. 12. INPUTS GAIN PRE-AMP EQUALIZATION +15dB +15dB COMPRESSION VOLUME POWER BLEND LO HI 0 0 D.I. . . . . . . . . . . S V -15 +15 -15 +15 DEEP BRIGHT GRAPHIC PEAK HI LO -15dB -15dB PRE DEPTH S-SOLID STATE POST V-VALVE 80 160 320 640 1250 2500 5000 DYNAMIC BASS SYSTEM 4. 6. 9. 15. 8. 11. 13. Rear Panel. 20. 21. 19. 22. 17. EFFECTS EFFECTS LINE MAINS INPUT TUNER OUT RETURN OUTPUT SEND 230v -50 Hz