Extron electronic sXPA 2001 user manual

Summary of the content on the page No. 1

LR
LR
LR
LR
™
XTRA Series Half-Rack
Audio Power Amplifiers • Setup Guide
WARNING: May cause serious injury. Installation and service must be performed by experienced personnel only. These
products must be used with UL approved, grounded, electrical boxes.
This guide provides startup instructions for an experienced installer to set up and operate the XPA 1002 or XPA 2001 series audio
power amplifiers. All references are to the XTRA Series Half-Rack User Guide which can be found on www.extron.c

Summary of the content on the page No. 2

Step 6 — Control Wiring 10V 50 mA REMOTE On the XPA 1002, XPA 1002 Plus, XPA 2001-70V, and the XPA 2001-100V models, the 3.5 mm, 5-pin VOL/MUTE 10V 50mA captive screw remote control port (shown to the right) is used to control volume and standby mode through contact closure. Standby mode turns off all output, although the XPA is still receiving power. G 12 34 5 For detailed wiring instructions, see the User Guide. NOTES: V C G STANDBY • Set the volume control on the connected control device t