AMX Tango Amplifiers DAS-TAMP4/8-SIG user manual

Summary of the content on the page No. 1

Installation Guide
DAS-TAMP4/8-SIG Tango Amplifiers
Overview
Tango Amplifiers - Product Specifications (Cont.)
Where more than one pair of speakers is required in a zone, Tango Amplifiers
From Controller: SWT input port (connects to an Tango Audio
provide the extra power needed to drive up to 4 additional speaker pairs (FIG. 1).
Controller)
To Keypad: SWT output port (connects to Matrix keypad or
Light Bar (power status)
interface)
Dimensions (HWD): Including feet and rear connectors:
• 3 1

Summary of the content on the page No. 2

Note: When stripping cable for use with SWT connector, only strip away about Connecting Zone Outputs (Speakers) ¼” (6mm) of the insulation from each wire. The complete assembly should not Speaker Connectors have more than 1/32” (1mm) of bare wire exposed from the bottom of the Speaker connections use standard speaker outputs (L+, L-, R-, R+) as shown connector. in FIG. 2. Wiring Diagram L+ L- R- R+ The wiring diagram below illustrates the connections from a Tango Audio Controller, and to S