Summary of the content on the page No. 1
DA604D
DA954D
DA501D
DA801D
COMPACT SERIES
INSTALLATION / OWNER'S MANUAL
Mobile Power Amplifiers
Summary of the content on the page No. 2
INSTALLATION Preparation Please read entire manual before installation. Due to the technical nature of amplifiers, it is highly recommended that your Dual amplifier is installed by a professional installer or an authorized dealer. Before You Start • Disconnect negative battery terminal. (consult a qualified technician for instructions) • Avoid installing the amplifier where it would be subject to high temperatures, such as from direct sunlight, or where it wo
Summary of the content on the page No. 3
INSTALLATION Connection Descriptions NOTE: Be sure to follow specific instructions included with your amplifier installation kit (not included with this amplifier). The information below should be used as a general guideline only. Power Wire (+12V) • Disconnect negative battery terminal before proceeding. Consult a qualified technician for instructions if you are unsure. • Plan wire routing before cutting any wires to length. Begin by routing the power +12V wire
Summary of the content on the page No. 4
INSTALLATION Audio Inputs and Controls DA604D 2 3 4 5 DA954D 1 4 3 2 1 DA501D DA801D 3 5 1 6 7 8 9 Gain Subsonic Filter 1 6 Crossover Mode Bass Boost 2 7 Hi-Level Input 3 8 Low Pass Filter Crossover Frequency Control Remote Turn On 4 9 RCA Input 5 4
Summary of the content on the page No. 5
INSTALLATION Power and Speaker Connections DA604D DA954D 1 4 6 3 5 2 DA501D DA801D 2 1 3 4 5 Speaker Connections Remote Turn On 1 4 Fuse(s) Ground Connection 2 5 +12VDC Battery Connection Remote Output 6 3 5
Summary of the content on the page No. 6
INSTALLATION Typical Wire Routing MAXIMUM GROUND FUSE No more than 36" (1 meter) 12V BATTERY 12V DC (Power) RCA CABLES SPEAKERS 2-8 ohms REM (Remote Turn On) Main Power Connections Connect +12V, GND and REM wires accordingly. A suitable fuse MUST be installed on the +12V lead within 18" of the battery for protection of the vehicle’s electrical system. Fuse Rating Power/Ground Wire Size When replacing fuses, make sure new fuse For optimum performance, use o
Summary of the content on the page No. 7
INSTALLATION Amplifier Connections 2 Speakers (stereo) Subwoofer (mono) Speaker Connections Connect speaker wires observing polarity.The minimum impedance load for the DA604D and DA954D is 2 ohms stereo and 2 ohms bridged. Use of loads lower than these is not recommended and may cause amplifier damage.The DA604D and DA954D can be wired for stereo, bridged or Typical Stereo Wiring stereo/bridged simultaneous Typical Bridged Wiring (2 ohms minimum) (2 ohms minimum) operation. Typical s
Summary of the content on the page No. 8
INSTALLATION Configuration/Setup Input level Control The input level control (gain) is used to obtain the best possible match between the head unit audio output and the amplifier input. Begin by turning the input level control fully counterclockwise. Next, turn up the head unit volume control around 3/4 of the way up. Adjust the input level control clockwise until audible distortion is heard, then slightly counterclockwise to provide the b
Summary of the content on the page No. 9
INSTALLATION Troubleshooting Problem Cause Action +12V wire not connected or incorrect Check connections for proper voltage voltage. REM wire not connected or Unit will not turn on (11~16VDC) incorrect voltage (no power LED indicator) GND wire not connected Check connection to ground Fuse(s) blown Replace fuse(s) Speaker wires not connected Check connections at speakers Volume turned all the way down Increase volume level at head unit One or more spe
Summary of the content on the page No. 10
INSTALLATION Specifications DA604D Power Output (14.4VDC, 20Hz ~ 20kHz): •60 Watts RMS x 4 channels @ 4 Ohms •85 Watts RMS x 4 channels @ 2 Ohms •200 Watts RMS x 2 channels @ 4 Ohms (bridged) Peak Music Power Output: 400 Watts Signal to noise ratio: > 90dB (THD < 0.05% @ 4Ω, 14.4V) Frequency response: 10Hz -35kHz (-3dB) Amplifier dimensions: 1 .6” x 4.7” x 7 .9” (41 x 119 x 201 mm) DA954D Power Output (14.4VDC, 20Hz ~ 20kHz): •100 Watts RMS x 4 channels @ 4 Ohms •1 50 Watts RMS x 4 channe
Summary of the content on the page No. 11
INSTALLATION One-Year Limited Warranty This warranty gives you specific legal rights. What to do? You may also have other rights which vary 1. Before you call for service, check the from state to state. troubleshooting guide in your owner’s manual. A slight adjustment of any Dual Electronics Corp. warrants this product custom controls may save you a service to the original purchaser to be free from call. defects in material and workmanship f
Summary of the content on the page No. 12
Dual Electronics Corp. Toll Free: 1-866-382-5476 Monday-Friday, 9AM-5PM, EST www.dualav.com ©2014 Dual Electronics Corp. NSA1113-V01
