Summary of the content on the page No. 1
MICRO COMPONENT MD SYSTEM
UX-F70MD — Consists of CA-UXF70MD and SP-UXF70MD
UX-F72MD — Consists of CA-UXF72MD and SP-UXF72MD
COLOR DIMMER REV.MODE STANDBY/ON COLOR DIMMER REV.MODE STANDBY/ON
CLOCK CLOCK
MD GROUP /TIMER FM MODE SLEEP MD GROUP /TIMER FM MODE SLEEP
MD TITLE MD TITLE
IMPUT/EDIT 1 MARK 2 3 IMPUT/EDIT 1 MARK 2 3
DISPLAY DISPLAY
/CHARA 4 5 6 /CHARA 4 5 6
MD TITLE MD TITLE
SEARCH 7 8 9 SEARCH 7 8 9
SET 10 0 +10 SET 10 0 +10
CANCEL ENTER REPEAT PLAY MODE MICRO COMPONENT MD SYSTEM UX-F70M
Summary of the content on the page No. 2
Warnings, Cautions and Others Caution –– STANDBY/ON button! Disconnect the mains plug to shut the power off completely (the STANDBY/ON lamp goes off). The STANDBY/ON button in any position does not disconnect the mains line. • When the unit is on standby, the STANDBY/ON lamp lights red. • When the unit is turned on, the STANDBY/ON lamp lights green. The power can be remote controlled. – G-1 – UX-F70MD[UB]SAFETY_f 1 01.7.10, 2:55 PM
Summary of the content on the page No. 3
CAUTION To reduce the risk of electrical shocks, fire, etc.: 1. Do not remove screws, covers or cabinet. 2. Do not expose this appliance to rain or moisture. CAUTION • Do not block the ventilation openings or holes. (If the ventilation openings or holes are blocked by a newspaper or cloth, etc., the heat may not be able to get out.) • Do not place any naked flame sources, such as lighted candles, on the apparatus. • When discarding batteries, environmental problems must be considered and local r
Summary of the content on the page No. 4
Caution: Proper Ventilation To avoid risk of electric shock and fire, and to prevent damage, locate the apparatus as follows: 1 Front: No obstructions and open spacing. 2 Sides/ Top/ Back: No obstructions should be placed in the areas shown by the dimensions below. 3 Bottom: Place on the level surface. Maintain an adequate air path for ventilation by placing on a stand with a height of 10 cm or more. Front view Side view 15 cm 15 cm 15 cm 1 cm 1 cm 15 cm 15 cm 15 cm UX-F70MD UX-F70MD UX-F72MD UX
Summary of the content on the page No. 5
IMPORTANT FOR LASER PRODUCTS / REPRODUCTION OF LABELS / 2 WARNING LABEL, PLACED INSIDE THE UNIT 1 CLASSIFICATION LABEL, PLACED ON REAR ENCLO- SURE DANGER: Invisible laser VARNING: Osynlig laser- ADVARSEL: Usynlig laser- VARO: Avattaessa ja suo- radiation when open and strålning när denna del är stråling ved åbning, når jalukitus ohitettaessa olet interlock failed or defeated. öppnad och spärren är sikkerhedsafbrydere er ude alttiina näkymättömälle CLASS 1 AVOID DIRECT EXPOSURE urkopplad.
Summary of the content on the page No. 6
Introduction We would like to thank you for purchasing one of our JVC products. Before operating this unit, read this manual carefully and thoroughly to obtain the best possible performance from your unit, and retain this manual for future reference. About This Manual Power sources This manual is organized as follows: • When unplugging the unit from the wall outlet, always pull the plug, not the AC power cord. • This manual mainly explains playback and editing operations using the remote control
Summary of the content on the page No. 7
Contents Location of the Buttons .................................. 3 Recording on Tapes ...................................... 35 Main Unit ............................................................... 3 Before You Start Recording on a Tape ................. 36 Remote Control ...................................................... 5 Recording FM/AM Broadcasts ............................ 37 Recording CD — CD Synchronized Recording .... 37 Getting Started........................................
