Summary of the content on the page No. 1
AMP210 / AMP310
OWNER’S MANUAL
FEATURES:
AMP210 / AMP310
Home Audio Multi-Zone Power Amplifier
Line 1 / Line 2 priority input switching
Line 2 auxiliary output
High level input
Speaker A/B switching
Front panel balance and volume trim controls
Congratulations on your purchase of the AudioSource® AMP210/310.
Independent rear left / right master level controls
Please take a few moments to read this entire manual, and be sure to
Front panel diagnostic LEDs retain this document for future reference
Summary of the content on the page No. 2
AMP210 / AMP310 OWNER’S MANUAL CAUTION RISK OF ELECTRICAL SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE THE COVER. NO USER SERVICABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED PERSONNEL! The exclamation point within an equilateral triangle is intended to alert the user of the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. EXPLANATION OF SAFETY SYMBOLS The lightning flash with the arrowhea
Summary of the content on the page No. 3
AMP210 / AMP310 OWNER’S MANUAL Technical Support Limited Warranty AudioSource® warrants its amplifier products against defects in materials If any part of this product is damaged or missing, please call your dealer or and workmanship for a limited period of time. For a period of two years from AudioSource® directly at toll free 1.800.435.7115 or locally 503.286.9300. date of original purchase, we will repair or replace the product, at our option, without charge for parts and labor. Customer m
Summary of the content on the page No. 4
AMP210 / AMP310 OWNER’S MANUAL AMP210 Stereo Power Amplifier Balance Trim Volume Trim Power Speakers Signal / Clip Signal / Clip Left Right A B Left Right -12dB +6dB 2 5 1 5 3 4 FRONT PANEL CONTROLS Figure 1. Front Panel 3. Balance Trim 1. Power Fades speaker output between the Right and Left Channels The front panel power switch switches the AMP210/310 on or off. Red 4. Volume Trim LEDs behind the faceplate indicate power status. Whenever the amplifier’s Allows fin
Summary of the content on the page No. 5
AMP210 / AMP310 OWNER’S MANUAL Begin Master Level control setup by adjusting the front panel “Volume Trim” FRONT PANEL CONTROLS to its fully clockwise position. Set the front panel “Balance Trim” to its center detent position. Now adjust both the Left and Right Channel Master Level The front panel power switch switches the AMP210/310 on or off. Red controls to set a “Maximum” desired volume for the AMP210/310 in its LEDs behind the power button lens indicate power status. Whenever applicat
Summary of the content on the page No. 6
AMP210 / AMP310 OWNER’S MANUAL MODE SWITCH SPEAKER TERMINALS 12 15 & 16 Mode Terminals are provided for “A” and “B” pairs of speakers for each channel. If you will be using the amplifier as a stereo amplifier (i.e. not a bridged amplifier), connect the speaker’s positive (red) terminal to the amplifier’s positive (red) terminal, and the speaker’s negative (black) terminal to the amplifier’s negative Stereo Bridged (black) terminal (immediately beside the positive terminal). Figure 8. Mode Sele
Summary of the content on the page No. 7
AMP210 / AMP310 OWNER’S MANUAL Line 1 Line 2 APPLICATIONS Speaker IN V V Line 1 Line 2 R L NOTE: It should be noted that the AMP210/310 is rated to operate into a IN OUT minimum 8-ohm bridged load. Therefore, if you are using more than a single IN + + 8-ohm loudspeaker in bridged mode you should consider using an impedance matching speaker selector, such as the Phoenix Gold® Innovative Home ISM4, L L ISM6 or ISM8, or possibly using an impedance matching volume control, such as the Phoenix G
Summary of the content on the page No. 8
AMP210 / AMP310 GUIDE DE L’UTILISATEUR AMP210 / AMP310 Amplificateur de puissance audio multi-zones pour la maison CARACTÉRISTIQUES: Commutation de priorité d’entrée Ligne 1 / Ligne 2 Sortie auxiliaire Ligne 2 Niveau élevé à l’entrée Commutation haut-parleurs A/B Contrôles de balance du panneau avant et de compensation du volume Contrôles principaux de niveau arrière gauche / droit DEL de diagnostic du panneau avant “Mise sous tension (Power On)” sensible au signal ”Déclencheur allumé (Trigger
