Summary of the content on the page No. 1
User Guide
Distribution Amplifier
P/2 DA2xi MT
Two Output VGA and Audio
Distribution Amplifier
68-713-01 Rev. G
01 13
Summary of the content on the page No. 2
Safety Instructions Safety Instructions • English Chinese Simplified （简体中文） 警告： 产品上的这个标志意在警告用户该产品机壳内有暴露的危险 WARNING: This symbol, , when used on the product, is intended to alert the user of the presence of uninsulated dangerous voltage within 电压，有触电危险。 the product’s enclosure that may present a risk of electric shock. 注意： 产品 上 的 这个标 志意在 提 示用户设备 随 附的用户手 册 中有 ATTENTION: This symbol, , when used on the product, is intended 重要的操作和维护(维修）说明。 to alert the user of important operating and maintenanc
Summary of the content on the page No. 3
FCC Class A Notice This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC rules. The Class A limits provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Op
Summary of the content on the page No. 4
Conventions Used in this Guide Notifications The following notifications are used in this guide: WARNING: A warning indicates a situation that has the potential to result in death or severe injury. CAUTION: A caution indicates a situation that may result in minor injury. ATTENTION: Attention indicates a situation that may damage or destroy the product or associated equipment. NOTE: A note draws attention to important information. Copyright © 2013 Extron Electronics. All rights reserved. Tra
Summary of the content on the page No. 5
Contents Introduction ...................................................1 Features ............................................................. 1 Installation .....................................................2 Connectors, Indicators, and Controls ................. 2 Mounting ............................................................ 5 UL rack mounting guidelines ........................... 5 Rack mounting ............................................... 6 Furniture mounting...............
Summary of the content on the page No. 6
Introduction The Extron P/2 DA2xi MT is a distribution amplifier that accepts video input from a VGA, XGA, UXGA, or QXGA compatible PC and distributes the signal to separately buffered outputs. The output on the back of the unit can be extended with Extron VGA Series cables from 6 feet to 250 feet in length. The MT model also has audio input and output. Features • Power and Signal LED — Green LED = power + signal. Amber LED = power but no signal. Off = no power. • Gain and Peak DIP switc
Summary of the content on the page No. 7
Installation The Installation section describes: • Connectors, Indicators, and Controls • Mounting Connectors, Indicators, and Controls The front and rear panels of the P/2 DA2xi MT are described below. 2 3 6 4 INPUT MONITOR 1 7 AUDIO 76 68 6 6 GAIN/PEAK EXT POWER (see manual) P/2 DA2xi MT OUT IMP 12V OUTPUT 0.2A MAX LR 96 ON 5 7 1 2 Figure 2. Front and Rear Panels a Power and Signal indicator LED — When lit green, this LED indicates that the distribution amplifier is receiving both power an
Summary of the content on the page No. 8
e Power connector — Plug the external 12 V power supply, only when needed (see “Power and Signal indicator LED” on page 2), into this 2-pole captive screw connector. The included power supply is shipped with a plug installed. If you need to cut the DC output cord to a different length and reinstall the plug, refer to the following figure and notes. Smooth Ridges SECTION A–A Power Supply Tie Wrap Output Cord 3 5 Captive Screw Connector Figure 3. Power Connector Wiring ATTENTION: Potentia
Summary of the content on the page No. 9
LR LR f Two-bank DIP switches — These switches affect only the video output ( ), not the g “monitor” output ( ). The Gain/Peak DIP switch should be on (up) when the output d cable is over 100 feet (30.5 m). The Out Imp DIP switch changes output impedance. If all connections and operations are correct, but the output device has no picture, switch to the other position. g Video output connector — Connect the video output device (projector, display panel, or monitor) to this connector. h Audi
Summary of the content on the page No. 10
Mounting WARNING: May result in serious injury. Installation and service must be performed by authorized personnel only (see UL rack mounting guidelines below. The P/2 DA2xi MT can be mounted on a rack shelf, under a desk or tabletop, or on a projector bracket. UL rack mounting guidelines The following Underwriters Laboratories (UL) guidelines pertain to the safe installation of the equipment in a rack. 1. Elevated operating ambient temperature — If installed in a closed or multi-unit rack
Summary of the content on the page No. 11
Rack mounting For optional rack mounting, mount the P/2 DA2xi MT on a19-inch, 1U RSF 123 rack shelf kit (part #60-190-20), a universal RSU 126 1U 6-inch deep rack shelf kit (part #60-190-10), or a universal RSU 129 1U 9.5-inch deep rack shelf kit (part #60-190-01), as shown below. 1. Remove the rubber feet (if installed) and mount the unit on the rack shelf, using two screws in opposite (diagonal) corners. 2. Install blank panels or other units to the rack shelf, as required. 3. Insert the sh
Summary of the content on the page No. 12
INPUT MONITOR Furniture mounting For optional furniture mounting, mount the unit using the mounting kit MBU 125 (part #70-077-01, provided with the P/2 DA2xi MT) as follows: 1. Attach the mounting brackets to the distribution amplifier with the provided machine screws, as shown below. Figure 5. Furniture Mounting Option 2. If feet were previously installed on the bottom of the unit, remove them. 3. Hold the unit with the attached brackets against the underside of the table or other furnitur
Summary of the content on the page No. 13
Reference Information Included Parts Included parts Replacement part number P/2 DA2xi MT 60-506-21 MBU 125 1U, 1/2 rack width under-desk mount kit 70-077-01 VGA-A M-M MD/6 6-foot 15-pin HD male-to-male VGA 26-490-02 cable with audio P/2 DA2xi MT Setup Guide Other Accessories Description Part number RSF 123 1U, 3.5” deep rack shelf kit 60-190-20 RSU 126 1U, 6” D universal rack shelf kit 60-190-10 RSU 129 1U, 9.5” deep universal rack shelf 60-190-01 P/2 DA2xi MT User Guide • Reference Inform
Summary of the content on the page No. 14
Extron Warranty Extron Electronics warrants this product against defects in materials and workmanship for a period of three years from the date of purchase. In the event of malfunction during the warranty period attributable directly to faulty workmanship and/or materials, Extron Electronics will, at its option, repair or replace said products or components, to whatever extent it shall deem necessary to restore said product to proper operating condition, provided that it is returned within t