Summary of the content on the page No. 8
Location of the Buttons Become familiar with the buttons on your unit. Main unit (Top view) t
AUTO REVERSE CASSETTE DECK
r e 1 TAPE EJECT w 2 F M / A M AUX TAPE STANDBY/ON COLOR VOLUME MODE REC MD GROUP select start REC MODE q 3 open/close C D M D open/close 4 p 5 9 6 7 8 (Front view) Display window on the electronic swing panel / l k PBC REC DAILY a SOUND AHB GROUP j PRO ST MONO s h y
PBC REC DAIRY SOUND AHB GROUP ST MONO PRO
d g u MICRO COMPONENT MD SYSTEM COMPACT STANDBY/ON DIGITAL A
Summary of the content on the page No. 9
Continued See pages in the parentheses for details. Main Unit Display window 1 FM/AM button (11, 15) a Timer mode indicators • Pressing this button also turns on the unit. • (Timer), DAILY (Daily Timer), and REC 2 COLOR button (9, 13) (Recording Timer) 3 STANDBY/ON button (11, 15) s CD indicator 4 CD open/close 0 button (18 – 20) • Lights when CD is in the disc tray. • Pressing this button also turns on the unit. d Tuner indicator 5 CD 3 ´ 8 (play/pause) button (11, 18, 19, 32, 37, 39) • Lights
Summary of the content on the page No. 10
Remote Control 1 DIMMER button (13, 57) 2 COLOR button (9, 13) 3 CLOCK/TIMER button (57 – 59) 4 MD GROUP button (43 – 47, 54) 5 MD TITLE INPUT/EDIT button (43 – 47, 50 – 52, 54) 1 y 6 DISPLAY/CHARA (character) button (16, 19, 24, 26, 2 u 28, 31 – 34, 37 – 39, 54) COLOR DIMMER REV.MODE STANDBY/ON 7 MD TITLE SEARCH button (26) 3 CLOCK i MD GROUP SLEEP /TIMER FM MODE 8 SET button 4 o 9 ENTER button (26, 43 – 47, 50 – 52, 55) MD TITLE 1 2 3 INPUT/EDIT MARK ; p CANCEL button 5 q FM/AM/AUX button (11
Summary of the content on the page No. 11
FM(75Ω) ANTENNA AM EXT AM LOOP FM(75Ω) COAXIAL ANTENNA AM EXT AM LOOP COAXIAL Getting Started Continued To connect an outdoor FM antenna Unpacking Before connecting it, disconnect the supplied FM antenna. Make sure that you have all the following items. The number in the parenthesis indicates the quantity of the pieces supplied. Outdoor FM antenna (not supplied) • FM antenna (1) • AM loop antenna (1) • AC power cord (1) • Remote control (1) • Batteries (2) • Spacers (2) If anything is missing, c
Summary of the content on the page No. 12
ANTENNA AM EXT AM LOOP FM(75Ω) COAXIAL Connecting Speakers AM antenna To attach spacers If you want to place the speakers beside the main unit, it is 1 recommended to leave a space (1 cm) between the main unit and the right speaker for ventilation. It is recommended to attach the spacers (supplied) to the right speaker as the illustration below: The main unit The right speaker Vinyl-covered wire 2 (not supplied) 3 Opening for ventilation Spacers (supplied) By peeling the cover seal from the spac
Summary of the content on the page No. 13
Continued To connect speakers Connecting Other Equipment You can connect the speakers by following the procedure below. You can connect the following equipment which can be used as a playback device. 1 When you connect and use the equipment, refer also to its manual supplied. • DO NOT connect other equipment while the power is on. • DO NOT plug in any equipment until all connections are complete. Speaker terminals 2 3,4 To connect another component such as analog audio equipment Be sure that the
Summary of the content on the page No. 14