Summary of the content on the page No. 9
AMP210 / AMP310 GUIDE DE L’UTILISATEUR CONTRÔLES DU PANNEAU AVANT CONTRÔLES DU PANNEAU AVANT 1. Alimentation L’interrupteur d’alimentation du panneau avant allume ou éteint le AMP210/310. Les L’interrupteur d’alimentation du panneau avant allume ou éteint le AMP210/310. DEL rouges placés à l’arrière de la lentille de la touche de mise en marche indiquent Les DEL rouges placés à l’arrière de la lentille de la touche de mise en marche l’état d’alimentation. Chaque fois que l’interrupteur d’aliment
Summary of the content on the page No. 10
AMP210 / AMP310 GUIDE DE L’UTILISATEUR 17 18 6 9 ENTRÉE/SORTIE RCA RESEAUX D’ENTRÉE D’ALIMENTATION ET PORTE-FUSIBLE/ Il existe 2 paires d’entrées RCA à l'arrière du panneau de l'AMP210/310. RESEAUX SELECTEUR DE TENSION Ces entrées RCA sont étiquetées «Ligne 1 IN» et «Ligne 2 IN». Ils sont Accepte les cordons d’alimentation IEC. Un fusible dans le porte-fusible intégré désignés également à l’aide d’un «R» ou d’un «L» en tant que entrées pour assure une protectio
Summary of the content on the page No. 11
AMP210 / AMP310 GUIDE DE L’UTILISATEUR APPLICATIONS Line 1 Line 2 NOTE: Remarquez que l’AMP210/310 est estimé pouvoir fonctionner dans une Charge raccordée minimale de 8 ohms. Ainsi, si vous utilisez plus d’un Speaker IN V V haut-parleur de 8 ohms en mode raccordé, vous devriez considérer l’utilisation Line 1 Line 2 R L d’un sélecteur de haut-parleur d’adaptation d’impédance , tel que Phoenix Gold® Innovative Home ISM4, ISM6 ou ISM8 ou peut-être un contrôle de volume IN OUT IN + + d’adaptation
Summary of the content on the page No. 12
AMP210 / AMP310 MANUAL DEL PROPIETARIO AMP210 / AMP310 Amplificador Hogareño de Audio de Energía Multi-Zona CARACTERÍSTICAS: Conmutación de entrada de prioridad Línea 1/Línea 2 Salida auxiliar de Línea 2 Entrada de alto nivel Felicitaciones por la compra de su AudioSource® AMP210/310. Conmutación Parlantes A/B Por favor tómese unos momentos para leer este manual completamente y asegúrese Controles de recorte de volumen y balance del panel frontal de retener este documento para futura referencia
Summary of the content on the page No. 13
AMP210 / AMP310 MANUAL DEL PROPIETARIO CONTROLES DEL PANEL FRONTAL CONTROLES DEL PANEL FRONTAL 1. Energía El interruptor de energía del panel frontal enciende o apaga el AMP210/310. El interruptor de energía del panel frontal enciende o apaga el AMP210/310. Lámparas LED rojas detrás de las lentes del botón de encendido indican el Lámparas LED rojas detrás de la placa frontal indican el estado de energía. estado de energía. Cuando el interruptor de energía del amplificador está en Cuando el in
Summary of the content on the page No. 14
AMP210 / AMP310 MANUAL DEL PROPIETARIO 17 18 6 9 ENTRADA/SALIDA RCA ENTRADA DE ENERGIA DE RED Y PORTAFUSIBLES/ Existen 2 pares de entrada RCA en el panel trasero del AMP210/310. SELECTOR DE VOLTAJE PRINCIPAL Estas entradas RCA están marcadas como "Línea 1 IN” y "Línea 2 IN”. El tomacorriente de energía acepta el cable de línea de tipo IEC suministrado También están designadas con una "R" o una "L" como entradas de Canal junto con el amplificador. El fusible int
Summary of the content on the page No. 15
AMP210 / AMP310 MANUAL DEL PROPIETARIO APLICACIONES Line 1 Line 2 AVISO: Debe ser tenido en cuenta que el AMP210/310 está diseñado para operar a un mínimo de carga de puente de 8-ohm. Por lo tanto, si usted está Speaker IN V V utilizando más de un altoparlante de 8-ohm individual en modo puente, debe Line 1 Line 2 R L considerar utilizar una impedancia que coincida con el selector del parlante, tal como Phoenix Gold® Innovative Home ISM4, ISM6 o ISM8 o posiblemente IN OUT IN + + utilizar un
Summary of the content on the page No. 16
AMP210 / AMP310 OWNER’S MANUAL 16.5” (419mm) AMP210 Stereo Power Amplifier 3.8” AMP210 SPECIFICATIONS Balance Trim Volume Trim Power Speakers (96.5mm) Signal / Clip Signal / Clip Left Right A B Left Right -12dB +6dB Stereo (8 ohm): 90W RMS per channel at 8 ohms, 20Hz - 20kHz, <0.1% THD+N Stereo (4 ohm): 125W per channel at 4 ohms, 20Hz-20kHz, <0.1% THD+N Bridged Mono (8 ohm): 250W RMS at 8 ohms, 20Hz - 20kHz, <0.2% THD+N Frequency Response: 10Hz - 50kHz, +0dB, -3dB Signa
