Summary of the content on the page No. 1
s
n
o
i
®
BassLink 4sc
®
BassLink 4sc
t
c
u
r
t
s
n
i
Summary of the content on the page No. 2
INTRODUCTION BASSLINK 4SC INSTALLATION ® ® THANK YOU for choosing the Infinity BassLink This owner’s manual assumes BassLink II is Figure 1. 4sc amplifier expansion module for use with installed in your vehicle. If you are installing ® BassLink II. To ensure optimum performance, both units simultaneously, refer to the BassLink II we strongly recommend that installation be owner’s manual for instructions regarding the entrusted to a qualified professional. Although mounting of BassLink II and the
Summary of the content on the page No. 3
CONNECTIONS Note: In order for the Phantom Center circuit to INPUT CONNECTIONS If your source unit provides only speaker-level Note: If your source unit provides two line-level operate properly, the speakers and input wires You must connect full-range signal to all four output wires, connect those wires to the Universal outputs and two speaker-level outputs, you may MUST be connected in proper polarity! inputs on BassLink II (if you are using the 4sc). Interface connections as shown in Figures 3
Summary of the content on the page No. 4
CONTROLS AND FUNCTIONS REMOTE CONTROL BASSLINK 4sc BASSLINK II Figure 7. Figure 4. REMOTE LEVEL controls. Figure 5. BassLink 4sc controls. Figure 6. BassLink II controls on the front panel. SUB LEVEL: Use this control to adjust the PHANTOM CENTER: Use this switch to select the amount of bass to suit your preference. proper adjustment of the Phantom Center circuit POWER LED:This indicator will glow blue when PHASE Control: Use this switch to reverse according to your car and your preference. Bas
Summary of the content on the page No. 5
TUNING BASSLINK II AND 4SC SETTING THE FRONT SPEAKER AND 5. Turn the Sub Level control (on the remote ABOUT THE PHANTOM CENTER CIRCUIT Using the Phantom Center Setup CD (included SUBWOOFER LEVELS level control) to its maximum output setting with your BassLink 4sc) you’ll listen to some (fully clockwise). Note: In order for the Phantom Center to work instructions, a spoken setup track and several Note: Refer to page 4, ”Controls and Functions,” properly, the front speakers MUST be connected music
Summary of the content on the page No. 6
TUNING BASSLINK II AND 4SC (CONTINUED) Tracks 5 through 16 are music tracks. There PHANTOM CENTER SETUP CD SETTING THE PHANTOM CENTER CIRCUIT ADDING THE SOUND FROM THE REAR are three excerpts of songs and each excerpt Track 1 Introduction 1. Before you begin, set the Phantom switch on SPEAKERS is recorded four times; once with no processing Track 2 Instructions for Track 3 the remote control for the seat in which you With music playing, turn the Rear Gain control (switch in the Off position), on
Summary of the content on the page No. 7
TROUBLESHOOTING SPECIFICATIONS • PROBLEM: • PROBLEM: • PROBLEM: BassLink 4sc BassLink II and 4sc Power LEDs are not lit. BassLink 4sc Power LED lit but no sound from No output from BassLink II when head-unit one or all speakers. fader control is set to front or rear (in a Amplifier Power: 35W x 4 channels at 4 ohms CAUSES and SOLUTIONS: 4-channel connection). 50W x 4 channels at 2 ohms 1. Poor or improper power connection. Check CAUSES and SOLUTIONS: Frequency Response: 90Hz to 47kHz power, gro
Summary of the content on the page No. 8
Declaration of Conformity We, Harman Consumer Group International 2, route de Tours 72500 Chateau du Loir France A valid serial number is required for warranty coverage. This product is designed for mobile applications and is not intended for connection to the mains. declare in own responsibility that the product described in this owner’s Features, specifications and appearance are subject to change without notice. manual is in compliance with technical standards: Infinity, Harman International