NOW, you can plug the AC power cord. Putting the Batteries into the Remote Control IMPORTANT: Be sure to check all connections to be done before plugging the AC power cord into a wall outlet. Insert the batteries — R6P(SUM-3)/AA(15F) — into the remote control, by matching the polarity (+ and –) on the batteries with the + and – marking on the battery compartment. When the remote control can no longer operate the unit, replace both batteries at the same time. RL 1 SPEAKER IMPEDANCE MIN 4 R L AC
Summary of the content on the page No. 15
Basic and Common Operations Continued The buttons emphasized in the illustration below are used and explained in this section (pages 11 to 13.) Remote control COLOR DIMMER COLOR DIMMER REV.MODE STANDBY/ON STANDBY/ON CLOCK MD GROUP /TIMER FM MODE SLEEP MD TITLE INPUT/EDIT 1 MARK 2 3 DISPLAY 4 5 6 /CHARA MD TITLE SEARCH 7 8 9 SET 10 SET 10 0 +10 10 0 +10 CANCEL ENTER REPEAT PLAY MODE FM/AM CD /AUX TAPE MD BEEP FM/AM CD MD /AUX TAPE SOUND AHB MODE PRO VOLUME BEEP RM-SUXF70MDU SOUND AHB VOLUME MO
Summary of the content on the page No. 16
Turning On the Power Selecting the Sources and Starting Play When you press the play buttons (CD 3 / 8, MD 3 / 8, To select the tuner or external equipment, press TAPE 2 3) for a particular source or the FM/AM/AUX FM/AM/AUX. button (or FM/AM or AUX button on the main unit), the The unit automatically turns on (when the unit is on unit automatically turns on (and starts playback if the standby) and the last selected source appears on the display. source is ready). • Each time you press the button
Summary of the content on the page No. 17
Continued Adjusting the Volume Reinforcing the Bass Sound You can adjust the volume level only while the unit is The richness and fullness of the bass sound is clearly turned on. The volume level has no effect on recording. maintained regardless of how low you set the volume — Active Hyper Bass Pro. The AHB PRO effect can be To increase the volume, press VOLUME + . applied only to playback sounds, and cannot be used for To decrease the volume, press VOLUME – . recording. On the remote control ON
Summary of the content on the page No. 18
To adjust and register the color Setting the Display Illumination You can adjust the color by changing the tone, whiteness, You can change the color and brightness of the display brigtness, and register into COLOR 1 to 7. illumination. • There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again. To select the color pattern You can select the color pattern by your preference. On the remote control ONLY: • If you press COLOR while the
Summary of the content on the page No. 19
Listening to FM and AM Broadcasts Continued The buttons emphasized in the illustration below are used and explained in this section (pages 15 and 16.) Remote control FM MODE COLOR DIMMER REV.MODE STANDBY/ON CLOCK MD GROUP /TIMER FM MODE SLEEP DISPLAY 1 2 3 /CHARA MD TITLE 1 2 3 INPUT/EDIT MARK DISPLAY 4 5 6 /CHARA 4 5 6 MD TITLE SEARCH 7 8 9 SET 7 8 9 SET 10 10 0 +10 0 +10 10 CANCEL ENTER REPEAT PLAY MODE FM/AM FM/AM CD MD /AUX TAPE /AUX BEEP SOUND AHB MODE PRO VOLUME RM-SUXF70MDU Main unit (T
Summary of the content on the page No. 20
To change the FM reception mode Setting the AM Tuner Interval Spacing When an FM stereo broadcast is noisy or hard to receive, Some countries space AM stations 9 kHz apart, and some you can change the FM reception mode to improve the countries use 10 kHz spacing. reception. When shipped, the built-in AM tuner is set to 9 kHz On the remote control ONLY: spacing. You can change it to 9 kHz or 10 kHz spacing. Press FM MODE so that the MONO indicator lights on the display. On the main unit ONLY: • E
